2010 MERCEDES-BENZ E-CLASS CABRIOLET engine coolant

Adding engine oil
H
Environmenta
lnote
When toppin guptheoil, tak ecaren ot to spill
any .Ifo il enter sthe soil or waterways, it is
harmful to the environmen t.Engine oil cap (example)
X
Turn cap :anti-clockwise and remove it.
X Top up with the amount of oil required.
Fill carefully to the maximum mark on the oil
dipstick.
i Depending on the engine, the difference
between the minimum mark and the maxi-
mum mark is approximately 1.5 –2litres.
! Do not add too muc hoil. If the oil level is
above the "max "mark on the dipstick, too
much oil has been added. This can lead to
damage to the engine or the catalytic con-
verter .Have excess oil siphoned off.
Further information on engin eoil
(Y page 315).
X Replac ecap : on the filler nec kand
tighten clockwise.
Ensure that the cap locks int oplace
securely. Checking and addin
gother service
products
Checking th ecoolan tlevel Only check th
ecoolant leve lwhen th evehicle
is on alevel surface and th eengine has cooled
dow n.
X Tur nthe ke ytop osition 2(Y page 135) in
th ei gnitio nlock.
On vehicles with KEYLESS -GO, press the
Star t/Stop butto ntwice (Y page 135).
X Check the coolant temperature display in
the instrument cluster. G
Risk of injury
The cooling system is pressurised. Therefore,
only unscrew the cap once the engine has
cooled down. The coolant temperature gauge
must display less than 70 †.Otherwi se,you
could be scalded if ho tcoolant escapes. X
Slowl yturn cap :half aturna nti-clock-
wis eand allo wexcess pressure to escape.
X Turn cap :further anti-clockwis eand
remove it.
If the coolant is at the level of marker bar
= in the filler neck when cold, ther eis
enough coolan tincoolant expansion
tank ;.
If the coolant is approximately 1. 5cm
higher when it is warm, ther eisenough
coolant in coolant expansion tank ;. Engin
ecompartment
261Maintenance and care
BA 207ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa Version:3.0.2.11
2010-01-26T13:03:22+01:0
0-Seite 261 Z

numb
er (VIN) is also stamped onto th evehicle
body.
It is located on the floor in front of the right-
hand front seat. X
Slide the right-hand front seat to its rear-
most position.
X Slightl yraise front floor covering =and
fold floor covering flap :upwards.
You will see vehicle identification number
(VIN) ;. Engine number
The engine number is stamped on the crank-
case. More information can be obtained from
any Mercedes-Benz Service Centre. Servic
eproducts and capacities Important safety notes
Service products include the following:
R fuels (e.g. petrol, diesel)
R lubricants (e.g. engine oil, transmission oil)
R coolant
R brake fluid
R windscreen wash erfluid Mercedes-Ben
zrecom mends that you use
product swhich hav ebeen tested and spe-
ciall yapproved by Mercedes-Ben zfor your
vehicle and ar elisted in this Mercedes-Benz
Owner' sManual in the relevant section as:
R parts and service products are matched.
R damage caused by the use of non-approved
service products is not covered by the
implied warranty
You can recognise service products approved
by Mercedes-Benz by the following inscrip-
tion on the containers:
R MB-Freigabe (e.g. MB-Freigabe 229 .51)
R MB Approval (e.g. MB Approval 229.51)
Othe rdesignations or recommendations that
relate to alevel of quality or aspecification in
accordan cewith an MB Sheet number (such
as MB 229 .5)h ave not necessarily been
approved by Mercedes-Benz.
You can obtain further information from any
Mercedes-Benz Servic eCentre. G
Risk of inju
ry
When handling, storin gand disposing of any
service products, please observe the relevant
regulations ,asyou coul dotherwis eendanger
yourself and others.
Keep service products away from children.
To protect your health, do not allo wservice
products to com einto contact with your eyes
or ope nwounds. See adoctor immediately if
any service product is swallowed. H
Environmental note
Dispose of service products in an environ-
men tally-responsible manner. Fuel
Important safety notes G
Risk of explosion
Fuel is highly flammable. Fire, naked flames
and smokin gare therefore prohibited when
handling fuels. Servic
eprodu cts and capacities
313Technical data
BA 207ECE ÄJ 2010 /1a; 1; 2, en-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00 -Seite 313 Z

Coolant
Important safety notes The coolan
tisamixture of water and anti-
freeze/corrosio ninhibitor. It performs the
following tasks:
R anti-corrosio nprotection
R antifreeze protection
R raising th eboiling point
i When the vehicle is first delivered, it is fil-
led with acoolant mixtur ethat ensures
adequate antifreeze and corrosion protec-
tion.
! Only top up with coolant that has been
premixed with the desired antifreeze pro-
tec tion. You coul dotherwis edamage the
engine.
Further information on coolants and on fill-
ing can be found in the Mercedes-Benz
Specifications for Service Products, MB
Approval 310.1 ,e.g. on the Internet at
http ://bevo.mercedes-benz.com .You can
also consult aMercedes-Benz Service
Centre.
! Alway suseasuitable coolant mixture,
even in countries where high temperatures
prevail.
Otherwise, the cooling system will not be
sufficiently protected from corrosion, and
the boiling point will be too low.
If antifreeze/corrosio ninhibitor is present in
the correc tconcentration, the boilin gpoint of
the coolant will be around 13 0†.
The antifreeze/ corrosion inhibitor con centra-
tion in the cooling system should:
R be at leas t50%. This wil lprotect the cooling
system against freezing down to around
37 †.
R not exceed 55% (antifreeze protection
down to -45 †); otherwise ,heat will not be
dissipated as effectively. If the vehicle has lost coolant, top it up with
equal amounts of water and antifreeze/cor-
rosion inhibitor. Mercedes-Ben
zrecom-
mends an anti freeze/cor rosion inhibitor
whic hhas been approved for Mercedes -Benz.
! The coolin gsystem is filled with coolant
which must be renewed after 15 years, or
after 250,000 km at the latest.
The warrant yisonly valid if you top up with
an antifreeze /corrosion inhibitor which
has been approved by Mercedes-Ben zand
if the recommend edmixt urer atio is
obser ved. Vehicl
edata Vehicle data,
E200 CG IBlueEFFI-
CIENCY Vehicle dimensions
Vehicle length (ECE)
Coupé
4698 mm
Cabri
olet 469
8mm Vehicle width including exterio
rmirrors Coupé
20
28 mm Cabriolet
201
5mm Vehicle height
62 Coupé
139
3mm Cabriolet
140
2mm Wheelbase
Coupé
276
0mm Cabriolet
276
0mm 62
Thev alues specified may diffe rfrom the actual values ,depending on the tyres, load, optional equipment
and the state of the suspension. Vehicl
edata
317Technical data
BA 207 ECE ÄJ 2010/1a; 1; 2, en-GB
mkalafa Version: 3.0.2.11 2010-01-26T13:03:22+01:00-Seite 317 Z