34
Fuel Door Rele ase (located on floor next to driver’s seat)
To open, pull the remote fuel
door release.
NOTE :
Fuel requirement 87 Octane.
Fuel Door
To avoid scratching the paint
during refueling, secure the fuel
filler cap tether over the hook
as shown.
Seats
ELECTRONICALLY OPERATED DRIVER SEAT CONTROLS
Slide/Tilt Switch
Seat can be moved back and forth, raised,
lowered, or tilted with this control.
Lumbar Adjustment
Rotate clockwise to
increase support and
counterclockwise to
decrease support.
Recline Switch
Push forward or backward
to adjust seatback angle.
Memory Seat Switch
To Program the Driver’s Seat Position
1 Park vehicle.
2 Adjust seat to desired position using the slide/tilt and recline switches.
3 While pushing the memory seat SET button, push one of the three
programming buttons until a beep is heard. Programming is now
complete. Program the remaining two buttons as desired.
NOTE: You can also program one seat position for each advanced key/retractable
type key used with the vehicle. See Owner’s Manual for programming instructions.
To Move the Seat to a Programmed Position
• With driver’s door OPEN and ignition OFF , push and release one
of the programmed buttons (1, 2, or 3) when entering the vehicle.
OR
• With driver’s door CLOSED and ignition ON , push and hold one of
the programmed buttons (1, 2, or 3).
NOTE:
Memory seat functions DO NOT operate when driver’s door is OPEN and
ignition is ON, when driver’s door is CLOSED and ignition is OFF, or when the vehicle
is in motion.
180567_10a_Mazda6_SSG_050709.indd 4-55/7/09 9:44:34 AM
Feature Highlights
AUTO -DIMMIN g MIRRORS AND hOME LINK®
•
Auto-dimming automatically
darkens your rearview
mirror and both outside
door mirrors to reduce
headlight glare from the
vehicles behind you.
• Auto-dimming is activated
every time the vehicle
is started.
NOTE:
•
Both door mirrors will appear to have a halo, or ring, around the outer edge of
the mirror surface. This is actually the electrical circuitry that allows the mirrors
to dim. This is normal operation of the mirrors.
• In addition to the auto-dimming mirror’s front light sensor, there is also a
rear light sensor (not shown). Do not place or hang any objects over the front
or rear mirror light sensors; other wise, the auto-dimming mirrors will not
operate properly.
homeLink®
•
This feature provides a convenient way to replace up to three
transmitters such as garage door openers, home lighting remotes
and other radio frequency devices.
• Refer to your Owner’s Manual for complete programming details.
Auto-Dimming Mirrors
Auto-Dimming
Indicator LightAuto-Dimming
On
homeLinkLight
SensorAuto-Dimming
Off
On Off
6-SPEED MANUAL TRANSMISSION
Push the clutch pedal down completely
•
to start the engine and to shift gears.
To place the transmission in Reverse,
•
place shifter in the neutral position,
push the shifter down, move to the left
and push forward.
Your aluminum wheels have a protective
coating on them. Only use a mild soap or
neutral detergent with a sponge or soft cloth
to clean them. Using a wire brush, polishing
compound, solvent, or any type of abrasive
cleaner may damage the protective coating.
ALUMINUM WhEEL CARE
Lower
gear
h igher
g ear
11 12
SPORT AT MANUAL Sh IFT MODE
The Sport AT Manual Shif t Mode gives you
the feel of driving a manual transmission
by allowing you to manually shif t to control
engine rpm and torque when more control
is desired.
To Use Manual Shift Mode:
• Shift lever from D to M.
NOTE:
Changing to manual mode
can be done while driving the vehicle.
To Shift Up To A Higher Gear:
• Tap shift lever back (+) once.
To Shift Down To A Lower Gear:
• Tap shift lever forward (-) once.
Neutral
Position
180567_10a_Mazda6_SSG_050709.indd 12-135/7/09 9:46:36 AM
