2010 LINCOLN MKT clock

Because your vehicle’s engine is electronically controlled by a computer,
some control conditions are maintained by power from the battery. When
the battery is disconnected or a new battery is installed, the engine must
relearn its idle and fuel trim strategy for optimum driveability and
performance. To begin this process:
1. With the vehicle at a complete stop, set the parking brake.
2. Put the gearshift in P (Park), turn off all accessories and start the
engine.
3. Run the engine until it reaches normal operating temperature.
4. Allow the engine to idle for at least one minute.
5. Turn the A/C on and allow the engine to idle for at least one minute.
6. Release the parking brake. With your foot on the brake pedal and with
the A/C on, put the vehicle in D (Drive) and allow the engine to idle for
at least one minute.
7. Drive the vehicle to complete the relearning process.
•The vehicle may need to be driven 10 miles (16 km) or more to
relearn the idle and fuel trim strategy.
•If you do not allow the engine to relearn its idle trim, the idle
quality of your vehicle may be adversely affected until the idle
trim is eventually relearned.
If the battery has been disconnected or a new battery has been installed,
the clock and radio settings must be reset once the battery is
reconnected.
•Always dispose of automotive
batteries in a responsible manner.
Follow your local authorized
standards for disposal. Call your
local authorized recycling center
to find out more about recycling
automotive batteries.
L
E
A
D
RETURN
RECYCLE
Maintenance and Specifications
387
2010 MKT(mkt)
Owners Guide, 1st Printing
USA(fus)

For vehicles with overflow coolant systems with a non-pressurized cap
on the coolant recovery system, add coolant to the coolant recovery
reservoir when the engine is cool. Add the proper mixture of coolant and
water to the FULL COLD level. For all other vehicles which have a
coolant degas system with a pressurized cap, or if it is necessary to
remove the coolant pressure relief cap on the radiator of a vehicle with
an overflow system, follow these steps to add engine coolant.
WARNING:To reduce the risk of personal injury, make sure the
engine is cool before unscrewing the coolant pressure relief cap.
The cooling system is under pressure; steam and hot liquid can come
out forcefully when the cap is loosened slightly.
Add the proper mixture of coolant and water to the cooling system by
following these steps:
1. Before you begin, turn the engine off and let it cool.
2. When the engine is cool, wrap a thick cloth around the coolant
pressure relief cap on the coolant reservoir (a translucent plastic bottle).
Slowly turn cap counterclockwise (left) until pressure begins to release.
3. Step back while the pressure releases.
4. When you are sure that all the pressure has been released, use the
cloth to turn it counterclockwise and remove the cap.
5. Fill the coolant reservoir slowly with the proper coolant mixture, to
within the COLD FILL RANGE or the FULL COLD level on the reservoir.
If you removed the radiator cap in an overflow system, fill the radiator
until the coolant is visible and radiator is almost full.
6. Replace the cap. Turn until tightly installed. Cap must be tightly
installed to prevent coolant loss.
After any coolant has been added, check the coolant concentration (refer
toChecking engine coolant). If the concentration is not 50/50
(protection to –34°F/–36°C), drain some coolant and adjust the
concentration. It may take several drains and additions to obtain a 50/50
coolant concentration.
Whenever coolant has been added, the coolant level in the coolant
reservoir should be checked the next few times you drive the vehicle. If
necessary, add enough 50/50 concentration of engine coolant and
distilled water to bring the liquid level to the proper level.
If you have to add more than 1.0 quart (1.0 liter) of engine coolant per
month, have your authorized dealer check the engine cooling system.
Maintenance and Specifications
390
2010 MKT(mkt)
Owners Guide, 1st Printing
USA(fus)

Roadside assistance ..................325
S
Safety belts (see Safety
restraints) ..........197, 200, 202–205
Safety Canopy ...................220, 222
Safety defects, reporting ..........367
Safety
restraints ...........197, 200, 202–205
Belt-Minder
...........................207
extension assembly ................206
for adults .........................202–205
for children .............................226
Occupant Classification
Sensor ......................................199
warning light and chime ........206
Safety restraints - LATCH
anchors ......................................234
Safety seats for children ..........230
Safety Compliance
Certification Label ....................416
Satellite Radio (if equipped) .....64
Seats ..........................................176
child safety seats ....................230
climate control ..........89, 182, 194
easy access/easyout feature ..184
front seats .......................181, 193
heated ......................................193
memory seat ...................159, 183
second row seats ............188, 191
third row seats ........191, 194–195
Second-row power fold seat ....191
SecuriCode keyless entry
system ........................................163
SecuriLock passive anti-theft
system ........................................165
Servicing your vehicle ..............376Setting the clock .........................40
SOS Post Crash Alert ...............225
Sound features ............................53
Spare tire
(see Changing the Tire) ...........338
Spark plugs,
specifications .....................411, 415
Specification chart,
lubricants ...................................412
Speed control ............................122
Starting your vehicle ........279–281
jump starting ..........................353
push button start system .......281
Steering wheel
controls ....................................132
tilting .......................................111
SYNC
..........................................88
System limitations ......................57
T
Temporary mobility kit .............343
Third-row power fold seat .......196
Tilt steering wheel ....................111
Tire Pressure Monitoring
System (TPMS)
Tires, Wheels and Loading ....261
Tires ...........................246–247, 336
alignment ................................254
care ..........................................250
changing ..................336, 338–339
checking the pressure ............250
inflating ...................................248
label .........................................260
replacing ..................................252
rotating ....................................254
safety practices .......................253
Index
429
2010 MKT(mkt)
Owners Guide, 1st Printing
USA(fus)