2010 Lancia Delta light

GETTING TO KNOW YOUR CAR47
1
fig. 18/aL0E0010m
REAR SEATS fig. 18/a - 18/b
Adjusting backrest tilt
Lift lever A (one on each side) to adjust the tilting of the
left or right part of the backrest respectively (in order to
make the process easier, move the seat slightly forward us-
ing lever B).
Rear seats movement
(for versions/markets, where provided)
The rear seats can be moved backwards and forwards (by
80 mm). To move the seats backwards or forwards oper-
ate levers B (one on each side).
When repositioning the rear backrest whilst
moving it, it is necessary to check that it is
correctly attached, grasping the backrest at
the top and shaking it.
“Fixed” type rear seats
In some versions, rear seats are “fixed” type and the back
rest angle adjustment is possible if the luggage compart-
ment is extended. Use lever A - fig. 18/b (one each side)
for backrest angle adjustment.
fig. 18/bL0E0231m
Before tilting the seat backs, make sure the
seat belts are fully stretched, without any tor-
sion.
001-142 Delta 3ed gb 30-11-2009 11:21 Pagina 47

GETTING TO KNOW YOUR CAR49
1
STEERING WHEEL
It can be adjusted vertically (and axially).
To adjust the steering wheel, move lever fig. 20 upwards
to position 1. Adjust the steering wheel into the most suit-
able position and lock it in this position by moving the
lever to position 2.
REARVIEW MIRRORS
INTERNAL REARVIEW MIRROR fig. 21
The mirror is fitted with a safety device that causes its
release in the event of a violent crash.
It can be moved using lever A to two different positions:
normal or antiglare.
ELECTROCHROMIC INTERNAL REARVIEW
MIRROR
(for versions/markets, where provided)
Some versions provide an electrochromic mirror with au-
tomatic antiglare function.
When the function is activated this is indicated by the LED
on the mirror lighting up.
Perform these operations only when the car
is stationary and the engine is not running.
fig. 21L0E0013mfig. 20L0E0012m
001-142 Delta 3ed gb 30-11-2009 11:21 Pagina 49

50GETTING TO KNOW YOUR CAR
Engaging reverse gear automatically sets the mirror for
daylight use.
DOOR MIRRORS fig. 22
Proceed as follows to adjust the position of the door mir-
rors:
❍select the mirror using selector B;
❍adjust the mirror using controls A, in all four direc-
tions.Folding back door mirrors fig. 23
When required (for example when the mirror causes dif-
ficulty in narrow spaces) it is possible to fold the mirror
by moving it from position 1 (open), to position 2 (closed).
On some versions the door mirrors can be folded back elec-
trically by operating a dedicated control.
fig. 22L0E0014mfig. 23L0E0015m
When driving, the mirrors should always be
in position 1. As the door mirrors are curved,
they may slightly alter the perception of dis-
tance.
001-142 Delta 3ed gb 30-11-2009 11:21 Pagina 50

GETTING TO KNOW YOUR CAR53
1
IMPORTANT It is advisable to activate air recirculation
in queues or in tunnels to prevent the introduction of pol-
luted air. Do not use the function for a long time, partic-
ularly if there are many passengers on board, to prevent
the windows from misting up.
D Air recirculation on/off button
(LED lights when function is on).
E Manual climate control compressor on/off button (LED
lights when function is on).
F Heated rear windscreen on/off button.
When the function is active, an LED on the button is
lit. In order to maintain battery efficiency, the function
is automatically deactivated after about 20 minutes.FAST FRONT WINDOW AND FRONT SIDE
WINDOWS DEMISTING/DEFROSTING
(MAX-DEF)
Proceed as follows:
❍turn knob A to the red section;
❍turn knob C to
Ú;
❍turn knob D to -;
❍turn knob B to 4 -(maximum fan speed).
IMPORTANT The climate control system is very useful for
fast demisting because it dries the air. Adjust the controls
as described above and press knob B to switch the climate
control system on: the LED on the knob will light up.
LOOKING AFTER THE SYSTEM
Run the climate control system for at least 10 minutes
every month during the winter. Have the system inspect-
ed at a Lancia Dealership before the summer.
001-142 Delta 3ed gb 30-11-2009 11:21 Pagina 53

GETTING TO KNOW YOUR CAR57
1
Adjusting the fan speed fig. 26
Operate buttons C
pto increase/decrease the speed of the
fan.
The 12 possible speeds are indicated by bars lighting up
on the display:
❍max fan speed = all bars lit
❍min fan speed = one bar lit.
The fan can only be disabled (no bars lit) if the climate
control compressor has been switched off by pressing but-
ton.
To restore automatic fan speed control after a manual ad-
justment, press AUTO.Aligning the set temperatures
(MONO function) fig. 26
Press button D (MONO) to align the temperature between
the driver side and passenger side.
Then turn the AUTO or MONO knob to increase/decrease
the temperature between the two areas by the same
amount.
Press MONO again to deactivate the function.
Switching off the climate control system fig. 26
Press button E (OFF).
The following information is shown on the display:
❍the word OFF;
❍outdoor temperature indication;
❍indication if air recirculation is switched on (LED on
button
Tlit).
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 57

58GETTING TO KNOW YOUR CAR
heated rear windscreen and door mirrors
demisting/defrosting fig. 26
Press button F (
() to activate the function: When the
function is active, an LED on the button lights up.
This function is timed and will turn off automatically af-
ter 20 minutes. Press
(again to disable the function in
advance.
IMPORTANT Do not apply stickers on the inside of the
rear window over the heating filaments to avoid damage
that might cause it to stop working properly.
IMPORTANT Press
Tto draw air in from the outside
(in this case the LED on the button should be off).Rapid window demisting/defrosting
(MAX-DEF function) fig. 26
Press button G
-to automatically activate the timed op-
eration of all the functions required to rapidly
demist/defrost the windscreen and front windows.
The functions are:
❍climate control compressor engagement (with an out-
door temperature of above 4°C);
❍disengagement (if previously engaged) of air recircu-
lation (the LED on button
Tshould be off);
❍engagement of heated rear windscreen (the LED on
button
-should be on) and door mirror heater coils;
❍air temperature set to maximum;
❍activation of air flow.
Activation of air recirculation and enablement of
AQS (Air Quality System) fig. 26
Press button
T.
Air recirculation is carried out according to three possi-
ble operation modes:
❍automatic control, indicated by the AQS appearing on
the display and the LED on button
Tshould be off;
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 58

60GETTING TO KNOW YOUR CAR
Switching the climate control compressor
on/off I-fig. 26
Press button
❄to switch on the climate control system
compressor.
Compressor engagement
❍the LED on button
❄is lit up;
❍Symbol
❄is shown on the display.
Compressor disengagement
❍the LED on button
❄is off;
❍symbol
❄disappears from the display;
❍internal air recirculation is excluded;
❍the AQS function is disabled.
With the climate control system compressor disengaged,
it is not possible to introduce air of a lower temperature
than the outside temperature into the passenger com-
partment; in this case the symbol on the display will flash.
The disengagement of the climate control compressor re-
mains in the system memory even after the engine has
been stopped. To engage the climate control compressor
press the button
❄once again or press AUTO: in this last
case any manual settings will be cancelled.
EXTERNAL LIGHTS
The left-hand lever operates most of the external lights.
The external lights can only be switched on when the ig-
nition key is on MAR. The instrument panel and the var-
ious controls on the dashboard will be illuminated when
the external lights are switched on.
DAYLIGHT lights (D.R.L. - Adaptive Daylight Led)
(for versions/markets, where provided)
With the ignition key turned to MAR and the selector wheel
turned to position Othe daylight lights are automatical-
ly activated; the other lights and internal illumination re-
main off. The automatic lighting up of the daytime lights
can be switched on/off using the display menus (see “Dis-
play” section in this chapter). If the daytime lights are
switched off, when the selector wheel is turned to Ono
lights will come on.
fig. 27L0E0019m
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 60

GETTING TO KNOW YOUR CAR61
1
Deactivation
When the lights are switched off by the sensor, the dipped
beam headlights and side lights are switched off and the
daylight lights are switched on (if activated).
The sensor cannot detect the presence of fog: switch the
lights on manually in this case.
FRONT FOG LIGHTS WITH CORNERING LIGHTS
FUNCTION
When travelling at a speed of less than 40 km/h with the
dipped beam headlights on, when the steering wheel is
turned at a wide angle or the direction indicators are lit
up, a light (built into the front fog lights) will be activat-
ed on the side of the turn to increase night time visibility.
This function can be switched on/off using the display
menus (see “Display” section in this chapter). AUTOMATIC HEADLIGHT SENSOR
(dusk sensor) fig. 27
(for versions/markets, where provided)
This sensor detects changes in external light levels ac-
cording to the sensitivity of the setting: the higher the sen-
sitivity, the lower the amount of external light needed to
switch the lights on. The sensitivity of the dusk sensor may
be adjusted, using the “Set-up menu” on the instrument
panel.
Activation
Turn the selector wheel to AUTO: in this way the external
lighting will switch on automatically according to the out-
side light level.
The headlights can only be flashed with the sensor on.The daytime lights are an alternative to the
dipped beam headlights for driving during
the daytime. They are compliant in countries
where is it obligatory to have lights on during the
day and permitted in those where it is not obliga-
tory Daytime lights cannot replace dipped beam
headlights when driving at night or through tunnels.
The use of daytime lights is governed by the High-
way Code of the country you are in. Keep to the
rules.
001-142 Delta 3ed gb 30-11-2009 11:22 Pagina 61