ComponentFluid, Lubricant, or
Genuine PartCapacities
Engine Oil with Filter 6.1L API certified full synthetic 5W-40 engine oil, meeting
the requirements of
Chrysler Material Standard
MS-10725. Refer to your oil
filler cap for correct SAE
grade.7 Quarts (6.6 Liters)
Fuel Selection 3.7L, 5.7L 87 Octane acceptable. 89 Octane recommended
for 5.7L.21 Gallons (79 Liters)
Fuel Selection 6.1L Premium Unleaded 91 Octane or higher.21 Gallons (79 Liters)
Engine Oil Filter 3.7L, 5.7L,
6.1L MOPAR
®Engine Oil Filter
or equivalent. —
Spark Plug 3.7L ZFR6F–11G (Gap 0.043 in
[1.09 mm]) —
Spark Plug 5.7L LZFR5C–11G (Gap 0.043 in
[1.09 mm]) —
Spark Plug 6.1L PLZTRA–13 (Gap 0.050 in
[1.27 mm]) —
Automatic Transmission MOPAR
®ATF+4®
Automatic Transmission
Fluid or equivalent
licensed ATF+4
®product. —
Transfer Case (NV140
Single Speed Only) MOPAR
®ATF+4®
Automatic Transmission
Fluid or equivalent
licensed ATF+4
®product.—
Transfer Case (NV245 Two
Speed Only) MOPAR
®NV 247/245
Transfer Case Lubricant or
equivalent. —
Axle Differential
(Front/Rear) MOPAR
®Synthetic Gear &
Axle Lubricant SAE
75W–140 API–GL5 or
equivalent. With friction
modifier additive. —
MAINTAINING YOUR VEHICLE
64
WHEEL AND WHEEL TRIM CARE
• All wheels and wheel trim, especially aluminum and chrome plated wheels, should becleaned regularly with a mild soap and water to prevent corrosion.
• To remove heavy soil and/or excessive brake dust, use MOPAR
®Wheel Cleaner or
equivalent or select a non-abrasive, non-acidic cleaner.
CAUTION!
Do not use scouring pads, steel wool, a bristle brush, or metal polishes. Do not use
oven cleaner. These products may damage the wheels protective finish. Avoid
automatic car washes that use acidic solutions or harsh brushes that may damage
the wheels protective finish. Only MOPAR
®Wheel Cleaner or equivalent is
recommended.
EXTERIOR BULBS
LIGHT BULBS – Exterior Bulb Number
Backup, Tail, Stop, Turn Lamp 3157K
Center High-Mounted Stop Lamp
(CHMSL) LED (*)
Fog Lamp – If Equipped 9145
Front Park/Turn Signal 3157A
Front Side Marker W5W
Headlamp – High Intensity Discharge
(HID) Service at Authorized Dealer (**)
Headlamp – Low Beam 9006
Headlamp – High Beam 9005
License Lamp 168
* CHMSL is not serviceable. It is a LED lamp. To replace the LED, the entire CHMSL
assembly must be replaced.
** The headlamps are a type of high-voltage discharge tube. High voltage can remain in the
circuit even with the headlamp switch off and the key fob removed. Because of this, you
should not attempt to service a headlamp bulb yourself. If a headlamp bulb fails, take your
vehicle to an authorized dealer for service.
MAINTAINING YOUR VEHICLE
74
