2010 JAGUAR XFR torque

11.
















12.
13.
14. NOTE: LH illustration shown, RH is similar.

















NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Torque: 45 Nm














NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.
Torque: 100 Nm

18.
19.
20.


























NOTE: Some variation in the illustrations may occur,
but the essential information is always correct.















Torque: 5 Nm













21.
Lower the vehicle.

22.
23. Torque:
M6 9 Nm M10 40 Nm














CAUTIONS:


Support the engine on a jack. The angle may need to
be adjusted during this procedure.


Make sure to protect the paintwork.

Special Tool(s): 303-021







24. WARNING: Do not work on or under a vehicle supported only by a
jack. Always support the vehicle on safety stands.
Raise and support the vehicle.

25. www.JagDocs.com

26.
27.
28.



















NOTE: LH illustration shown, RH is similar.

Torque: 43 Nm





















During installation tighten the bolts in the following
sequence.

Torque:
Bolt 1 55 Nm Bolt 2 55 Nm Bolt 1 55 Nm

Published: 11-May-2011
Front Suspension - Front Wheel Bearing and Wheel Hub TDV6 3.0L Diesel /V8 5.0L Petrol/V8 S/C 5.0L Petrol
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details.


1. WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.

2. Torque: 125 Nm 3. Torque: 10 Nm

4. NOTE: LH illustration shown, RH is similar.























5. CAUTION: Discard the bolts.
NOTES:


LH illustration shown, RH is similar.


Secure with cable ties.
Torque: 115 Nm





6. NOTE: LH illustration shown, RH is similar.

7. CAUTIONS:


Discard the bolts.


Make sure that the area around the component is
clean and free of foreign material.


Do not attempt to release the wheel hub by hitting it
with a hammer directly, loosen the wheel hub retaining
bolts partially before applying an even amount of force to
the head of each bolts to release the wheel hub from the
wheel knuckle. Failure to follow this instruction may cause
damage to the component.
NOTES:


Some variation in the illustrations may occur, but the
essential information is always correct.


LH illustration shown, RH is similar.


Install the components to their original fitted
positions.
Torque: 90 Nm
Installation

1. To install, reverse the removal procedure. www.JagDocs.com

Interior Trim and Ornamentation, Removal and Installation).

Vehicles with active damping

2. Disconnect the active suspension damper electrical connector.













All vehicles

3. Remove the shock absorber and spring assembly top mount
nuts. TORQUE: 28 Nm













4. WARNING: Make sure to support the vehicle with axle stands.
Raise the vehicle.

5. Remove the wheel and tire.
For additional information, refer to: Wheel and Tire (204-04 Wheels and Tires, Removal and Installation).