2010 JAGUAR XFR Oil

Engine - V8 S/C 5.0L Petrol - Oil Filter Element
Removal and Installation

Removal Published: 11-May-2011


NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

1. Refer to: Engine Cover - V8 5.0L Petrol/V8 S/C 5.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation).

2.
Allow the engine oil to drain from the oil filter
element housing for two minutes.















3.
4.

3. Check and top-up the engine oil.

4. Start and run the engine.

5. Refer to: Engine Cover - V8 5.0L Petrol/V8 S/C 5.0L Petrol (501-05 Interior Trim and Ornamentation, Removal and Installation). Installation

Engine - V8 S/C 5.0L Petrol - Oil Pan
Removal and Installation

Removal


NOTE: Removal steps in this procedure may contain installation details. Published: 11-May-2011

1. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).


2. WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.

3. Refer to: Engine Oil Level Sensor (303-14D Electronic Engine Controls - V8 S/C 5.0L Petrol, Removal and Installation).

4. www.JagDocs.com

Installation
1. CAUTIONS:


Use only a plastic scraper when removing the sealing
material.


Use lint free cloth.


Make sure that the mating faces are clean and free of
corrosion and foreign material.

Apply RTV sealant WSE-M4G323-A6 (Loctite 5901G)
to the areas shown, and tighten the bolts within 7
minutes.
Apply a bead of sealant, 2.5 mm diameter, to the
area indicated.








2. NOTE: Tighten the bolts in the sequence shown.
Torque: 12 Nm
















3. Refer to: Engine Oil Level Sensor (303-14D Electronic Engine Controls - V8 S/C 5.0L Petrol, Removal and Installation).

34.
















35.
36.
37. NOTE: Discard component.












































NOTE: Make sure to use the aluminium lug provided on the oil pan
extension to lever against.

















NOTE: Do not disassemble further if the component is removed for
access only.

15.
16.
17.
18. Torque: 11 Nm

























Torque: 11 Nm

















NOTE: Lubricate the fuel rail high-pressure fuel pump bucket with clean
engine oil.
















CAUTION: Tighten the Torx screws a turn at a time until the correct
torque is achieved.


NOTE: Lubricate the fuel rail high-pressure fuel pump O-ring seal with
clean engine oil.

Torque: 11 Nm

19.
20.
21.
22. Loosen the Torx screws half a turn each.





































NOTE: Lubricate the fuel rail high-pressure fuel pump bucket with clean
engine oil.
















CAUTION: Tighten the Torx screws a turn at a time until the correct
torque is achieved.


NOTE: Lubricate the fuel rail high-pressure fuel pump O-ring seal with
clean engine oil.

Torque: 11 Nm

23.
24.
25. Loosen the Torx screws half a turn each.




































CAUTIONS:


Install new high-pressure fuel supply lines.


Lubricate only the union threads with clean engine oil.

NOTES:


Remove and discard the blanking caps.


Install the bolt and unions fully finger tight before final tightening.