2010 HONDA INSIGHT S mode

µµ
µ
µ
µ
Adjusts the bass. Adjusts the front-to-back
strength of the sound. To adjust the
front/rear fader, touch the FR or RR
icon.
Adjusts the side-to-
side strength of the sound. To adjust
the left/right balance, touch the L or
Ricon.
The right upper display shows you
the current setting of the sound
strength coming f rom each speaker.
The SVC mode
controls the volume based on vehicle
speed. The f aster you go, the louder
the audio volume becomes. As you
slow down, the audio volume
decreases. Touch the appropriate
icon (Low, Mid, Hi, Of f ) to select the
mode. This f unction is set to MID as the
def ault setting when the vehicle
leaves the f actory. If you f eel the
sound is too loud, choose low. If you
f eel the sound is too quiet, choose Hi.
You can also select the icon with the
joystick. Move it up and down to
move the highlighting and scroll
through lists. Select the icon, then
enter the joystick.
The system will return to the audio
display about 10 seconds af ter you
stop adjusting a mode.
Adjusts the treble. To
adjust the treble and bass, touch
either or on the treble or
bass adjustment bar. The adjustment
bar on the lower right display shows
you the current setting. BASS FADER
BAL ANCE
SVC (speed-sensitive volume
compensation)
TREBLE
Playing the A M/FM Radio (Models with navigation system)
202
SPEAKER SETTING
BASS/TREBLE SETTING
—
—y

y
)"yy
2010 Insight

You can use the instrument panel
brightness control knob to adjust the
illumination of the control panel (see
page ). The audio system
illuminates when the parking lights
are on, even if the radio is turned of f .
You can select the background
screen to display the sound level.
There are three screen modes: level
(the sound level is shown with the
vertical bars), spectrum analysis (the
sound level appears as ripples of
water), and off. Each time you touch
the background icon, the display
changes. 121
Playing the A M/FM Radio (Models with navigation system)
A udio System L ightingScreen Mode
Features
203
—
—y

y
)"yy
2010 Insight

µ´
Playing a Disc (Models with navigation system)
204
SCAN BUTTON JOYSTICK
AUDIO BUTTON POWER/VOLUME
KNOB OPEN BUTTON
RANDOM
BUTTON
REPEAT BUTTON REWIND BUTTON FAST FORWARD
BUTTON
TUNE BAR CD ICON
CD/AUX BUTTON
SKIP BUTTONSKIP BUTTON
—
—y


y
)"yy
2010 Insight

You operate the in-dash disc player
with the same controls used for the
radio.This audio system can also play CD-
RsandCD-RWscompressedinMP3
or WMA f ormats. When playing a
disc in MP3, you will see ‘‘MP3’’ on
the screen. In WMA f ormat, ‘‘WMA’’
will appear on the screen. You can
select up to 255 f olders and play up
to 999 tracks. If the disc has a
complex structure, it takes a while to
readthediscbeforethesystem
begins to play it.If you have a disc that is a
combination of CD-DA tracks and
MP3/WMA f iles, you can choose the
f ormat to listen to by pressing and
holding the CD/AUX button.
Video CDs and DVD discs will not
work in this unit.
A disc compressed in AAC f ormat
cannot be played in this audio
system.
CONT INUED
Playing a Disc (Models with navigation system)
To Play a Disc
(In-dash single player)
Features
205
Do not use discs with adhesive labels.
The label can curl up and cause the
disc to jam in the unit.
—
—y

y
)"y
y
2010 Insight

µ
µ
µ
µµ
µ
µ
µ
The specif ications f or compatible
MP3 f iles are:
The specif ications f or compatible
WMA f iles are: If an MP3 or WMA f ile is
protected by digital rights
management (DRM), the audio unit
displays FILE ERROR, and then
skips to the next f ile.
Sampling f requency:
32/44.1/48 kHz (MPEG1)
16/22.05/24 kHz (MPEG2)
Bitrate:
32/40/48/56/64/80/96/112/128/
160/192/224/256/320 kbps
(MPEG1)
8/16/24/32/40/48/56/64/80/96/
112/128/160 kbps (MPEG2)
Compatible with variable bitrate
and multi-session
Maximum layers
(including ROOT): 8 layers Sampling f requency:
32/44.1/48 kHz
Bitrate:
48/64/80/96/128/160/192 kbps
Maximum layers
(including ROOT): 8 layers Compatible with variable bitrate
and multi-session
Playing a Disc (Models with navigation system)
206
NOTE:
—
—y

y
)"y

y
2010 Insight

The in-dash disc player is behind the
navigation screen. To use the disc
player, press the OPEN button
beside the screen. The screen f olds
back, and the disc slot appears.Insert a disc about half way into the
disc slot. The drive will pull the disc
in the rest of the way and begin to
play it.
You cannot load and play 3-inch
(8-cm)discsinthissystem.To return the screen to the upright
position, press the CLOSE button on
the edge of the screen panel. Do not
use the f olded screen as a tray. If
you put a cup, f or example, on the
screen, the liquid inside the cup may
spill on the screen when you go over
a bump.
CONT INUED
To Load a Disc
Playing a Disc (Models with navigation system)
Features
207
DISC SLOT
CLOSE BUTTON
OPEN BUTTON
—
—y


y
)"y
y
2010 Insight

µµ
Press the AUDIO button beside the
screen to show the audio display and
operate the in-dash disc player.
You can also operate the audio
system without using the control
icons on the audio screen. Press the
CD/AUX button. The status bar
appears on the bottom of the screen.
On the navigation screen, you can
see the audio inf ormation whenever
you touch the AUDIO INFO or
TRACK LIST icons on the lower half
of the screen.
When playing a CD recorded with
text data, the track, album, and artist
name are shown on the audio display.
When playing a disc in MP3 or WMA,
the f older number and name, the f ile
number and name, the artist name,
and the elapsed time are shown. The
system will continuously play a disc
until you change modes. If the disc
was not recorded with text data, it
will not be displayed.
You can use the preset buttons while
a disc is playing to select passages
and change tracks (files in MP3 or
WMA mode). Each preset button’s
f unction is shown on the bottom of
the screen.You can also select an icon with the
joystick. Move it to left, right, up, or
down to change the highlighting and
scroll through lists. Then press ENT
on the top of the joystick to select
the icon.
Each time you press and
release (preset 6), the player
skips forward to the beginning of the
next track (f ile in MP3 or WMA
mode). Press and release (preset 5), to skip backward to
the beginning of the current track.
Press it again to skip to the
beginning of the previous track.
To move rapidly within
a track/f ile, press and hold (preset 4) or (preset 3).
T o Change or Select T racks/Files
SK IP
FF/REW
Playing a Disc (Models with navigation system)
208
PRESET BUTTONS
PRESET BUTTON’S FUNCTION
—
—y

y
)"y
y
2010 Insight

µ
µ
µ
Û Ý
In MP3 or WMA mode In MP3 or WMA mode
This feature,
when activated, replays all f iles on
the selected f older in the order they
are compressed. To activate folder
repeat, press and hold the RPT
button (preset 1) f or 2 seconds. You
will see FOLDER REPEAT in the
display. The system continuously
replays the current f older. Press the
RPT button again to turn it off.
Selecting a dif f erent f older with the
TUNE bar also turns of f f older
repeat.
To continuously replay
a track (f ile in MP3 or WMA mode),
press and release the RPT button
(preset 1). You will see TRACK
REPEAT in the display. Press the
RPT button again to turn it off.
To
select a dif f erent f older, press either
side of the TUNE bar to move to the
beginning of the next f older. Press
the side of the TUNE bar to skip
to the next folder, and the side to
move to the beginning of the current
folder.Pressitagaintoskiptothe
beginning of the previous f older.
CONT INUED
Playing a Disc (Models with navigation system)
FOLDER REPEAT
T RA CK REPEA T (FIL E
REPEAT)
FOLDER SELECTION
Features
209
—
—y

y
)"y
y
2010 Insight