61
SAFETY
STARTING
AND DRIVING
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND CONTROLS
Operation in position Eis limited to the
time during which the lever is kept in that
position manually. When released, the
stalk will return to position Aand the
wiper will be automatically stopped.
IMPORTANT Replace wiper blades as
specified in the “Maintenance and care”
chapter. RAIN SENSOR
(where provided)
The rain sensor is located behind the dri-
ving mirror in contact with the windscreen
and has the purpose of automatically ad-
justing the frequency of the windscreen
wiper strokes as to the rain intensity.
IMPORTANT Keep clean the glass in the
sensor area.
Activation
Move the right stalk down by one click.
The activation of the rain sensor is sig-
nalled by a control acquisition flick.
Turn the ring F-fig. 73to increase the rain
sensor sensitivity.
The increase of the sensitivity of the rain
sensor is signalled by a control and acqui-
sition flick.
The smart cycle is started when the wind-
screen wiper is turned on while the rain
sensor is active without supplementary
flick after 5 seconds. The sensor will re-
sume normal automatic operation. “Smart wash” function
fig. 72
Pull the stalk towards the steering wheel
(unstable position) to operate the wind-
screen washer.
Keeping the stalk pulled for more than half
a second, with just one movement it is
possible to operate the washer jet and the
wiper at the same time.
The jet will be released immediately when
the wiper stops after four flicks.
A further stroke after 5 seconds com-
pletes the wiping operation. Do not use the windscreen
wiper to remove layers of
snow or ice from the wind-
screen. In such conditions, the
windscreen wiper may be subjected to
excessive stress and the motor protec-
tion which prevents operation for a few
seconds may trip. If rear window wiper
operation is not reset, contact the Fi-
at Dealership.
fig. 72F0H0074m
036-092 LUM IDEA GB 2 ed.qxd 14-01-2010 12:15 Pagina 61
122
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
STARTING
AND DRIVING
STORING THE CAR
If the car is to be left inactive for longer
than a month, the following precautions
should be noted:
❒park the car in covered, dry and if pos-
sible well-ventilated premises;
❒engage a gear;
❒check that the handbrake is not en-
gaged;
❒disconnect the negative battery ter-
minal and check battery charge. Re-
peat this check once every three
months during storage. Recharge the
battery if the indicator is dark and the
middle area is not green;
❒clean and protect the painted parts us-
ing protective wax;
❒clean and protect the shiny metal parts
using special compounds readily avail-
able;
❒sprinkle talcum powder on the rubber
windscreen and rear window wiper
blades and lift them off the glass;
❒slightly open the windows;
❒cover the car with a fabric or perfo-
rated plastic terrapin. Do not use
compact plastic sheets which do not
allow humidity to evaporate from the
surface of the car.
❒inflate tyres to a pressure of +0,5 bar
above the normal specified pressure
and check it at intervals;
❒if you don’t disconnect the battery
from the electric system, check its
charge every month and recharge it if
the optical indicator shows a dark
colour without the central green area;
❒do not drain the engine cooling sys-
tem.
111-122 LUM IDEA GB 2 ed.qxd 14-01-2010 12:32 Pagina 122
176
STARTING
AND DRIVING
IN AN
EMERGENCY
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
DASHBOARD
AND
CONTROLS
SAFETY
WARNING
LIGHTS AND
MESSAGES
MAINTENANCE
AND CARE
RUBBER HOSES
Carefully follow the information contained
in the “Service schedule” in this section
for maintenance of brake system and fuel
feed rubber hoses.
Ozone, high temperatures and prolonged
lack of fluid in the system may cause hard-
ening and cracking of the hoses, with pos-
sible leaks. Careful inspections are there-
fore necessary.
WINDSCREEN/REAR
WINDOW
WIPER/WASHER
BLADES
Periodically clean the rubber part using
special products; TUTELA PROFES-
SIONAL SC 35is recommended.
Replace the blades if the rubber edge is
deformed or worn. In all cases, it is ad-
visable to replace them approximately
once a year.
A few simple precautions can reduce the
possibility of damage to the blades:
❒make sure that the rubber part is not
stuck to the windscreen at sub-zero
temperatures. Use an antifreeze prod-
uct to release it if required;
❒remove the snow from the window:
this will avoid overstressing the elec-
trical motor and causing it to overheat
in addition to protecting the blades;
❒do not operate the windscreen and
rear window wipers on dry glass.
Driving with worn wiper
blades is a serious hazard,
because visibility is reduced in bad
weather.
WARNING
Replacing the windscreen wiper
blades fig. 16
Proceed as follows:
❒lift the arm Aof the wiper and posi-
tion the blade so that it forms an an-
gle of 90° with the arm itself;
❒press the tab Bon the clip and extract
the blade from the arm A;
❒fit the new blade, inserting the tab in
the specific set on the arm. Make sure
that it is locked.
fig. 16F0H0217m
161-180 LUM IDEA GB 2 ed.qxd 14-01-2010 13:53 Pagina 176
203
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
DASHBOARD
AND
CONTROLS
SAFETY
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
Rear view mirrors ....................... 42
Rear window wiper
- blades ........................................ 177
- controls .................................... 62
- nozzles ....................................... 176
Rearscreen washer
- controls .................................... 62
- fluid level .................................. 171
Refulling ......................................... 90
Rev counters ................................ 19
Reversing light
- bulb replacement .................. 150
Rims ................................................ 190
Roof rails ...................................... 81
Rubber hoses ................................ 176
Safety .............................................. 93
Seat belts
- general information ................ 97
- height adjustment ................... 95
- maintenance ............................. 99- warming up the engine once
started ....................................... 113
Starting up and driving ................ 111
Steering lock ................................. 18
Steering wheel adjustment ........ 36
Steering ........................................... 188
Storing the car .............................. 122
Storing the car ............................... 122
Sun roof ......................................... 72
Sun visors ...................................... 71
Suspension ..................................... 188
Symbols ........................................... 9
Technical data ............................. 181
Third brake light
- bulb replacement .................. 151
Towing the car ............................. 159
Towing trailers ............................. 117
Transmission ................................. 187
Two-zone automatic climate
control system ............................ 51 - S.B.R. system............................. 94
- use .............................................. 94
Seatbelt tensioners ...................... 97
Seats ................................................ 36
Side air bags .................................. 108
Side lights
- bulb replacement .................... 149
- controls .................................... 58
Smart washing .............................. 61
Snow chains .................................. 121
Spark plugs .................................... 185
Speedometer ................................. 8
Starting the engine ........................ 112
- bump starting............................ 135
- ignition switch .......................... 18
- jump starting ............................ 134
- procedure for Multijet
versions ..................................... 112
- procedure for petrol
versions ...................................... 112
- stopping the engine ................. 113
200-208 LUM IDEA GB 2 ed.qxd 14-01-2010 13:59 Pagina 203
204
STARTING
AND DRIVING
IN AN
EMERGENCY
MAINTENANCE
AND CARE
DASHBOARD
AND
CONTROLS
SAFETY
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
ALPHABETICAL
INDEX
Tyres
- inflation pressure ..................... 192
- snow tyres ............................... 120
- standard .................................... 191
- tyre marking ........................... 189
Unit on roof ............................... 68
Warning lights and messages .. 123
Weights .......................................... 194
Wheel geometry .......................... 189
Wheel
- replacement ............................. 140
- spare wheel .............................. 189
Windows (cleaning) .................... 60
Windows (cleaning) ..................... 60
Windscreen washer
- controls ................................... 60
- fluid level .................................. 171
Windscreen wiper
- blades ........................................ 176
- controls .................................... 60 - jets ............................................. 177
- smart washing ........................ 61
Windscreen/rear screen washing
fluid level; ..................................... 171
200-208 LUM IDEA GB 2 ed.qxd 14-01-2010 13:59 Pagina 204