2010 CITROEN C4 PICASSO remove seats
[x] Cancel search: remove seatsPage 21 of 352
Downloaded from www.Manualslib.com manuals search engine 19
FAMILIARISATION
Deactivation of front passenger
airbag
Child lock
The 3 second-row seats of your vehicle
are fi tted with regulation ISOFIX mount-
ing points, with 3 rings for each seat po-
sition A B C.
This fi xing system is designed for chil-
dren weighing up to 18 kg.
Electric control
135
125
122
Front airbags
Manual control
PASSENGER SAFETY
1.
Insert the key in lock A
.
2.
Select the "OFF"
position.
3.
Remove the key. The rear doors are locked by operating
the lever using the key (aperture at an
angle).
Pressing the button prohibits operation
of the electric windows from the rear
of the vehicle and opening of the rear
doors from inside.
ISOFIX mounting system
Page 32 of 352
Downloaded from www.Manualslib.com manuals search engine 30
FAMILIARISATION
Limit the causes of excess
consumption
Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to the
rear seats.
Limit the loads carried in the vehicle
and reduce wind resistance (roof bars,
roof rack, bicycle carrier, trailer...). Use
a roof box in preference.
Remove roof bars and roof racks after
use.
At the end of winter, remove snow tyres
and refi t your summer tyres.
Observe the recommendations
on maintenance
Check the tyre pressures regularly,
when cold, referring to the label in the
door aperture, driver's side.
Carry out this check in particular:
- before a long journey,
- at each change of season,
- after a long period out of use.
Don't forget the spare wheel and the
tyres on any trailer or caravan.
Have your vehicle serviced regularly (en-
gine oil, oil fi lter, air fi lter...) and observe
the schedule of operations recommended
by the manufacturer.
When refuelling, do not continue after
the 3 rd cut-off of the nozzle to avoid
any overfl ow.
At the wheel of your new vehicle,
it is only after the fi rst 1 800 miles
(3 000 kilometres) that you will see
the fuel consumption settle down to a
consistent average.
Switch off the headlamps and front
foglamps when the level of light does
not require their use.
Avoid running the engine before mov-
ing off, particularly in winter; your ve-
hicle will warm up much faster while
driving.
As a passenger, if you avoid connect-
ing your multimedia devices (fi lm, mu-
sic, video game...), you will contribute
towards limiting the consumption of
electrical energy, and so of fuel.
Disconnect your portable devices be-
fore leaving the vehicle.
Page 69 of 352
Downloaded from www.Manualslib.com manuals search engine III
67
COMFORT
FRONT SEATS
MANUAL ADJUSTMENTS
1. Forwards-backwards
adjustment
Raise the control bar, then slide the
seat to the position desired.
2. Lumbar support
Rotate the control until you attain
the position desired.
3. Seat height adjustment
Raise or lower the the control the
number of times necessary to obtain
the position desired.
4. Backrest angle
Operate the control and adjust the
angle of the backrest.
It is possible to incline the back-
rest 45° rearwards by tilting it until it
locks; to unlock it, lift the control.
5. Armrest
To adjust the position of the armrest,
pull it up and then fully down, and
then raise it to the desired position.
6. Head restraint
To raise it, pull it upwards. To lower
it, press on the control as well as on
the head restraint.
The adjustment is correct when the
top of the head restraint is level with
the top of the head.
It can also be adjusted for tilt (de-
pending on version).
To remove it, press on the unlocking
button and pull it upwards.
To adjust the head restraint for-
wards/backwards, move the base of
the head restraint to obtain the posi-
tion desired.
Never drive without the head re-
straints fi tted. They must be in
place and adjusted correctly.
Page 72 of 352
Downloaded from www.Manualslib.com manuals search engine III
70
COMFORT
REAR HEAD RESTRAINTS
The rear head restraints can be
removed and have two positions:
- high, position for use,
- low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high posi-
tion, push the lug and pull it upwards.
To r efi t it, engage the head restraint
rods in the holes taking care to re-
main in line with the seat back.
SECOND ROW SEATS
Forwards-backwards adjustment
Lift the control A
, located at the front
of the seat, then move the seat to
the desired position.
"Comfort" position
The 3 second-row seats are inde-
pendent of each other and all the
same width. They all can have a
"comfort" position.
Placing a seat in the "comfort"
position
)
Pull on the control B
and guide
the seat rearwards.
The backrest reclines and the seat
base pivots slightly.
Returning the seat to the initial
position
)
Pull on the control B
and allow
the seat to come forwards.
Always supervise any movements
of seats by children. Never drive with the head restraints
removed, they must be in place
and correctly adjusted.
Page 100 of 352
Downloaded from www.Manualslib.com manuals search engine V
98
VISIBILITY
OF XENON HEADLAMPS
This system adjusts the height of the
xenon headlamp beams automati-
cally and when stationary, according
to the load in the vehicle, so as to
avoid causing a nuisance to other
road user.
If a malfunction occurs,
this warning lamp is dis-
played in the instrument
panel, accompanied by
an audible signal and a message in
the screen.
The system then places your head-
lamps in the lowest position.
Do not touch the xenon bulbs.
Contact a CITROËN dealer or a
qualifi ed workshop.
MANUAL ADJUSTMENT OFHEADLAMPS
To avoid dazzling other road users,
the height of the halogen bulb head-
lamps must be adjusted according
to the load in the vehicle. To do this,
turn the control, located below the
dashboard to the left of the driver, to
the appropriate position:
0.
1 or 2 people in the front seats.
-.
3 people.
1.
4 to 7 people.
-.
Intermediate setting.
2.
4 to 7 people + maximum autho-
rised loads.
-.
Intermediate setting.
3.
Driver + maximum authorised loads.
Initial setting is position " 0
".
EXTERIOR SIDE SPOTLAMPS
Switching on
The side spotlamps come on tempo-
rarily:
- when you unlock the vehicle,
- when you press the lighting button
on the remote control,
-
with the automatic guide-me-home
lighting, on switching off the ignition,
- when you remove the key from
the ignition,
- when you open a door,
- when you use the remote control
to locate the vehicle.
Page 115 of 352
Downloaded from www.Manualslib.com manuals search engine VI
11 3
FITTINGS
The roller has a moving fl ap to
avoid interference with the second-
row passengers when the seats
are in the "reclined" position.
)
Engage the lug on the left of the
roller in notch C
.
)
Pass the right-hand end above
the third-row armrest.
)
Engage the lug in notch D
.
)
Pull the seat belt(s) so that they
reel out without locking.
)
Pull out the blind and engage
the guides into the rails on the
pillars.
)
Lock the seat(s) in position.
Installing the roller
)
Reel in the blind, then remove
the roller from its initial position.
)
Position the roller, with the blind
pull bar uppermost, fl ap down-
ward.
)
Fold the concertina boards.
Removing the roller
)
Push the fl ap towards the seat
backrest.
)
Lift the concertina board by tak-
ing it at the side, then position it
vertically.
)
Release the seat by pulling the
strap E
.
)
Push the backrest towards the front.
)
Proceed in reverse order to in-
stalling.
Position 3
7-seat confi guration; stowed behind
the third row seats when these are
folded away.
Installing the roller
)
Fold the concertina boards.
)
Position the roller, with the blind
pull bar uppermost, fl ap down-
ward.
)
Engage the lug on the left of the
roller in notch C
.
)
Pass the right-hand end above
the third-row armrest.
)
Engage the lug in notch D
.
Removing the roller
)
Proceed in reverse order to in-
stalling.
Position 2
7-seat confi guration; installed be-
hind the third-row seats when these
are folded away. This position con-
ceals objects stowed in the boot
from outside view.
The roller can only be stored when
the seats are folded away.
You can position the concertina
board vertically to lodge a bulky ob-
ject in the boot well.
Page 116 of 352
Downloaded from www.Manualslib.com manuals search engine VI
114
FITTINGS
CARGO NET(GRAND C4 PICASSO)
This enables you to maximise the
vehicle’s loadspace.
It retains objects, preventing them
from sliding towards the front of the
passenger compartment.
You insert it under the luggage-
cover roller securing it on the
third-row side mouldings.
Position 1
5-seat confi guration: installed behind
the second row.
Installing the roller
)
Remove the protective covers
located under the blind roller
notches.
)
Position the roller under that of
the luggage-cover blind.
)
Raise the fl ap on the blind, posi-
tioning it on top of the blind.
)
Deploy the net, passing it be-
tween the rollers and the seats.
)
Pull the net upwards.
)
Anchor it to the roof by means of
the fi xing points (after you have
removed their covers).
Removing the roller
)
Carry out these operations in re-
verse order.
Position 2
2-seat confi guration; installed be-
hind the fi rst row.
Removing the roller
)
Carry out these operations in re-
verse order.
Installing the roller
)
With the second-row seats fold-
ed away, remove the covers of
the Isofi x mounting points locat-
ed on the seat backrests.
)
Secure the roller on the Isofi x
mounting points.
)
Deploy the net and pull it up-
wards.
)
Anchor it to the roof by means of
the fi xing points (after you have
removed their covers).
Page 122 of 352
Downloaded from www.Manualslib.com manuals search engine VII
120
CHILD SAFETY
*
Applies only to the CITROËN Grand C4 Picasso.
LOCATIONS FOR CHILD SEATS SECURED WITH THE VEHICLE SEAT BELT
In conformity with European law, this table tells you to what extent each of the seat positions in your vehicle may take a
child seat that is secured with the vehicle seat belt and approved as Universal (a), according to the weight of the child and
the position in the vehicle.
(a) Universal child seat: child seat which can be installed in all vehicles by means of the seat belt.
(b) Group 0: from birth to 10 kg. Shell seats and "car cots" cannot be installed on the front passenger seat.
(c) Consult the legislation in force in your country before installing your child on this seat.
U
: seat position suitable for the installation (in conjunction with the vehicle seat belt) of a universal rearwards-facing and/or
forwards-facing child seat.
For seats in groups 1, 2 and 3, check that the child seat is correctly secured on the backrest of the vehicle seat. If
necessary, remove and stow the head restraint.
To install a voluminous child seat in the 2nd or 3rd row, move the rear seat fully back so as to avoid interference with the
front seat.
Seat position
Weight groups established by legislation
< 10 kg and < 13 kg
(groups 0 (b) and 0+)
9 – 18 kg
(group 1)
15 – 25 kg
(group 2)
22 – 36 kg
(group 3)
1st
row
Front passenger
(c)
U
U
U
U
2nd row
Outer
U
U
U
U
Centre
U
U
U
U
3rd row
*
Outer
U
U
U
U