Downloaded from www.Manualslib.com manuals search engine XI
204
PRACTICAL INFORMATION
Disconnecting the (+)
terminal
)
Raise the lever D
fully to release
the clamp E
.
Do not force the lever as locking
will not be possible if the clamp is
not positioned correctly; start the
procedure again.
Reconnecting the (+) terminal
)
Position the open clamp E
of the
cable on the positive post (+) of
the battery.
)
Press down on the clamp to po-
sition it correctly on the battery
post.
)
Lock the clamp by lowering the
lever D
.
Starting using another
battery
If the battery in your vehicle is fl at,
the engine can be started using a
slave battery (external or in another
vehicle) and jump leads.
First ensure that the slave
battery has a nominal volt-
age of 12 V and a capac-
ity at least equal to that of the fl at
battery.
Do not try to start the engine by
connecting a battery charger.
Do not disconnect the (+) terminal
when the engine is running.
)
Connect the red lead to the (+)
terminal of the fl at battery A
,
then to the (+) terminal of the
slave battery B
.
)
Connect one end of the green or
black lead to the (-) terminal of
the slave battery B
(or the earth
point on the slave vehicle).
)
Connect the other end to the
earth point C
on the broken-
down vehicle.
)
Start the engine on the slave ve-
hicle and leave the engine run-
ning for a few minutes.
)
Operate the starter on the bro-
ken-down vehicle and leave the
engine running.
If the engine does not start
straight away, switch off the ig-
nition and wait a few moments
before trying again.
)
With the engine idling, discon-
nect the jump leads in reverse
order.
