4. Find the jacking location from the diagram aboveand use the corresponding cutouts located in theplastic molding.
The front location is (A) 8.5 inches (21 cm) from therear edge of the front wheel well, and the rearlocation (B) is 3.5 inches (8.5 cm) from the frontedge of the rear wheel well.
The notches may also be labeled JACK with anarrow pointing to the jacking location on the vehicle.
{WARNING:
Getting under a vehicle when it is jacked up is
dangerous. If the vehicle slips off the jack, you
could be badly injured or killed. Never get under a
vehicle when it is supported only by a jack.
{WARNING:
Raising your vehicle with the jack improperly
positioned can damage the vehicle and even
make the vehicle fall. To help avoid personal injury
and vehicle damage, be sure to fit the jack lift
head into the proper location before raising
the vehicle.
Notice:If you position the jack under the rockermolding and attempt to raise the vehicle, you couldbreak the molding and/or cause other damage toyour vehicle. Always position the jack so that whenthe jack head is raised, it will fit firmly in thenotch located inboard from the rocker molding.
6-84
