2010 CADILLAC DTS light

LANE DEPARTURE SYSTEM
UNAVAILABLE
If your vehicle has the Lane Departure Warning (LDW)system, this message may display if the LDW systemdoes not activate due to a temporary condition.SeeLane Departure Warning (LDW) on page 3-46formore information.
LEFT REAR DOOR OPEN
This symbol appears withthis message.
This message displays when the driver side rear door isnot closed completely. Make sure that the door isclosed completely.
NO CRUISE BRAKING GAS PEDAL
APPLIED
This message displays when the Adaptive CruiseControl (ACC) is engaged and you are pressing theaccelerator pedal enough to disable ACC automaticbraking. SeeAdaptive Cruise Control on page 4-15formore information.
OIL PRESSURE LOW STOP ENGINE
Notice:If you drive your vehicle while the engineoil pressure is low, severe engine damage mayoccur. If a low oil pressure warning appears on theinstrument panel cluster and/or DIC, stop thevehicle as soon as possible. Do not drive the vehicleuntil the cause of the low oil pressure is corrected.SeeEngine Oil on page 6-13for more information.
This message displays when the vehicle’s engineoil pressure is low. The oil pressure light also appearson the instrument panel cluster. SeeOil PressureLight on page 4-59.
A multiple chime sounds when this message is displayed.SeeEngine Oil on page 6-13for more information.
Stop the vehicle immediately, as engine damage canresult from driving a vehicle with low oil pressure. Havethe vehicle serviced by your dealer/retailer as soonas possible when this message is displayed.
4-72

RIGHT REAR DOOR OPEN
This symbol appears withthis message.
This message displays when the passenger side reardoor is not closed completely. Make sure that the door isclosed completely.
SERVICE AIR BAG
This message displays when there is a problem with theairbag system. Have your vehicle serviced by yourdealer/retailer immediately. SeeAirbag Readiness Lighton page 4-50for more information.
SERVICE A/C SYSTEM
This message displays when the air delivery mode dooror the electronic sensors that control the air conditioningand heating systems are no longer working. Havethe climate control system serviced by yourdealer/retailer if you notice a drop in heating and airconditioning efficiency.
SERVICE BATTERY CHARGING
SYSTEM
This message displays when a problem with thecharging system has been detected. The chargingsystem light also displays on the instrument panelcluster. SeeCharging System Light on page 4-52formore information. Have your vehicle serviced byyour dealer/retailer.
SERVICE BRAKE ASSIST
This message displays if there is a problem with thebrake system. The brake system warning light and theantilock brake system warning light may also bedisplayed on the instrument panel cluster. SeeBrakeSystem Warning Light on page 4-52andAntilock BrakeSystem (ABS) Warning Light on page 4-53for moreinformation. If this happens, stop as soon as possibleand turn off the vehicle. Restart the vehicle andcheck for the message on the DIC display. If themessage is displayed or appears again when you begindriving, the brake system needs service. See yourdealer/retailer as soon as possible. SeeBrakeson page 6-32for more information.
4-74

SERVICE BRAKE SYSTEM
This message displays if the ignition is on to inform thedriver that the brake fluid level is low. Have the brakesystem serviced by your dealer/retailer as soon aspossible.
SERVICE LANE DEPARTURE SYSTEM
If your vehicle has the Lane Departure Warning(LDW) system, this message may display to indicatethat the LDW system is not working properly. Ifthis message remains on after continued driving, thesystem needs service. See your dealer/retailer.SeeLane Departure Warning (LDW) on page 3-46formore information.
SERVICE PARKING ASSIST
If your vehicle has the Ultrasonic Front and RearParking Assist (UFRPA) system, this message displaysif there is a problem with the UFRPA system. Do notuse this system to help you park. SeeUltrasonic Frontand Rear Parking Assist (UFRPA) on page 3-40formore information. See your dealer/retailer for service.
SERVICE POWER STEERING
Your vehicle may have a speed variable assist steeringsystem. SeeSteering on page 5-8.
This message displays if a problem is detected with thespeed variable assist steering system. When thismessage is displayed, you may notice that the effortrequired to steer the vehicle decreases or feels lighter,but you will still be able to steer the vehicle.
SERVICE RADAR CRUISE
This message displays when the Adaptive CruiseControl (ACC) system and the Forward Collision Alert(FCA) system are disabled and need service. Seeyour dealer/retailer.
SERVICE SIDE BLIND ZONE ALERT
SYSTEM
If your vehicle has the Side Blind Zone Alert (SBZA)system and this message displays, both SBZA displayswill remain on indicating there is a problem with theSBZA system. If these displays remain on aftercontinued driving, the system needs service. See yourdealer/retailer. SeeSide Blind Zone Alert (SBZA)on page 3-43for more information.
4-75

SERVICE STABILITRAK
Your vehicle may have a vehicle stability enhancementsystem called StabiliTrak®. SeeStabiliTrak®Systemon page 5-5.
This message displays if there has been a problemdetected with the StabiliTrak system.
If this message comes on while you are driving, pull offthe road as soon as possible and stop carefully. Tryresetting the system by turning the ignition off then backon. If this message still stays on or comes back onagain while you are driving, your vehicle needs service.Have the StabiliTrak system inspected by yourdealer/retailer as soon as possible.
SERVICE SUSPENSION SYS (System)
This message displays when the magnetic ridecontrol or automatic leveling control system is notoperating properly. Have your vehicle serviced by yourdealer/retailer.
SERVICE THEFT DETERRENT SYSTEM
This message displays when there is a problem withthe theft-deterrent system programmed in the key.A fault has been detected in the system which meansthat the system is disabled and it is not protectingthe vehicle. The vehicle usually restarts; however, youmay want to take the vehicle to your dealer/retailer
before turning off the engine. SeePASS-Key®III+Electronic Immobilizer Operation on page 3-21for moreinformation.
SERVICE TIRE MONITOR SYSTEM
On vehicles with the Tire Pressure Monitor System(TPMS), this message displays if a part on the TPMS isnot working properly. The tire pressure light alsoflashes and then remains on during the same ignitioncycle. SeeTire Pressure Light on page 4-56. Severalconditions may cause this message to appear. SeeTirePressure Monitor Operation on page 6-58for moreinformation. If the warning comes on and stays on, theremay be a problem with the TPMS, see yourdealer/retailer.
SERVICE TRACTION CONTROL
This message displays when there is a problem with theTraction Control System (TCS). When this messageis displayed, the system will not limit wheel spin. Adjustyour driving accordingly. See your dealer/retailer forservice. SeeTraction Control System (TCS) on page 5-6for more information.
SERVICE TRANSMISSION
This message displays when there is a problem with thevehicle’s transmission. Have your vehicle serviced byyour dealer/retailer.
4-76

SERVICE VEHICLE SOON
This message displays when a non-emissions relatedmalfunction occurs. Have your vehicle serviced by yourdealer/retailer as soon as possible.
SET SPD (Speed)
If your vehicle has Adaptive Cruise Control (ACC), thismessage displays whenever the cruise control isset. First, the “CRUISE SET TO XXX MPH (km/h)”message appears. After a few seconds, the “CRUISESET TO XXX MPH (km/h)” message clears and themessage “SET SPD XX” displays at the bottom of theDIC. See “CRUISE SET TO XXX MPH (km/h)” earlier inthis section andAdaptive Cruise Control on page 4-15for more information.
SIDE BLIND ZONE ALERT
SYSTEM OFF
If your vehicle has the Side Blind Zone Alert (SBZA)system, this message displays when the SBZA systemhas been turned off. SeeSide Blind Zone Alert(SBZA) on page 3-43andDIC Operation and Displayson page 4-62for more information.
SIDE BLIND ZONE SYSTEM
UNAVAILABLE
If your vehicle has the Side Blind Zone Alert (SBZA)system, this message displays when the SBZA systemis disabled because the sensor is blocked and cannotdetect vehicles in your blind zone. The sensor maybe blocked by mud, dirt, snow, ice, or slush. Thismessage may also display during heavy rain or due toroad spray. It may also come on when driving inisolated areas with no guardrails, trees, or road signsand light traffic. Your vehicle does not need service.For cleaning instructions, seeWashing Your Vehicle onpage 6-95. SeeSide Blind Zone Alert (SBZA) onpage 3-43for more information.
SPEED LIMIT XXX MPH (km/h)
This message displays when the Speed Alert has beenturned on through the DIC Information Menu and thevehicle is at or above the speed limit. SeeDIC Operationand Displays on page 4-62for more information.
SPEED LIMITED TO XXX MPH (km/h)
This message displays when your vehicle speedis limited to 128 km/h (80 mph) because the vehicledetects a problem in the speed variable assist steering,magnetic ride control, or automatic leveling controlsystems. Have your vehicle serviced by yourdealer/retailer.
4-77

STABILITRAK NOT READY
If your vehicle has StabiliTrak, this message may displayand the Traction Control System and StabiliTrak WarningLight on the instrument panel cluster may be on after firstdriving the vehicle and exceeding 30 km/h (19 mph) for30 seconds. The StabiliTrak system is not functional untilthe light has turned off. SeeStabiliTrak®System onpage 5-5for more information.
STARTING DISABLED SERVICE
THROTTLE
This message displays when your vehicle’s throttlesystem is not functioning properly. Have your vehicleserviced by your dealer/retailer.
THEFT ATTEMPTED
This symbol appears withthis message.
This message displays if the content theft-deterrentsystem has detected a break-in attempt while you wereaway from your vehicle. SeeContent Theft-Deterrenton page 3-19for more information.
TIGHTEN GAS CAP
This message displays when the fuel cap has not beenfully tightened. Recheck the fuel cap to ensure that itis on and tightened properly.
TIRE LEARNING ACTIVE
This message displays when the Tire Pressure MonitorSystem (TPMS) is re-learning the tire positions on yourvehicle. The tire positions must be re-learned afterrotating the tires or after replacing a tire or sensor. SeeTire Inspection and Rotation on page 6-62,Tire PressureMonitor System on page 6-57, andInflation - TirePressure on page 6-54for more information.
TRACTION CONTROL OFF
This message displays when the Traction ControlSystem (TCS) is turned off. Adjust your drivingaccordingly. SeeTraction Control System (TCS) onpage 5-6for more information.
4-78

AUTO DOOR UNLOCK
This feature allows you to select whether or not to turnoff the automatic door unlocking feature. It alsoallows you to select which doors and when the doorswill automatically unlock. SeeProgrammable AutomaticDoor Locks on page 3-10for more information.
Press the customization button until AUTO DOORUNLOCK appears on the DIC display. Press theset/reset button once to access the settings for thisfeature. Then press the menu up/down button to scrollthrough the following settings:
OFF:None of the doors will automatically unlock.
DRIVER AT KEY OUT:Only the driver’s door willunlock when the key is taken out of the ignition.
DRIVER IN PARK:Only the driver’s door will unlockwhen the vehicle is shifted into P (Park).
ALL AT KEY OUT:All of the doors will unlock whenthe key is taken out of the ignition.
ALL IN PARK (default):All of the doors will unlockwhen the vehicle is shifted into P (Park).
NO CHANGE:No change will be made to this feature.The current setting will remain.
To select a setting, press the set/reset button while thedesired setting is displayed on the DIC.
REMOTE DOOR LOCK
This feature allows you to select the type of feedbackyou will receive when locking the vehicle with theRemote Keyless Entry (RKE) transmitter. You will notreceive feedback when locking the vehicle with theRKE transmitter if the doors are open. SeeRemoteKeyless Entry (RKE) System Operation on page 3-4formore information.
Press the customization button until REMOTE DOORLOCK appears on the DIC display. Press the set/resetbutton once to access the settings for this feature.Then press the menu up/down button to scroll throughthe following settings:
OFF:There will be no feedback when you press thelock button on the RKE transmitter.
LIGHTS ONLY:The exterior lamps will flash when youpress the lock button on the RKE transmitter.
HORN ONLY:The horn will sound on the second pressof the lock button on the RKE transmitter.
HORN & LIGHTS (default):The exterior lamps willflash when you press the lock button on the RKEtransmitter, and the horn will sound when the lock buttonis pressed again within five seconds of the previouscommand.
NO CHANGE:No change will be made to this feature.
4-82

The current setting will remain.
To select a setting, press the set/reset button while thedesired setting is displayed on the DIC.
REMOTE DOOR UNLOCK
This feature allows you to select the type of feedbackyou will receive when unlocking the vehicle withthe Remote Keyless Entry (RKE) transmitter. You willnot receive feedback when unlocking the vehiclewith the RKE transmitter if the doors are open. SeeRemote Keyless Entry (RKE) System Operationon page 3-4for more information.
Press the customization button until REMOTE DOORUNLOCK appears on the DIC display. Press theset/reset button once to access the settings for thisfeature. Then press the menu up/down button to scrollthrough the following settings:
LIGHTS OFF:The exterior lamps will not flash whenyou press the unlock button on the RKE transmitter.
LIGHTS ON (default):The exterior lamps willflash when you press the unlock button on theRKE transmitter.
NO CHANGE:No change will be made to this feature.The current setting will remain.
To select a setting, press the set/reset button while thedesired setting is displayed on the DIC.
DELAY DOOR LOCK
This feature allows you to select whether or not thelocking of the vehicle’s doors will be delayed. Whenlocking the doors with the power door lock switch and adoor is open, this feature will delay locking the doorsuntil five seconds after the last door is closed. You willhear three chimes to signal that the delayed lockingfeature is in use. The key must be out of the ignition forthis feature to work. You can temporarily overridedelayed locking by pressing the power door lock switchtwice or the lock button on the RKE transmitter twice.
Press the customization button until DELAY DOORLOCK appears on the DIC display. Press the set/resetbutton once to access the settings for this feature.Then press the menu up/down button to scroll throughthe following settings:
OFF:There will be no delayed locking of thevehicle’s doors.
ON (default):The doors will not lock until five secondsafter the last door is closed.
NO CHANGE:No change will be made to this feature.The current setting will remain.
To select a setting, press the set/reset button while thedesired setting is displayed on the DIC.
4-83