Page 33 of 136
Low-beam headlight
The low-beam headlight switcheson automatically when the igni-tion is switched on.
The low-beam headlightplaces a strain on the bat-tery. Do not switch the ignitionon for longer than absolutelynecessary.
High-beam headlight
Press front section of switch1to switch on the high-beamheadlight.
Press rear section of switch1to switch off the high-beamheadlight.
Headlight flasher
Press button1to operate theheadlight flasher.
Turn indicators
Operating flashing turn
indicators
Switch on the ignition.
Push button1to the left toswitch on the left flashing turnindicators.
Push button1to the right toswitch on the right flashing turnindicators.
Centre button1to cancel theflashing turn indicators.
Hazard warning
flashers
Operating hazard warning
flashers
Switch on the ignition.
4
31
zOperation
Page 39 of 136

Rebound stage, basicsetting, rear
turn the bottom adjustingscrew as far as it will go inthe clockwise direction andthen back it off half a turn(Full load of fuel, with rider85 kg)
Tyres
Checking tyre pressure
Incorrect tyre pressures im-pair the motorcycle's hand-ling characteristics and increasethe rate of tyre wear.
Always check that the tyre pres-sures are correct.
At high road speeds, tyrevalves installed perpen-dicular to the wheel rim have atendency to open as a result ofcentrifugal force.
In order to avoid a sudden loss oftyre pressure, fit a valve cap with
rubber sealing ring to the reartyre and make sure that the capis screwed on firmly.
Make sure the ground is leveland firm and place the motor-cycle on its stand.
Check tyre pressures againstthe data below.
Tyre pressure, front
1.9 bar (one-up, at tyre tem-perature 20 °C)
2.1 bar (two-up and/or withluggage, at tyre temperature20 °C)
Tyre pressure, rear
2.1 bar (one-up, at tyre tem-perature 20 °C)
2.3 bar (two-up and/or withluggage, at tyre temperature20 °C)
If tyre pressure is too low:
Correct tyre pressure.
Headlight
Adjusting headlight for
driving on right/driving on
left
If the motorcycle is ridden in acountry where the opposite ruleof the road applies, its asymmet-ric low-beam headlight will tendto dazzle oncoming traffic.
Have the headlight set accord-ingly by a specialist workshop,preferably an authorised BMWMotorrad dealer.
Headlight beam throw and
spring preload
Headlight beam throw is gener-ally kept constant when springpreload is adjusted to suit load.
Spring preload adjustment mightnot suffice only if the motorcycleis very heavily loaded. Under
4
37
zOperation
Page 87 of 136

nical data". The figures in thegraphic correspond to the fusenumbers.
Close the fuse cover.
The latch engages with anaudible click.
Installing seat (39).
Bulbs
Notes
A defective bulb placesyour safety at risk becauseit is easier for other users tooversee the motorcycle.
Replace defective bulbs assoon as possible; always carry acomplete set of spare bulbs ifpossible.
The bulb is pressurised andcan cause injury if dam-aged.
Wear protective goggles andgloves when changing bulbs.
The types of bulb fitted toyour motorcycle are listedin the section entitled "Technicaldata".
Do not touch the glass ofnew bulbs with your fingers.Use a clean, dry cloth to holdthe bulbs when handling them.Dirt deposits, in particular oil andgrease, interfere with heat radi-ation from the bulb. This leadsto overheating and shortens thebulb's operating life.
Replacing low-beam and
high-beam headlight bulb
If it is not standing firmly,the motorcycle could topplein the course of the operationsdescribed below.
Always make sure that themotorcycle is stable and firmlysupported.
Make sure the ground is leveland firm and place the motor-cycle on its stand.
Switch off the ignition.
Disconnect plug1.
Remove rubber cap2.
8
85
zMaintenance
Page 88 of 136
The rubber cap enclosesand forms a seal aroundthe wiring for the parking light.Consequently, the rubber capcannot be removed.
Turn retaining ring3counter-clockwise to release and re-move the ring.
Remove bulb4.
Replace the defective bulb.
Bulb for low-beam andhigh-beam headlight
H4 / 12 V / 55 W / 60 W
Install bulb4, making sure thattab5is correctly positioned.
Hold retaining ring3in positionand turn it clockwise to secure.
Install rubber cap2.
Connect plug1.
8
86
zMaintenance
Page 117 of 136
Lighting
Bulb for low-beam and high-beam headlightH4 / 12 V / 55 W / 60 W
Bulb for parking lightW5W / 12 V / 5 W
Bulb for tail light/brake lightP21/5W / 12 V / 5 W / 21 W
Bulbs for flashing turn indicators, frontR10W / 12 V / 10 W
Bulbs for flashing turn indicators, rearR10W / 12 V / 10 W
Fuses
Current rating of fuse 1 (for engine electronics)15 A
Current rating of fuse 2 (for instrument panel, haz-ard warning flashers, on-board socket, optionalaccessories and diagnosis plug)
10 A
Current rating of fuse 3 (for horn and headlightflasher)7.5 A
Current rating of fuse 4 (for low-beam headlight)7.5 A
10
115
zTechnical data
Page 131 of 136

AAbbreviations and symbols, 6
ABSControl, 18
Engineering details, 54
Self-diagnosis, 45
Switching off and on, 33
Warnings, 23
AccessoriesNotes, 58
Air filterPosition on the motorcycle, 13
Replacing, 91
BBatteryCharging battery whenconnected, 94
Charging battery whendisconnected, 94
Installation, 95
Maintenance instructions, 93
Removal, 94
Stowage, 11
BMW Motorrad service, 120
Brake fluidChecking fluid levels, 70
Reservoir, front, 13
Reservoir, rear, 13
Brake padsChecking brake-padthickness, 68
Running in, 46
BrakesChecking operation, 68
Notes, 47
Technical data, 113
BulbsNotes on replacement, 85
Replacing brake-light bulb, 90
Replacing high-beam headlightbulb, 85
Replacing low-beam headlightbulb, 85
Replacing rear light bulb, 90
Replacing side-light bulb, 87
Replacing turn indicatorbulb, 88
Technical data, 115
CCare, 101
CaseOperation, 59
ChainAdjusting sag, 76
Checking sag, 75
Checking wear, 76
Lubricating, 75
Checklist, 44
Clock, 15Adjusting, 29
ClutchAdjusting clutch lever, 34
Adjusting handlebar-leverplay, 74
Checking play, 73
Technical data, 111
Confirmation of maintenancework, 122
CoolantChecking fluid level, 72
Fore-and-aft tilt indicator, 11
Topping up, 73
12
129
zIndex
Page 133 of 136

IgnitionSwitching off, 28
Switching on, 28
Ignition switch, 28
Instrument clusterOverview, 15
JJump starting, 92
KKeys, 28
LLaying up, 104
LightsHeadlight flasher, 31
Switch on the high-beamheadlight, 31
Switch on the parking lights, 29
Switching on low-beamheadlight, 31
Switching on the parkinglights, 30
Low-beam headlightSwitching on, 31
LuggageInstructions for loading, 42
MMaintenanceNotes, 66
Maintenance intervals, 121
MirrorsAdjusting, 34
Mobility services, 120
MotorcycleCare, 101
Laying up, 104
Overview, 11, 13
Parking, 49
Restoring to use, 104
OOdometer and tripmeters, 15Operation, 30
Off-roading, 47
PParking, 49
Power socket, 11Notes on use, 58
RRear-wheel driveTechnical data, 112
Refuelling, 49
Restoring to use, 104
Rev. counter, 15
Rider's ManualStowage, 14
Running gearTechnical data, 112
Running in, 46
SSafety instructions, 42
SeatInstallation, 38
Lock, 11
Removal, 38
Service, 120Side lightSwitching on, 30
Spark plugsTechnical data, 114
Speedometer, 15
12
131
zIndex