2010 BMW ACTIVEHYBRID X6 park assist

Reference
At a glance
Controls
Driving tips
Mobility
5
The individual vehicle
When purchasing your BMW, you have decided
in favor of a model with individualized equip-
ment and features. This Owner's Manual
describes the entire array of options and equip-
ment available with a specific BMW model.
Please bear in mind that the manual may con-
tain information on accessories and equipment
that you have not specified for your own vehicle.
Sections describing options and special equip-
ment are marked by asterisks
* to assist you in
identifying possible differences between the
descriptions in this manual and your own vehi-
cle's equipment.
If equipment in your BMW is not described in
this Owner's Manual, please refer to the BMW
X6 Owner's Manual.
Editorial notice
BMW pursues a policy of continuous, ongoing
development that is conceived to ensure that
our vehicles continue to embody the highest
quality and safety standards combined with
advanced, state-of-the-art technology. For this
r e a s o n , i t i s p o s s i b l e t h a t t h e f e a t u r e s d e s c r i b e d
in this Owner's Manual could differ from those
on your vehicle.
For your own safety
The BMW ActiveHybrid X6 has special fea-
tures, e.g. electric driving, that can require spe-
cial alertness in traffic.
During electric driving, please note that
pedestrians and other road users may fail
to notice the vehicle in the usual way due to the
lack of engine noise. For example, proceed with
particular caution when pulling into and out of a
parking space.<
Maintenance and repairs
Advanced technology, e.g. the use of
modern materials and high-performance
electronics, requires specially adapted mainte-nance and repair methods. Therefore, have cor-
responding work on your BMW performed only
by your BMW Sports Activity Vehicle Center or
a repair shop that works according to BMW
repair procedures with correspondingly trained
personnel. If this work is not carried out prop-
erly, there is a danger of subsequent damage
and related safety hazards. Particularly when
work is performed on the high-voltage systems,
lack of expertise can lead to life-threatening
injuries.<
Teleservice Report*
Transmits technical data about your vehicle as
needed to BMW at regular intervals; these data
are used in the development of BMW products.
The service is only used in vehicles with partic-
ular technical equipment. A Teleservice Report
is only activated in connection with the BMW
SIM card-equipped phone unit installed in the
vehicle and does not cost you anything. Neither
personal data nor location data are transmitted.

Reference
At a glance
Controls
Driving tips
Mobility
37
Giving and receiving assistance
Jump starting, charging
high-voltage battery
Your BMW ActiveHybrid X6 is equipped with
two types of battery:
>12 Volt battery
>High-voltage battery
If the 12 Volt battery or high-voltage battery is
dead, the combustion engine can be started
with the aid of another vehicle using two jumper
cables.
Only use jumper cables with fully insulated ter-
minal clamps and do not deviate from the
described procedure.
To avoid the risk of potentially fatal injury,
always avoid all contact with electrical
components while the engine is running. Care-
fully adhere to the following sequence, both to
prevent damage to one or both vehicles, and to
guard against possible personal injuries.<
Identifying the dead battery
>Dead 12 Volt battery: Ignition cannot be
switched on.
>Dead high-voltage battery: Ignition can be
switched on. Drive readiness cannot be
activated.
A message appears on the Control Display.
Preparation
1.Check whether the battery of the other
vehicle is a 12 Volt battery and has approxi-
mately the same capacitance in Ah. This
information can be found on the battery.
2.Switch off the engine of the assisting vehi-
cle.
3.Switch off any electrical systems and com-
ponents in both vehicles.
There must not be any contact between
the bodies of the two vehicles, otherwise
there is a danger of shorting.<
Connecting jumper cables
To avoid personal injury from sparks, fol-
low this sequence when connecting
jumper cables.<
In your BMW, the so-called jump-starting termi-
nal in the engine compartment functions as the
positive battery terminal, also refer to the
engine compartment overview on page35. The
cover cap is marked with a + symbol.
1.Fold open the cover of the BMW starting-
aid terminal. To do so, pull the tab.
2.Attach one end of the jumper cable plus/+
to the positive terminal of the battery or a
starting-aid terminal of the vehicle provid-
ing assistance.
3.Attach the second end of the cable to the
positive terminal of the battery or to a start-
ing-aid terminal of the vehicle to be started.
4.Attach one end of the jumper cable minus/–
to the negative terminal of the battery or to
an engine or body ground of the assisting
vehicle.
Your BMW has a special nut as body ground
or negative pole.

Giving and receiving assistance
40 trained personnel. Otherwise, there is the risk of
life-threatening injury by electrocution due to
the high voltage of the hybrid system.<
Hybrid system: Contact with water
The hybrid system is generally safe, even in the
following sample situations:
>Water in the footwell, e.g. when rain show-
ers occur with an open glass roof.
>The vehicle is in water, e.g. in a flood.
>Fluid escapes in the cargo bay.
In these cases, there is no danger of being
injured by electrocution. Other types of damage
to the vehicle are possible.
Hybrid system: Automatic deactivation
In the event of an accident, the hybrid system is
switched off automatically in order to protect
passengers and other road users from injury.
The high-voltage system is automatically
switched off in the following sample situations:
>Sensors of the airbag system detect an
accident
>Obstacles on the road damage the under-
body and high-voltage cables
After an accident, do not touch any
exposed high-voltage components. Oth-
erwise, there is the risk of life-threatening injury
by electrocution due to the high voltage of the
hybrid system.<
Also follow the instructions for what to do after
an accident.
What to do after an accident
If you should get into an accident with your
vehicle, the following safety precautions must
be taken with regard to the hybrid system:
>Secure the accident site.
>Immediately inform the paramedics, police,
o r f ir e d e p a r t m e n t o f t h e f a c t t h a t i t i s a v e h i-
cle equipped with a hybrid system.>Move the selector lever into position P, set
the parking brake, and switch off drive
readiness.
>Do not touch any orange high-voltage
cables and connectors or high-voltage
components. Otherwise, there is the risk of
life-threatening injury by electrocution.
>Do not inhale gases emanating from the
high-voltage battery. Stay away from the
vehicle if necessary.
>Contact a service center in order to ascer-
tain the damage.