2010 AUDI S8 wiper blades

Intermittent wiping ~l (acti vating rain
sensor )
- Move the lever up to position (D.
- Move switch @up or down , to adjust the sensitivity of the
rain sensor.
Low wip er sp eed
- Move the lever up to position@.
High wiper speed
- Move the lever up to position ®·
One-touch wiping
- Move the lever to position@, when you want to wipe the
windshield
briefly .
Automatic wiper /washer
- Pull the lever to position © (toward the steering wheel)
and hold.
- Release the lever . The washer stops and the wipers keep
going for about four seconds.
Turning off the wipers
- Move the lever back to positio n@ .
The windshield wipe rs and washer only work when the ignition is
turned on.
T he rain sensor is only activated with the wiper leve r set to position
@ . When i t starts to rain, the rain sensor will automatically activate
the intermittent wiping mode .
T o red uce the sensit iv ity of the senso r, move sw itch @down. To
increase the sensitivity, move the switch up . The higher you adjust the
Controls and equip ­
ment Safety first
Clear v
ision
sensitivity, the faster the sensor will react when it senses mo isture on
t he windsh ie ld. T he rain senso r wiper inte rvals depend on the sensi­
tiv ity setting as well as vehicle speed . During brief stops, w iper
motion will adj ust in relation to the amount of rain on the winds hield.
Dur ing b rief stops, e .g . at a red light , w iper motion will automatically
be reduced to the next lower speed. Wipers already turn ing at low
speed. c hange to intermittent w iping.
When the ign ition is turned on, the washer jets are heated.
With the low beam headlights switched on, pull the wiper lever
towards you o nly
briefly to clean the w indshield . Holding the wiper
lever would also engage the headlight washer system each time you
clean the w indshield and would d rain the washer fluid rese rvoir
prematurely .
& WARNING
• Wiper bl ade s a re cruci al for safe dri ving! Only when the y are in
good condition are th ey able to clear the wind ows properly to
pro vide uncompr omi sing visibilit y. Worn or damaged wipe r
blade s ar e a safet y hazard =>
pag e 73, "In stalling new wiper
blades "!
• The rain sensor i s only des igned t o assist and support the
dri ver. It rem ain s entirely the d river's re spon sibility to m onito r
out side weather condition s and to manually a ctivate the wipers as
soon a s rain or dr izzle reduce s visibil ity th rough the windshield.
• The win dshield mu st not be treated with wat er- re pellent
m aterial s. They c an in crease gla re under po or visibilit y condit ions
s u ch as wetn ess, darkne ss, or when the sun i s low on the horizon .
In addition , they can cause the wi ndshield wipers to chatter.
0 Note
In freezing or near freezing conditions:
• Always check that the wiper blades a re not frozen to the glass
before you turn the wipers on. Loosen a wiper blade which is fro zen in ..,
Vehicle care Technical data

Clear vision
place before operating the wipers to prevent damage to the wiper
blade o r th e wiper motor.
• Do not use the wipers to clear a frosted window. Us ing the wipers
as a convenie nt ice scraper wi ll dest roy the w iper blades .
• Before you take your vehicle to an automatic car wash, make sure
you have the w ind shield wipe r sys tem sw itched off (lever in posi tion
0), otherw ise the windshie ld wiper system cou ld get damaged in the
car w ash if i t shou ld sudden ly come on.
[ i ] Tips
• Make s ure the washe r flu id reservoir in the eng ine compa rtment is
topped off before going on a long trip . Look up~
page 305 for
check ing and filling the washer conta iner.
• If you switch off the ignition with the w indshield wiper lever still
in the inte rval wipe posit io n and then come bac k a w hile la ter and
dr ive off, the rain sensor will reactivate itself afte r the ve hicle speed
has exceeded 4 mph (6 km/h).
• Worn or d irty windshield w iper blades cause smear ing which can
affect the operation o f the rain senso r. Check the cond it io n of your
w indshield wiper b lades regularly .•
Headlight washer system
The headlight washer system cleans the headlights.
- Operate the wi ndsh ield wip er/was her syst em ® with the
headlig hts turned on by hold ing the lever for lo nger than
one second=>
page 70, fig. 67 .
The washer je ts extend fo rwa rd o ut of the front bumper driven by
water pressure to spray the front headlights w ith water .
You should inspect the headlights regu larly (for example when refu­
eling) and clean off a ny solid dirt o r insects from the lenses. To ensure the system works properly in winter, keep the washer jets
free o
f snow and remove any ice using a de- ic ing spray. •
Service position
The wiper blades can only be changed in the service posi ­
tion.
- At below freezing outside temperatures, make sure first
that the wiper blades are not frozen to the windshield .
- Select: Function b utt on
I CAR ]> System s > Windshield
wipers .
- Select Serv ice position on t o tu rn th e service position on
or
off to return t he windsh ield w iper to its or ig inal pos i­
tion.
You must only attempt to change the wiper b lades when the service
position is act ivated. This way, when you are working on the wind­
shield wipe rs, you can avoid damaging the paint on the engine hood.
[ i ] Tips
• You can also turn on the se rvice position, for examp le, if you want
to protect the windshield from ic ing, using a cover .
• T he service position t urns itself
off , whenever yo u use the w ind­
shield wiper lever .•

Installing new wiper blades
Wiper blades in good condition help keep the windshield
clear .
Removing a wiper blade
Fig. 68 Rem ov in g th e
wi per bla des
F ig . 69 Installi ng
wip er b lad es
- Bring the windshield wipers to the se rvice posi tion
~ page 72.
- Lift the wiper arm away from the windshield .
- Push the locking piece on the wiper blade in the direct ion
of t he arrow @~ fig . 68 . Ho ld the wipe r blade firmly.
- Remove the w iper blade@.
Con tro ls a nd e quip ­
m en t Vehicle
OP-eration
Clear vision
Installing wiper blade
- Place the new wiper b lade in th e retaine r on the wiper arm
@ ~fig. 69.
- Push the locking piece on the wiper blade in the direction
o f the arrow ® until you feel it click into place on the
wrper arm.
Clean your wiper blades regular ly with a windshie ld washer so lution
to p revent streaking.
If the b lades are very dirty, for example wi th
insects, carefu lly clean the blades with a sponge or a soft brush .
If the w iper blades begin to streak the w indshield, this could be
caused by res idue left on the windsh ie ld by au tomatic car washes .
Fill the windshie ld washer container with a specia l solution availab le
a t you r author ized A udi dealer to remove the res idue.
& WARNING
Be sur e to in spe ct the conditi on of your wiper blades regularly . See
your authorized Audi de ale r for replacement blades .
0 Note
To prevent damage to the wiper system:
• Always loosen blades wh ich are frozen to the wi ndshield before
operating wipers.
• Do not use gasoline , ke rosene, paint th inner, or ot her solvents on
or near the wiper blades .
• Do not at tempt to move the w ipers by hand.
[I] Tips
Commercial hot waxes applied by automatic car washes affect the
cleanability of the windshield. •
Vehicle care Do-it-yourselt service iTechnical data

___ A_ l_. p_ h_a _b_ e_ t_ic _a_ l _ in_ d_e _ x ____________________________________________ _
u
Undercoating ...... ... ... ..... ..... 276
Unfastening safety be lts ............. 203
Unidi rect ional tires . .. .. .. .. .... ..... 306
Uniform tire quality grading . ........ . 322
Unlocking Power locking switch . ... .......... 45
Rear lid/trunk lid . ... .............. 46
Remote control . .. .. .. .. .... ...... 43
Using the key ........ .... .. .. .. .. . 44
V
Cruise control ... ... ...... .. .. .. . . 19 Wheel bolts
Electromechanical parking brake .... . 20 Torque .............. ... .. .. .. .. 32S
Electronic power control ........ .. .
16 Wheels . ... .. .. .. .. ........ ... .. .. 306
Electronic stabilization program (ESP) 16
Fog lights .... .... ............... 17
Generator .. .. .... ....... ...... .. 16
H igh beam ............... .. .. .. .. 17
Instrument cluster .... .... ........ 10
Malfunction Indicator Lamp (MIL) . ... 18
Rear fog lights ...... .... . .. .... .. 17
Safety belt ............... .. .. .. .. 18
Tire pressure monitoring system ..... 17
Turnsignals . .. .... ....... ...... .. 17
Wa rranty coverages .......... .. .. .. . 361 Cast alloy
....................... 27S
Checking tire pressure ............ 313
Cold tire inflation pressure .. .. . ... 310
General notes ....... .. .... .... .. 306
Glossary of tire and loading terminology .
307
New tires and wheels ...... ..... .. 318
Tires and vehicle load limits ...... . .
When must a safety be lt be replaced? .. 314
200
When must the airbag system be inspected? .
217
Vanity mirror 68 Washer reservoir
...... .... .... .. .. . 30S When should I adjust the tire pressures? 314
When should I check the tire pressures? 314
Where are lower anchorages located? .. 245
Where can I find the tire pressures for my car?
rear
.. ...... .......... .......... 70
Veh icle electr ical system .. .. .. ... ..... 16
Vehicle identification label ........... 356
Vehicle Identification Number (VIN) ... 356
Vehicle jack .............. .... .. 333, 338
Vehicle literature ................ ..... S
Vehicle transport ................ ... 353
Vehicle-care products ............ ... 270
Ventilated seats 107
vv
Warning/indicator lights .. .... ........ 14
Adaptive Air Suspension ............ 18
Adaptive Cruise Control ......... .. 13S
Airbag system ... ....... ....... ... 17
Anti-lock brake system (ABS) ........ 19
Brake system ............. ... .. .. . 20 Washing .
... .................... .. 270
Automati c car wash ....... .. ..... 2 71
by hand ....... .... .. .. .... .. ... 271
with a power washe r ............. . 272
313
Washing the vehicle ................. 270 Why safety belts? ........ . .. ... . 197, 198
Waxing ..................... ... .. . 273 Windows
Wear indicator .............. ...... . 317 Cleaning ........... .. .... .... .. 274
Weatherstrips . .. ........... ...... . 275 Convenience open feature ......... . 56
Weights .. ................. .. .... . 357 Defogging . .. .. .... ............. 109
What happens if you wear your safety belt too
loose? ............ ... ......... 202
What happens to unbelted occupants? . 199
What impairs dr iv ing safety? ......... . 187
What should I do after changing a wheel? .. .
314
What should I do after replacing wheels? 314 Defrosting .
.. .. ................. 109
Rapid defrosting/defogging ... .. ..
111
Windshield defogger/defroster
Windshield washer fluid 112
Low level ....... .. .. .. .. .. .. .. .. . 33
Windshield wipers Installing new wiper blades .... .. .. . 73
Intermittent wip ing ............... 70
One -tap wiping ................. .. 70

___________________________________________ A_ l::.. p _h _a_ b_ e_t _ic _a_ l_ in_ d _ e_x __ _
Rain sensor .... ..... .. ... .. .. .. .. 70
Service position .................. . 72
Was he r r eservo ir ............. ... . 305
Wi nter driving
Windows . .. ................. .. . 274
Wi nte r ope ra tion
Batte ry ............ .. .. .. .. .... . 30 0
Cooling system ... ..... ... ... ... . 2 96
Steering wheel heat ing .... ... .. .. . 108
T ir es ... ... .. .. .. .. .. .. .. .. ... .. 257
W inte r tir es .. .. .. ............... .. . 3 23
All-whee l dr ive . ............... .. . 3 23
Wiper blades
See Windshie ld w ipers ............ . 73
X
Xenon-Lights ... ....... ... .. .... ... . 346
y
Yellow symbols ................. ... .. 32
Controls and equip­
ment Safety first Vehicle operation
Vehicle care Do-it-yourself service Technical data