85
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
CONTROLS
HAZARD WARNING LIGHTS fig. 50
Press A switch to switch on/off the lights.ŸandΔwarning
lights come on and the A switch will flash when the lights are
on.
fig. 50A0K0093m
The use of hazard lights is governed by the High-
way Code of the country you are in. Keep to the
rules.
Emergency braking
In the event of emergency braking the hazard warning lights are
lit up automatically along with the
ŸandΔwarning lights on
the instrument panel. The lights are switched off automatically
when the nature of braking changes.
FRONT FOG LIGHTS fig. 51
(for versions/markets, where provided)
Press
5button to switch on/off the lights. Press the button again
to turn the lights off. The
5warning light on the instrument pan-
el and the LED on the button itself will light up when the lights
are on.
REAR FOG LIGHTS fig. 51
Press4button to switch on/off the lights. The rear fog lights
are only enabled with the dipped beam headlights on. Press the
button again to turn the lights off or turn off the dipped beam head-
lights and/or the front fog lights (for versions/markets, where pro-
vided).
4warning light on the instrument panel and the LED over
the button itself will light up when the lights are on.
fig. 51A0K0120m
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 85
110
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
VDC SYSTEM
(Vehicle Dynamics Control)
This is an electronic system that controls vehicle stability in the
event of tyre grip loss, helping maintain directional control. The sys-
tem is capable of recognising potentially dangerous situations in
terms of the stability and intervenes automatically on the brakes
in a differentiated manner for the four wheels in order to provide
a stabilizing torque.
The VDC, in turn, includes the following systems:
❍Hill Holder
❍ASR
❍Brake Assist
❍MSR
❍CBC
❍“ELECTRONIC Q2” (“E-Q2”)
❍DST
❍RAB
SYSTEM INTERVENTION
This is signalled by warning lightáblinking on the instrument
panel to inform the driver that stability and grip conditions are
critical.
SYSTEM ACTIVATION
The VDC system switches on automatically each time the engine
is started and cannot be switched off.
HILL HOLDER SYSTEM
This system is an integral part of the VDC system and it is provided
to facilitate starting on slopes.
It is activated automatically in the following instances:
❍uphill: car standing on a road with a gradient of more than 5%,
engine on, brake pedals pressed and gearbox in neutral or gear
(other than reverse) engaged;
❍downhill: car at a standstill on a road with a gradient higher
than 5%, engine running, brake pedal pressed and reverse gear
engaged.
When setting off the VDC system control unit maintains the brak-
ing pressure at the wheels until the engine torque required for de-
parture is reached or for approximately 2 seconds, allowing your
right foot to be moved easily from the brake pedal to the acceler-
ator.
If the car does not start off after this time, the system will deacti-
vate automatically by gradually releasing the brake force. A noise
may be heard: this means that the car is about to start moving.
IMPORTANT the Hill Holder system should not be used as a hand-
brake. Do not leave the vehicle without having engaged the hand-
brake, switched off the engine and engaged a gear.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 110
121
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
EOBD SYSTEM
(European On Board Diagnosis)
(for versions/markets, where provided)
The aim of the EOBD (European On Board Diagnosis) system is to:
❍to monitor system efficiency;
❍indicate an increase in emissions;
❍to warn of the need to replace deteriorated components.
The car also has a diagnostic connector that can be interfaced
with appropriate tools, which makes it possible to read the error
codes stored in the electronic control units together with a series
of specific parameters for engine operation and diagnosis. This
check can also be carried out by the traffic police.
IMPORTANT After eliminating a fault, to check the system com-
pletely, Alfa Romeo Authorized Services are obliged to run tests
and, if necessary, road tests which may also call for a long journey.
DUAL PINION ACTIVE STEERING
This only operates with the key turned to MAR and the engine start-
ed. The steering allows the force required at the steering wheel
to be adjusted to suit driving conditions. The different power as-
sistance modes can be selected via the d,n,a positions of the"Alfa
DNA System" lever (see paragraph entitled "Alfa DNA System").
IMPORTANT The steering system will need to be initialised after
disconnecting the battery. A warning light will come on to indicate
this. Simply turn the steering wheel all the way from one end to the
other or simply drive in a straight line for a few hundred metres.
Under no circumstances should aftermarket op-
erations be carried out involving steering system
or steering column modifications (e.g. installation
of anti-theft device). This could negatively affect perfor-
mance and safety, invalidate the warranty, cause serious
safety problems and also result in non-compliance of the
car with type-approval requirements.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 121
125
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
DISPLAY INDICATIONS
(for versions/markets, where provided)
When the sensor is activated, the "Reconfigurable multifunctional
display" (for versions/markets where provided) shows the screen
illustrated in fig. 88a; the information about the presence of and
distance from the obstacle is given by the buzzer and also by a
visual indication on the instrument panel display. If there are se-
veral obstacles, the closest one is indicated.
BUZZER WARNINGS
When reverse gear is engaged a buzzer warning is automatically
activated if there is an obstacle within the range of operation.
The acoustic signal:
❍increases as the distance between the car and the obstacle de-
creases;
❍becomes continuous when the distance between the car and
the obstacle is less that 30 cm and stops immediately if the
distance increases;
❍remains constant if the distance between the vehicle and the
obstacle remains unchanged, whilst if this situation occurs for
the side sensors, the signal is interrupted after about 3 seconds,
for example, to prevent signals in the case of manoeuvres along-
side walls.
IMPORTANT The volume of the audible signal can be adjusted th-
rough the option "Warnings volume" of the "Set-Up menu".
OPERATION WITH TRAILER
Parking sensor operation is automatically turned off when the trail-
er electric cable plug is fitted into the car tow hook socket. The sen-
sors are automatically enabled again when the trailer cable plug
is removed.
The sensor must be free of mud, dirt, snow or ice
in order for the system to work. Be careful not to
scratch or damage the sensors while cleaning them.
Avoid using dry, rough or hard cloths. The sensors should
be washed using clean water with the addition of car sham-
poo if necessary. In washing stations, clean sensors quick-
ly keeping the vapour jet/high pressure washing noz-
zles at a distance of at least 10 cm from the sensors.
fig. 88aA0K0059m
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 125
126
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
GENERAL WARNINGS
During parking manoeuvres, pay the utmost attention to any ob-
stacles that could be located above or below the sensors.
Sometimes, objects located close to the rear part of the car may
not be detected by the system and may damage the car or become
damaged themselves.
The ultimate responsibility when parking and car-
rying out other dangerous manoeuvres still rests
with the driver. When carrying out such manoeu-
vres, always ensure that the manoeuvring area is free
of people (particularly children) and animals. Parking sen-
sors are designed to assist drivers; however, you must al-
ways concentrate fully during potentially dangerous ma-
noeuvres, even if carried out at low speeds.
Here below are some conditions that may influence the perfor-
mance of the parking system:
❍Reduced sensor sensitivity and a reduction in the parking as-
sistance system performance could be due to the presence on
the surface of the sensor of: ice, snow, mud, thick paint.
❍the sensor may detect a non-existent obstacle (echo noise) due
to mechanical noises, for example when washing the vehicle,
in case of rain, strong wind, hail.
❍the signals sent by the sensors can also be altered by the pres-
ence of ultrasound devices (e.g. pneumatic brake systems or
pneumatic drills) near the car;
❍sensor performance can also be influenced by the position of
the sensors. For example by a change in the ride setting (caused
by the wear of the shock absorbers, suspension), overloading
the car and carrying out specific tuning operations that require
thecartobelowered;
❍the detection of obstacles at the top part of the vehicle may
not be guaranteed because the system detects obstacles that
could cause an impact with the vehicle in the bottom part.
For repainting the bumpers or retouching the paint-
work around the sensors contact Alfa Romeo
Authorized Services. Incorrect application of paint
may compromise the operation of the parking sensors.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:34 Pagina 126
133
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
SBR SYSTEM
(Seat Belt Reminder)
This system comprises of an acoustic signal, which in conjunction
with the
been fastened.
fig. 95A0K0075m
On some versions there is also a panel (provided as an alternative
to the warning lights on the instrument panel) located above the
rear-view mirror fig. 95, which warns the front and back seat pas-
sengers via acoustic and visual signals if their seat belts have not
been fastened.
Contact Alfa Romeo Authorized Services to deactivate this system
permanently. The SBR system can only be reactivated via the dis-
play Set Up Menu (see chapter “Knowing your car”).
The red and green warning lights work as follows fig. 95:
❍1 = front left seat (this indicates the driver’s seat state in left-
hand drive versions)
❍2 = rear left seat (passenger)
❍3 = rear middle seat (passenger)
❍4 = rear right seat (passenger)
❍5 = front right seat (this indicates the passenger seat state in
right-hand drive versions)
131-150 Alfa Giulietta EN 4ed 27-04-2010 11:15 Pagina 133
134
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
Front seats (warning light no. 1 = driver and
no. 5 = passenger)
Driver
If the driver is the only occupant and the seat belt is not fastened,
when 20 km/h is exceeded or when travelling at a speed from 10
to 20 km/h for longer than 5 seconds, an acoustic signal sequence
will be started (front seats) consisting of a tone for 6 seconds fol-
lowed by a 90 second beep. The warning light will blink. Once the
cycle is complete, the warning lights stay on with a fixed light un-
til the car is turned off. The acoustic signal will be interrupted im-
mediately when the driver’s seat belt is fastened and the warning
light will turn green.
If the seat belt is again unfastened when the car is in motion, the
acoustic signal and the red warning light blinking resume as de-
scribed previously.
Passenger
A similar solution applies for the front passenger, with the differ-
ence that the warning light turns green and the signal is interrupted
also when the passenger leaves the car.
If both front seat belts are unfastened with the car in motion a few
seconds apart, the acoustic signal will refer to the most recent event
while the two warning lights will issue a visual signal independently.
Rear seats (warning light no. 2, no. 3
and no. 4)
The signalling cycle is run only when any rear seat belt is unfas-
tened (blinking red). In this condition, the warning light referred
to the seat belt which has been unfastened will start blinking (red)
for approximately 30 seconds. An acoustic signal will also sound.
The visual signal (blinking red) will start and end independently for
each warning light if several seat belts are unfastened. The visual
signal will turn green after the corresponding seat has been fas-
tened.
The rear seat warning lights will go out, regardless of the state of
the belt (red or green) approximately 30 seconds after the last sig-
nal.
WARNINGS
All warning lights will remain off if all the seat belts (front and rear)
are already fastened when the key it turned to MAR.
All the warning lights will come on when at least one belt changes
from fastened to unfastened status or vice versa.
131-150 Alfa Giulietta EN 4ed 27-04-2010 11:15 Pagina 134
142
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
Main safety rules to be followed
when carr ying children:
❍install the child seats on the rear seat, which is the most pro-
tected position in the event of an accident.
❍when the passenger front air bag is deactivated always check
that the
Fwarning light remains permanently lit to confirm
the deactivation;
❍carefully follow the instructions supplied with the child seat,
which are mandatory by law. Keep the instructions in the car
along with the other papers and this handbook. Do not use
child seats without instructions;
❍always check the seat belt is well fastened by pulling the belt;
❍only one child is to be strapped to each retaining system;
❍always check the seat belts do not rest around the child’s neck;
❍while travelling, do not let the child sit incorrectly or release the
belts;
❍Never carry children on your lap, even newborns. No-one could
hold on to a child in the event of an accident;
❍In the event of an accident, replace the child seat with a new
one.
131-150 Alfa Giulietta EN 4ed 27-04-2010 11:15 Pagina 142