18
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
Rain sensor fault
(for versions/markets where provided)
On some versions, a message + symbol will be shown
on the display if a dusk sensor fault is detected.1
Possible presence of ice on the road
On versions equipped with reconfigurable multifunc-
tion display, a message + symbol will appear when
the outdoor temperature falls to or below 3°C.
On versions with multifunctional display, only the message is shown.
IMPORTANT In the event of outdoor temperature sensor fault, dash-
es are shown on the display instead of the value.√
Fuel cut-off
On some versions the display will show a message +
symbol if the fuel cut-off trips. For the fuel cut-off sys-
tem reactivation procedure see paragraph “Fuel cut-off
system” in this chapter.s
Exterior lights fault
On some versions, a message + symbol will appear
on the display if a fault is detected in one of the fol-
lowing lights:
– daytime lights (DRL)
– sidelights/taillights
– direction indicators
– rear fog lights
– number plate lights.
The fault relating to these lights could be: one or more blown bulbs,
a blown protection fuse or a break in the electric connection.W
Brake lights fault
On some versions, a message + symbol will appear
on the display if a brake light fault is detected. The
fault may be caused by a blown bulb, a blown protec-
tion fuse or an interruption of the electric connection.T
Boot open
On some versions, a message + symbol on the dis-
play are shown when the boot is open.R
Bonnet open
On some versions, a message + symbol on the display
are shown when the bonnet is open.S
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 18
20
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
DISPLAY
The car may be equipped with a multifunction display/ multi-
function reconfigurable display which, in accordance with the set-
tings made, can display useful information when driving.
With the ignition key removed, the display lights up and shows the
time and total odometer reading (in km or miles) for a few sec-
onds when a door is opened/closed.
MULTIFUNCTION DISPLAY “STANDARD”
SCREEN fig. 6
The following information is shown on the display:
A. Date
B. Odometer (distance covered in km or miles)
C. Driving mode selected using “Alfa DNA” (dynamic control sys-
tem) (for versions/markets, where provided)
– d = Dynamic
– n = Normal
– a = All Weather
D. Time (always displayed, even with the key extracted and the
front doors closed)
E Start&Stop function indicator (for versions/markets, where
provided)
F. Outside temperature
G Gear Shift Indicator (for versions/markets where provided)
H. Headlight alignment position (dipped headlamps on only)
fig. 6A0K1222g
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 20
23
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
WELCOME MOVEMENT
On some versions, the following occurs when the key is turned to
MAR:
❍quick movement (up and down) of the speedometer and rpm
gauge;
❍illumination of graphic symbols/display;
❍an animated graphic representation of the vehicle profile ap-
pears on the display.
Gauge movement
❍If the key is removed from the ignition switch whilst the gauges
are moving, they immediately return to their initial position.
❍Once they have reached the end-of-scale values the gauges rest
on the value indicated by the car.
❍The movement of the gauges stops when the engine is started.
Illumination of graphic symbols/display
A few seconds after the key is inserted, the gauges, graphic sym-
bols and display light up in sequence.
Graphic animation display
When the key is removed from the ignition switch (with the doors
closed), the display remains lit up and shows a graphic animation.
The display illumination is then dimmed gradually until it goes
out completely.
CONTROL BUTTONS fig. 10
Ò▲: To scroll up the screen and the menu options or increase the
displayed value.
“SET ESC”: Briefly press to access the menu and/or go to the next
screen or confirm your choice. Hold down to go back
to the standard screen.
▼: To scroll down the screen and the menu options or decrease
the displayed value.
IMPORTANT Buttons “
Ò▲“and“▼“ activate different func-
tions in the following situations:
❍to scroll the menu options upwards and downwards;
❍to increase or decrease values during settings.
fig. 10A0K0094m
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 23
24
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
The menu includes the following items:
–MENU
– SPEED BEEP
– HEADLIGHT SENSOR (for versions/markets, where provided)
– RAIN SENSOR (for versions/markets where provided)
– ON/TRIP B DATA
– SET TIME
–SETDATE
– FIRST PAGE (for versions/markets where provided)
– SEE RADIO
–AUTOCLOSE
– MEASURES
–LANGUAGE
– ALERTS VOLUME
– BUTTONS VOLUME
– SEAT BELT REMINDER
– SERVICE
– PASSENGER AIR BAG
– DAY LIGHTS
– COURTESY LIGHTS
–MENUEXIT
NOTE Some menu items are shown on the navigator display in mod-
els equipped with radio-navigation systems (for versions/markets,
where provided).SETUP MENU
The menu comprises a series of items which can be selected us-
ing the “
Ò▲“and“▼“ buttons to access the different se-
lection and setting operations illustrated in the following paragraphs.
Some items also have a sub-menu.
The menu can be activated by briefly pressing the SET ESC but-
ton.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 24
27
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
Headlight sensor (Automatic headlight/dusk
sensor sensitivity adjustment)
(for versions/markets, where provided)
This function is used to turn the headlights on or off according to
external lighting conditions.
The dusk sensor sensitivity can be adjusted according to 3 levels
(level 1= minimum sensitivity, level 2= average sensitivity, level
3= maximum sensitivity); the greater the sensitivity set, the less
the external light variation needed to control turning on the lights
(e.g. with a setting on level 3 at sunset the headlights are expected
to come on in relation to levels1 and 2).
Proceed as follows to set:
– briefly press SET ESC: the previously set brightness level flash-
es in the display;
– press “
Ò▲“or“▼“ to select;
– briefly press the SET ESC button to go back to the menu screen
or hold the button down to go back to the standard screen with-
out saving.
Rain sensor (sensitivity adjustment)
(for versions/markets where provided)
This function is used to adjust the rain sensor sensitivity to four
levels.
To set the required sensitivity level, proceed as follows:
– briefly press SET ESC button: the previously set sensitivity level
will flash on the display;
–press“
Ò▲“or“▼“toselect;
– press the SET ESC button to go back to the menu screen or
hold the button down to go back to the standard screen without
saving.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 27
34
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
Front passenger air bag and side bag
(Chest/pelvis protection)
Activation/Deactivation
This function is used to activate/deactivate the passenger air bag.
Proceed as follows:
– press SET ESC and, after the message Bag pass: Off (to deac-
tivate) or Bag pass On (to activate) is displayed by pressing
“
Ò▲“ buttons and “▼“ , press SET ESC again;
– the confirmation request message appears in the display;
– press “
Ò▲“or“▼“ to select Yes (confirming activa-
tion/deactivation) or No (to cancel);
– briefly press SET ESC button to confirm the setting and go back
to the menu screen or hold the button down to go back to the stan-
dard screen without saving.
Day Lights (DRL)
With this function is possible to turn the day lights on and off.
Proceed as follows to switch this function on or off:
– briefly press the SET ESC button to display a submenu;
– briefly press the SET ESC button again: the display flashes On
or Off depending on what was previously set;
–press“
Ò▲“or“▼“ button to select;
– briefly press SET ESC button to go back to the submenu screen
or hold the button down to go back to the main menu without
saving.
– hold down SET ESC button again to go back to the standard
screen or main menu, depending on which point in the menu you
have reached.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 34
35
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
Courtesy lights
(courtesy lights activation/desactivation)
(for versions/markets, where provided)
With this function is possible to turn on the side lights, the num-
ber plate lights and the ceiling lights for approximately 25 seconds
when the doors or boot are opened using the remote control, with
the following exceptions:
❍interruption after 5 seconds after closing a door
❍interruption after locking operation using the remote control
❍interruption following any operation using the remote control
Proceed as follows to turn the function on/off:
– briefly press SET ESC button: “On” or “Off” will flash on the dis-
play (according to previous setting);
– press “
Ò▲“or“▼“ to select;
– briefly press the SET ESC button to go back to the menu screen
or hold the button down to go back to the standard screen with-
out saving.
Exit menu
This function closes the settings listed on the menu screen. Briefly
press SET ESC button to go back to the standard screen without
saving. Briefly pressing
▼button the display will go back to the
first menu item.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 35
40
GETTING
TO KNOW
YOUR CAR
SAFETY
STARTING
AND DRIVING
IN AN
EMERGENCY
SERVICING AND
MAINTENANCE
TECHNICAL
SPECIFICATIONS
CONTENTS
SYMBOLS
Some components of the car have coloured labels whose sym-
bols indicate precautions to be observed when using this compo-
nent. Under the bonnet there is also a label that summarises all
the symbols.
ALFA ROMEO CODE SYSTEM
This is an electronic engine locking system which increases pro-
tection against attempted thefts of the car. It is automatically ac-
tivated when the ignition key is extracted.
Each key contains an electronic device which modulates the sig-
nal emitted during ignition by an antenna built into the ignition de-
vice. This signal is the ‘password’ which changes at each ignition
and which the control unit uses to recognise the key and enable
ignition.
OPERATION
The Alfa Romeo CODE system control unit sends an acknowl-
edgement code to the engine management control unit to deacti-
vate the inhibitor each time the car is started by turning the igni-
tion key to MAR.
The code is sent only if the Alfa Romeo CODE system control unit
has recognised the code transmitted from the key.
Each time the ignition key is turned to STOP, the Alfa Romeo
CODE system deactivates the functions of the engine management
control unit. Warning light
Ylights up on the instrument panel
if the code is not correctly recognised during ignition.
In this case, turn the key to STOP and then to MAR; if it is still
locked, try again with the other keys that come with the car. If you
are still unable to start the engine contact Alfa Romeo Authorized
Services.
001-130 Alfa Giulietta EN 5ed 26-07-2010 16:33 Pagina 40