2010 Acura TSX under the hood

Reach in between the hood and
the f ront grille with your f ingers.
The hood latch handle is above
the ‘‘A’’ logo. Push this handle up
to the right until it releases the
hood. Lif t the hood.
Park the vehicle, and set the
parking brake. Pull the hood
release handle located under the
lower lef t corner of the dashboard.
The hood will pop up slightly. If the hood latch handle moves stif f ly,
or if you can open the hood without
lif ting the handle, the mechanism
should be cleaned and lubricated.
2.
1.
Service Station Procedure
Opening and Closing the Hood
350
LATCH
HOOD RELEASE HANDLE
2010 TSX

Remove the oil drain bolt and
washer from the bottom of the
engine. Drain the oil into an
appropriate container.
Always change the oil and f ilter
according to the maintenance
messages shown on the multi-
inf ormation display. The oil and f ilter
collect contaminants that can
damage your engine if they are not
removed regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
technician.
Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood and remove the
engine oil f ill cap. Remove the bolts located on the
underside of the body with a
wrench, then remove the under
cover.
2. 1. 3.
4.
CONT INUED
4-cylinder models
Changing the Engine Oil and Filter
Maint enance
417
WASHER
OIL DRAIN BOLT
BOLT UNDER COVER
4-cylinder models 4-cylinder models
2010 TSX

If the temperature gauge stays at
the red mark, turn of f the engine.
Look f or any obvious coolant leaks,
such as a split radiator hose.
Everything is still extremely hot,
so use caution. If you f ind a leak, it
must be repaired bef ore you
continue driving (seeon page ).
If you do not see steam or spray,
leave the engine running and
watch the temperature gauge. If
the high heat is due to overloading,
the engine should start to cool
down almost immediately. If it
does, wait until the temperature
gauge comes down to the midpoint,
then continue driving.
The pointer of the vehicle’s
temperature gauge should stay in
the midrange. If it climbs to the red
mark, you should determine the
reason (hot day, driving up a steep
hill, etc.).
You will also see a ‘‘WATER TEMP
HOT’’ message on the multi-
inf ormation display (see page ).
If your vehicle overheats, you should
take immediate action. The only
indicationmaybethetemperature
gauge climbing to or above the red
mark. Or you may see steam or
spray coming f rom under the hood.
Saf ely pull to the side of the road.
Put the transmission in neutral
(manual) or Park (automatic), and
set the parking brake. Turn of f all
accessories, and turn on the
hazard warning lights.
If you see steam and/or spray
coming f rom under the hood, turn
of f the engine. Wait until you see
no more signs of steam or spray,
then open the hood.
1.
2. 3.
4.
5.
69
482
CONT INUED
Emergency
Towing
If theEngineOverheats
T aking Care of t he Unexpect ed
469
Steam and spray from an
overheated engine can
seriously scald you.
Do not open the hood if steam
is coming out.
Driving with the temperature gauge
pointer at the red mark can cause
serious damage to the engine.
2010 TSX

The vehicle’s f uses are contained in
threefuseboxes.
Thedriver’ssideinteriorfuseboxis
under the dashboard on the driver’s
side. The fuse label is attached to the
side panel.The passenger’s side interior f use
box is on the lower passenger’s side
panel. To remove the f use box lid,
put your f inger in the notch on the
lid, and pull it upward slightly, then
pull it toward you and take it out of
its hinges.The under-hood f use box is on the
driver’s side. To open it, push the
tabs as shown.
CONT INUED
Fuses
T aking Care of t he Unexpect ed
475
INTERIOR (Driver’s side)
NOTCHINTERIOR (Passenger’s side)
UNDER-HOOD
FUSE BOX
FUSE LABEL TAB
4-cylinder models
2010 TSX

Check each of the large f uses in
the under-hood f use box by
looking at the wire inside.
Removing these f uses requires a
Phillips-head screwdriver.
If something electrical in your
vehicle stops working, the first thing
youshouldcheckforisablownfuse.
Determine f rom the chart on pages
, and , or the diagram on
thefuseboxlidorthefuselabel,
which f use or f uses control that
component. Check those f uses f irst,
but check all the f uses bef ore
deciding that a blown f use is not the
cause. Replace any blown f uses and
check if the device works.
Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are of f .
On the under-hood and passenger’s
side interior f use boxes, remove
the cover f rom each f use box. 3.
1.
2. 479 480 481
Checking and Replacing Fuses
Fuses
476
FUSE
BLOWN
UNDER-HOOD
TAB
6-cylinder models
2010 TSX

CONT INUED
Look f or a blown wire inside the
fuse.If itisblown,replaceitwith
one of the spare f uses of the same
rating or lower.
Check the smaller f uses in the
under-hood f use box and all the
fuses in the interior fuse boxes by
pulling out each one with the f use
pullerprovidedonthebackof the
under-hood f use box cover.
Also check the combined f use box in
the under-hood f use box.
5.
4.
Fuses
T aking Care of t he Unexpect ed
477
BLOWN
FUSE PULLER
BLOWN
2010 TSX

If the replacement fuse of the
same rating blows in a short time,
there is probably a serious
electrical problem with your
vehicle. Leave the blown fuse in
that circuit, and have your vehicle
checked by a qualif ied technician.
If you cannot drive the vehicle
without f ixing the problem, and you
do not have a spare fuse, take a fuse
of the same rating or a lower rating
f rom one of the other circuits. Make
sureyoucandowithoutthatcircuit
temporarily (such as the accessory
power socket).
If you replace the blown f use with a
spare f use that has a lower rating, it
might blow out again. This does not
indicate that anything is wrong.
Replace the f use with one of the
correct rating as soon as you can.
Your vehicle has spare fuses on the
back of the under-hood f use box
cover. 6.
Fuses
478
FUSE PULLER SPARE FUSES
Replacing a f use with one that has a
higher rating greatly increases the
chances of damaging the electrical
system. If you do not have a
replacement f use with the proper rating
f or the circuit, install one with a lower
rating.
2010 TSX

ÎÎ
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
Î
Î
µ
µ
µ
CONT INUED
Specif ications (4-cylinder Models)
Technical Inf ormation
489
Battery
Lights
Engine Fuses 12V 36AH/5HR
60W
12 V
12 V 35 W
Capacity
12 V 2 W 12 V 3.8 W
12 V 5 W12 V 8 W
12 V 8 W
12 V 5 W 12 V 3 CP
12 V 21 W
12 V 21 W
12 V 21/5 W
12 V 21 W 12 V 12 V 55 W 55 W
On vehicles with high voltage discharge type headlights,
replacement of a headlight bulb should be done by your dealer. 12 V
12 V 45 AH/20 HR
21/5 W
Headlights
Fog lights
Front turn signal/
Front parking lights/
Side marker lights
Rear turn signal lights
Stop/Taillights
High-mount brake light
Back-up lights
Rear side marker lights
License plate lights
Ceiling light
Spotlights
Trunk light
Door courtesy lights
Vanity mirror lights
SXU22HCR11S ILZKR7B-11S 11.0 : 1
144 cu-in (2,354 cm
)
3.43 x 3.90 in (87.0 x 99.0 mm) Water cooled 4-stroke, DOHC
i-VTEC 4-cylinder, gasoline engine
Type
BorexStroke
Displacement
Compression ratio
Spark plugs Interior
Under-hood 12 V 47 AH/20 HR
See page 480or the fuse label
attached on the side panel.
See page 481or the fuse label
attached to the inside of the fuse
box door.
See page 479or the fuse box
cover.
NGK:
DENSO:
Driver’s side
Passenger’s side
High
Low
(D2S)
(H1)
(H11)
Canadian TSX (HB3)
1:
2:
3 : If equipped
3 1
2
2010 TSX