2010 Acura TL navigation system

Getting Started
Navigation System17
NOTE:
The voice command names that can be used for each letter are shown below. For
additional keyboard symbols, see page 167 .
Say Or say “...” Say Or say “...” Say Or say “...” Say Or say “...”
AAlpha/Apple
HHotel/Henry
OOscar
VVictor
B Bravo /Boy
IIndia/Igloo
PPapa /Paul
W
Whiskey/William
CCharlie
JJuliet /John
QQuebec/Queen
XX-r ay
D Delta/Dog
KKilo/King
RRomeo / Rober t
YYa n k e e / Ye l l o w
E Echo/Edward
LLima/Larry
SSier ra / Sam
ZZulu/Zebra
F Foxtrot /Frank
MMike/Mary
TTa n g o / To m
E n t e r
G Golf/George
N
November/ NancyUUniform / Uncle
2010 TL

Getting Started
18 Navigation System

System Start-up
When you change the power mode to
the ON mode, it takes about 10 seconds
for the navigation system to boot up.
The fi rst screen to appear is the
navigation system globe screen.
The screen then changes to the
Disclaimer screen:
NOTE:
Driver information will display on the
upper right hand side of the screen.
If there are any unread messages, the
Message icon will display on the bottom
left hand side of the screen.
See page 20 .
System Language Selection
Move the Interface Dial to the right
to select CHANGE LANGUAGE. On
the Select a language screen, you
can select the language to be used by
the entire system by choosing from the
language choices that are displayed.
After you have changed the language
settings, you will be returned to the
Disclaimer screen.
Read this disclaimer carefully so you
understand it before continuing. Push
in on the Interface Dial to select OK,
and the map screen will appear on the
display. The “OK” cannot be activated
by voice. If you do not push in on the Interface
Dial
, the screen will go dark after 30
seconds. (You can also display the
Wallpaper screen. See page 116 .)
To return to the Disclaimer screen,
press any navigation or voice control
button.
2010 TL

Getting Started
Navigation System19
If you have entered any Calendar
reminders, they are displayed after you
select OK. See Calendar on page 85 .
The Calendar reminder screen
remains displayed until you select OK
or Remind Later by rotating the
Interface Dial knob and pushing in
on the Interface Dial , or press the
CANCEL button.
If you select OK and push in on the
Interface Dial , the reminder will not
show up again. (It will be deleted from
the Calendar.) If you select Remind Later and push
in on the Interface Dial
, the reminder
will show up again the next time you
start the vehicle. If there are several
reminders, the next reminder will be
displayed.
If you press the CANCEL button, the
system will skip all the reminders. The
reminders will show up again the next
time you start the vehicle.
NOTE:
The system will display the current
message and any older or previously
unread messages, with the newest
message appearing fi rst and the
remaining messages appearing in date
order.
If you turn off the engine during route
guidance and then restart the vehicle,
the Continue Trip to screen will be
displayed. For more information, see
Continue Trip to Screen on page 77 .
Bluetooth® HandsFreeLink®
If you have a Bluetooth-compatible cell
phone that is paired with the system,
then CALL on the Calculate route to
screen will be enabled.
When you select CALL, the system
dials the number shown on the screen.
For more information on Bluetooth®
HandsFreeLink®, see the vehicle
Owner’s manual and the offi cial website
( www.acura.com /handsfreelink ).
2010 TL

Getting Started
20 Navigation System

Map Screen Legend
Tr a f c Status Indicator
(See page 23
.)
Vehicle Position (see page
70
)
(Use voice command “Display
current location” or use the
Interface Dial to show current
location.)
Current Map Scale
(see page 61 )
Message Icon (see page 78
)
Indicates that you have an
AcuraLink message.
Warning Icon
Indicates that there are weather
warnings. To check the warning
list, see page 83 .
Current Street
(see page
6 )
Map Scale Adjustment
(Mile or km per half-inch appears only
when you zoom in or out by rotating the
Interface Dial knob .)
NOTE:
See Map Legend in the Map
Information on the MAP MENU
screen for further explanation.
Streets
(see Map Overview on page 6 )
: Freeways (Red)
: State Routes (Pink)
: Veri ed Streets (Gray)
: Unveri ed Streets (Purple)
: One-Way Streets (see page 63
)
(1/20 mile scale only)
Landmark Icon - Generic (see page 63
)
Honda Dealer (USA)
Honda Dealer (Canada)
HospitalAcura Dealer
Grocery StoreSchool
Gas StationRestaurant
Hotel/LodgingAT M
Parking GarageParking Lot
Freeway Exit
InformationPost Of ce
Map Features
ParkAirport/Business
HospitalBody of Water
Shopping MallCemetery
Golf Course/
StadiumUniversity
NOTE:
If you move the Interface Dial over
an area (map features shown above),
the name is displayed at the top of the
screen.
No Entry Icon
GPS Signal Strength
: Best Reception
: Good Reception
(Missing): Poor/No Reception
Map Orientation
(see page 62 )
“Heading Up” “North Up”
Map Menu
(see page 57 )
(Push in on the Interface Dial to view.)
“ Breadcrumbs”
(see
Off-road Tracking on page 69
)
2010 TL

Getting Started
Navigation System21
Map Screen Description
Zoom In / Out
Rotate the Interface Dial knob to
change the map scale. Zooming in
increases the detail, while zooming
out gives you a wide area view. After
changing the scale, give the system a
few moments to update the display.
Map Scrolling
To view other map areas, move the
Interface Dial left, right, up, or down.
The map will shift in that direction. To
return the map to your current location,
press either the MAP/GUIDE , the
CANCEL , or the BACK button.
Displaying Current Location
You can see the current address,
latitude, longitude, and elevation at any
time by doing one of the following:
• Use the voice control system and say
“Display the current location.”
• Push in on the Interface Dial
while displaying the map of the
current location, and select Map
Information . Rotate the Interface
Dial knob to select CURRENT
LOCATION .
The Current location screen will
appear on the display.
NOTE:
The elevation will not appear when the
system is temporarily lacking proper
GPS information. The system elevation
may not agree with elevations shown
on roadside elevation signs, and may
fl uctuate plus or minus 100 feet or
more.
You can save the current location in
your Address Book by doing one of the
following (if an Address Book PIN has
been set, you need to enter your PIN.):
• Use the voice control system and say “Save.”
• Select SAVE by rotating the
Interface Dial knob and push in on
the Interface Dial .
Say “Register the current location” on
the map screen, and you can register
the current location without displaying
the Current Location screen.
Select Return to return to the previous
screen.
2010 TL

Getting Started
22 Navigation System

Tr a f c Display Legend
Viewing Incident Details:
To view incident details, use the Interface
Dial to position the cursor (round red circle)
over an incident icon and push in.
Incident Icons
Accident / Incident (other)
ConstructionRoad Closed
WeatherCongestion
Incident Icon Update Details:
Typically M–F, 5:00 AM – 7:00 PM (varies by metropolitan area)
Continuously updated signal is received.
Map Scale
Traf c ow and incident icons are
displayed on the 5 mile (8 km) or
less map scale Hearing Incident Details:
If this screen is displayed, the system will
start reading incident details.
To view the message on the screen, push
in on the Interface Dial
.
To return to current position, press the
MAP/GUIDE button.
Tr a f c Flow Data
(colored lines parallel to road)
(red) Heavy traf c: 0 – 24 mph
(approx.)
(orange) Moderate traf c: 25 – 52 mph
(approx.)
(green)Free ow traf c: 53 + mph
(approx.)
(shown for both sides of the freeway where
available)
Tr a f c Flow Data Update Details:
Available 24 hours a day, 7 days a week

5 mi 1/20 mi
Scales
NOTE:
When driving to a destination on freeways that have traffi c fl ow data, the route line
is used to display moderate and heavy traffi c fl ow status instead of the colored bands
on the side of the road. The route line color indicates the following conditions:
• Free Flow Traffi c - A section of the blue route line will be bordered with a light
green line (this may be diffi cult to see).
• Moderate Traffi c Flow - A section of the route line will change from green to orange.
• Heavy Traffi c Flow - A section of the route line will change from green to red.
• Unknown Traffi c Flow - A section of the route will not be bordered with traffi c
fl ow.
2010 TL

Getting Started
Navigation System23

AcuraLink Real-Time
Tr a f c™
The navigation screen can display
continuously updated traffi c
information when available, including
fl ow (traffi c speed), accidents, and
construction on freeways in major
metro areas.
The display of traffi c fl ow and incidents
on your map screen is optional and
can be turned On/Off by selecting
the “Traffi c” icon on the Icon bar (see
Showing Icons on the Map on page 67 ).The current metropolitan areas that
have traffi
c coverage can be seen on
page 142 . For more current metro coverage
information, go to
www.acura.com /realtimetraffi c . This
link offers the following:
• The latest list of metro areas that have AcuraLink Real-Time Traffi c
coverage
• Detailed coverage information for each metro area showing what roads
have traffi c speed, traffi c icons, or
both
• An AcuraLink Real-Time Traffi c
demonstration
• Frequently asked questions (FAQs)
NOTE:
• AcuraLink Real-Time Traffi c relies on a satellite signal. It will not work
in Hawaii, Alaska, Canada, and
Puerto Rico.
• AcuraLink Real-Time Traffi c is only available if you have a current traffi c
subscription with XM
®. See page 120 .
Tr a ffi c Status Indicator
You can confi rm the reception status
of traffi c information (traffi c fl ow and
incidents). The “TRF” icon indicates
the following status:
Icon Status
Tra f fi c speed and incidents are
available.
Tra f fi c speeds or incidents are
not available.
Tra f fi c speeds and incidents are
not available.
• Traffi c display turned off.
• Traffi c not displayed on this
map scale.
Missing No traffi
c information available.
(Out of coverage area).
NOTE:
• Traffi c information can be turned on or off. See Showing Icons on the Map
on page 67 .
• Traffi c information can be displayed on the 5 miles (8 km) or more map
scale.
2010 TL

Getting Started
24 Navigation System

Viewing Flow Data
Tra f fi c fl ow data is displayed as colored
bands on either side of the freeway (see
Traffi c Display Legend on page 22 ).
The different colored bands represent
the average road speeds as determined
by under-road sensors and other probes.
While driving to your destination on
a road that has traffi c fl ow data, your
route line color is used to display the
traffi c fl ow data. This means that
when the map scale is set to one of
the traffi c scales (1/20 through 5 mile
scale), your blue route line may appear
as alternating orange, red, or green
segments (see Traffi c Display Legend
on page 22 ).
NOTE:
A blue route line segment on a freeway
can mean one of two things:
• Under-road sensors, GPS probes, cell phone probes, and other
methods used to collect traffi c speed
information indicate free-fl ow traffi c.
• The road has no sensors, and traffi c
conditions are unknown (they could
be congested). Naturally, only roads with these sensors
will show traffi
c information. The
amount of fl ow data varies considerably
from one city to another. This map
display is refreshed continuously.
You can only view traffi c information
from within 200 miles of the vehicle’s
location.
NOTE:
• Traffi c fl ow and incident icons are displayed on the 5 miles (8 km) or
less map scale.
• Not all freeways within a metropolitan area have traffi c fl ow
data (colored bands on the side of
the freeways) - this is normal, and
you cannot assume that a lack of
data implies no traffi c.
• Not all cities have traffi c fl ow information. See cities listed on page
14 2 .
• Due to freeway maintenance and construction, traffi c fl ow may be
available only for one side of a
road, or be missing entirely for some
portion of the freeway. • The displayed traffi c fl ow may
confl ict with other audio- or Internet-
based traffi c information.
• If traffi c fl ow is not showing, verify that the “TRAFFIC” selection for
the Icon Bar is ON, and that the icon
options for traffi c are both ON (see
page 67 ).
2010 TL