2010.5 Peugeot 508 Dag ECU

367
Comfort
Folding the seat from the
rear
Check that no object, either on or underneath the seat, could hinder its movement.
Returning the seat back to its original position
 Put the seat back in the upright position and secure it, the seat cushion also returns to its original position,  check that the red indicator, located at the
control 1 , is no longer visible,  refit the head restraints or put them back in place.
 Move the corresponding front seat for wards if necessary,  check that the seat belt is positioned correctly on the side of the seat back,
 place the head restraints in the low position or remove them if necessary,
 pull the control 1 for wards to release the seat backrest 2 then fold it for wards.
When returning the rear seat back to its original position, take care not to trap the seat belts and ensure that their buckles are positioned correctly.

72
!
Comfort
Mats
Removable carpet protection.
When fitting the mat for the first time, on the driver's side use only the fixings provided in the wallet attached. The other mats are simply placed on the carpet.
Fitting
Removal
To remove the mat on the driver's side:  move the seat as far back as possible,
 unclip the fixings,  remove the mat.
Refitting
To refit the mat on the driver's side:  position the mat correctly,  refit the fixings by pressing,  check that the mat is secured correctly.
To avoid any risk of jamming of the pedals: - only use mats which are suited to the fixings already present in the vehicle; these fixings must be used, - never fit one mat on top of another. The use of mats not approved by PEUGEOT may inter fere with access to the pedals and hinder the operation of the cruise control/speed limiter.
 Lower the rear armrest for a more comfor table position. It has cup holders and also gives access to the ski flap.
Rear armrest

72
!
Comfort
Mats
Removable carpet protection.
When fitting the mat for the first time, on the driver's side use only the fixings provided in the wallet attached. The other mats are simply placed on the carpet.
Fitting
Removal
To remove the mat on the driver's side:  move the seat as far back as possible,
 unclip the fixings,  remove the mat.
Refitting
To refit the mat on the driver's side:  position the mat correctly,  refit the fixings by pressing,  check that the mat is secured correctly.
To avoid any risk of jamming of the pedals: - only use mats which are suited to the fixings already present in the vehicle; these fixings must be used, - never fit one mat on top of another. The use of mats not approved by PEUGEOT may inter fere with access to the pedals and hinder the operation of the cruise control/speed limiter.
 Lower the rear armrest for a more comfor table position. It has cup holders and also gives access to the ski flap.
Rear armrest

76
Comfort
Luggage cover (SW)
To reel in To remove To install
 Gently push on the (PRESS) handle, the luggage cover reels in automatically. The moving par t A can be folded against the rear bench seat backrest.
Compress the control 1 and lift the luggage cover on the right then on the left to remove it.  Position the left-hand end of the luggage cover roller in its location B behind the rear bench seat.  Compress the roller control 1 and put the roller in place in its location C on the right.  Release the control to secure the luggage
cover.  Unreel it to its fastening on the rear pillar.

78
i
Comfort
High load retaining net (SW)
Hooked onto the special upper and lower fixings, this allows the use of the entire loading volume up to the roof: - behind the front seats (row 1) when the rear seats are folded. - behind the rear seats (row 2).
Never reposition the rear seats if the net's roller is attached to the backs of the folded seats.  position the net's roller above the two rails (located on the back of the folded rear seats),
 the two grooves a must be placed above the two rails b . Slide the two rails b in the grooves a and push the roller (lengthwise) from right to left to secure it,  check that the net is hooked and tightened correctly,
 fold the rear seats,  unroll the high load retaining net without stretching it,
 position one of the ends of the net's metal bar in the corresponding upper fixing 1 ,  pull the net's metal bar to position the other end in the other upper fixing 1 .
Row 1

148
i
Child safety
Passenger airbag OFF
For more information on deactivating the airbag, refer to the "Safety" section then "Airbags".
Child seats recommended by
PEUGEOT
PEUGEOT offers a complete range of recommended child seats which are secured using a three point seat belt :
Group 0+: from bir th to 13 kgGroup 1: from 9 to 18 kg
L1"RÖMER /BRITA X Baby-Safe Plus". Installed in the rear wards-facing position.
L2"RÖMER Duo Plus ISOFIX".
Groups 1, 2 and 3: from 9 to 36 kg
L3"KIDDY Life". The use of the restraining cushion is compulsory for the transpor tation of young children (from 9 to 18 kg).
Groups 2 and 3: from 15 to 36 kg
L4"RECARO Star t''.
L5"KLIPPAN Optima". From the age of 6 years (approximately 22 kg), the booster is used on its own.

6149
./..
Child safety
Installing child seats attached using the seat belt
In accordance with European regulations, this table indicates the options for installing child seats secur ed using a seat belt and universally approved (a) in accordance with the weight of the child and the seat in the vehicle.
Weight of the child and indicative age
SeatUnder 13 kg(groups 0 ( b ) and 0+) Up to approx 1 year
From 9 to 18 kg(group 1) 1 to 3 years approx
From 15 to 25 kg(group 2) 3 to 6 years approx
From 22 to 36 kg(group 3) 6 to 10 years approx
Front passenger seat ( c )with height adjuster U (R)U (R)U (R)U (R)
Front passenger seat (c)without height adjuster UUUU
Saloon
Outer rear seats UUUU
Centre rear seat XXXX
SW
Outer rear seats UUUU
Centre rear seat XXXX

150
Child safety
a: universal child seat, child seat that can be installed in all vehicles using a seat belt. b: group 0, from bir th to 10 kg. Shells seats and baby c arriers cannot be installed in the front passenger seat. c: consult the legislation in force in your country before installing your child on this seat. U: seat suitable for the installation of a child seat secured using a seat belt and universally approved, "rear wards-facing" and/or "for wards-facing". U (R): idem U , with the vehicle's seat adjusted to the highest position and as far back as possible. X: seat position not suitable for installation of a child seat for the weight class indicated.