2010.5 Peugeot 508 Dag parking brake

4117
!
Driving
Hill start assist
System which keeps your vehicle immobilised temporarily (approximately 2 seconds) when star ting on a gradient, the time it takes to move your foot from the brake pedal to the accelerator pedal. This system only operates when: - the vehicle is completely stationary, with your foot on the brake pedal, - in par ticular conditions on a slope, - with the driver’s door closed. The hill star t assist system cannot be deactivated.
On an ascending slope, with the vehicle stationary, the vehicle is held for a momentarily when you release the brake pedal: - provided you are in first gear or neutral on a manual gearbox, - provided you are in A or M on an electronic gear control gearbox, - provided you are in D or M on an automatic gearbox.
Operation
On a descending slope, with the vehicle stationar y and reverse gear engaged, the vehicle is held momentarily when you release the brake pedal.
Do not exit the vehicle while it is being held in the hill star t assist phase. If you need to exit the vehicle with the engine running, apply the parking brake manually then ensure that the
parking brake warning lamp (and the warning lamp P in the lever of the electric parking brake) are on fixed (not flashing).
Operating fault
If a fault in the system occurs, these warning lamps come on. Contact a PEUGEOT dealer or a qualified workshop to have the system
checked.

8179
i
Practical information
Removing a wheel
Parking the vehicle
Immobilise the vehicle where it does not block traffic: the ground must be level, stable and not slippery. Apply the parking brake unless it has
been programmed to automatic mode, switch off the ignition and engage first gear * to block the wheels. Check that the braking warning lamp and the P warning lamp in the parking brake control lever come on. The occupants must get out of the vehicle and wait where they are safe. Never go underneath a vehicle raised using a jack; use an axle stand.
List of operations
 Remove the bolt cover from each of the bolts using the tool 3 (according to equipment).  Fit the security socket 4 on the wheelbrace 1to slacken the security bolt (if fitted).  Slacken the other bolts using the wheelbrace 1 only.
* position R for the electronic gear control gearbox; P for the automatic gearbox.

9217
!
Checks
Manual gearbox
The gearbox does not require any maintenance (no oil change). Refer to the Warranty and Maintenance Record for the details of the level checking inter val for this component.
6-speed electronic gear
control gearbox
The gearbox does not require any maintenance (no oil change). Refer to the Warranty and Maintenance Record for details of the checking inter val for this component.
Automatic gearbox
The gearbox does not require any maintenance (no oil change). Refer to the Warranty and
Maintenance Record for details of the level checking inter val for this component.
Brake wear depends on the style of driving, par ticularly in the case of vehicles used in town, over shor t distances. It may be necessary to have the condition of the brakes checked, even between vehicle ser vices. Unless there is a leak in the system, a drop in the brake fluid level indicates that the brake pads are worn.
Brake pads
For information on checking brake disc wear, contact a PEUGEOT dealer or a qualified workshop.
Brake disc wear
Manual parking brake
If a loss of effectiveness of this system is noticed, the parking brake must be checked, even between
two ser vices. Checking this system must be done by a PEUGEOT dealer or a qualified workshop.
Electric parking brake
This system does not require any routine ser vicing. However, in the event of a problem, have the system checked by a PEUGEOT dealer or a qualified workshop. For more information, see "Driving - Electric parking brake - § Operating faults".
Only use products recommended by PEUGEOT or products of equivalent quality and specification.
In order to optimise the operation of units as impor tant as the braking system, PEUGEOT selects and offers
very specific products. To avoid damaging the electrical units, the use of a high pressure washer in the engine compar tment is strictly prohibited .