Page 2 of 119
FAMILIARISATION
OPEN
REMOTE CONTROL KEY
A. Locking the vehicle.
B. Unlocking the vehicle.
44
FUEL TANK
1. O p e n i n g t h e fi l l e r c a p .
Capacity of the tank: approximately
50 litres.
50 BONNET
A. Interior release lever.
B. Exterior safety catch.
C. Bonnet stay.
77 BOOT
- Unlock the vehicle using the remote
control.
- Operate the handle A to open.
49
Page 4 of 119
FAMILIARISATION
INSTRUMENTS AND CONTROLS
1. Speed limiter/cruise controls.
2. Steering wheel height adjustment
control.
3. Lighting and direction indicator
control stalk.
4. Instrument panel.
Instrument panel lighting dimmer.
5. Driver's airbag.
Horn.
6. Parking brake.
7. Front electric window controls.
8. Central locking control.
9. Bonnet release lever.
10. Fusebox.
11. Headlamp height adjustment.
12. Passenger's airbag deactivation.
13. Heated seats control.
14. ESP/ASR deactivation.
Page 5 of 119
FAMILIARISATION
1. Steering lock.
2. Audio system steering mounted
controls.
3. Wipers/screenwash/trip computer
control stalk.
4. Hazard warning lamps switch.
5. Multifunction screen.
6. Air conditioning and rear screen
and mirrors demist/defrost switch.
7. Audio system.
8. Cup holder.
9. Gear lever.
10. 12 V accessory socket.
11. Glove box.
INSTRUMENTS AND CONTROLS
Page 6 of 119
FAMILIARISATION
SITTING COMFORTABLY
FRONT SEAT ADJUSTMENTS
1. Forwards-backwards adjustment.
2. Head restraint height adjustment.
3. Seat back angle adjustment.
37
4. Access to the rear seats (3-door).
5. Height adjustment. STEERING WHEEL ADJUSTMENT
1. Releasing the adjustment mechanism.
2. Adjustment of height.
3. Locking the adjustment mechanism.
42
Page 10 of 119
FAMILIARISATION
MONITORING
1. When the ignition is on, the orange
and red warning lamps come on.
2. When the engine is running, these
warning lamps should go off.
If warning lamps remain on, refer to the
page concerned.
WARNING LAMPS
16
INSTRUMENT PANEL
A. When the ignition is on, the fuel
gauge needle should rise.
B. When the engine is running, the
associated low level warning lamp
should go off.
If the levels are not correct, top up as
required.
15 CONTROLS
A. Passenger's airbag deactivation.
63
B. Heated seats control.
37
C. ESP/ASR deactivation.
59
D. Central locking/unlocking.
48
Page 16 of 119
INSTRUMENTS and CONTROLS
Warning lamps
When the engine is running or the vehicle is being driven, the switching on of one of the following warning lamps indicates a
fault which requires action on the part of the driver.
Any fault resulting in the switching on of a warning lamp must be investigated further by reading the associated message on
the multifunction screen.
If you encounter any problems, do not hesitate to contact a PEUGEOT dealer.
Warning lamp is on Cause Action/Observations
STOP fi x e d ,
associated
with another
warning lamp. It is associated with the
braking, the engine oil pressure
or the coolant temperature.
Stop as soon as it is safe to do so.
Park, switch off the ignition and call a
PEUGEOT dealer.
Braking fi x e d ,
associated
with the STOP warning lamp. T h e b r a k i n g s y s t e m fl u i d l e v e l
is too low. You must stop as soon as it is safe to do so.
T o p u p w i t h b r a k e fl u i d r e c o m m e n d e d b y
PEUGEOT.
If the problem persists, have the system
checked by a PEUGEOT dealer.
+
fi x e d , a s s o c i a t e d
with the STOP and
ABS warning lamp. The electronic brake force
distribution (EBFD) system has
a fault. You must stop as soon as it is safe to do so.
Have it checked by a PEUGEOT dealer.
Anti-lock
Braking
System (ABS) fi x e d . The anti-lock braking system
has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact
a PEUGEOT dealer without delay.
Dynamic
stability control
(ESP/ASR) fl a s h i n g .
The ESP/ASR regulation is
active. The system optimises traction and improves
the directional stability of the vehicle.
fi x e d . Unless it has been deactivated
with the indicator lamp on
the button on, the ESP/ASR
system is faulty. Have it checked by a PEUGEOT dealer.
Page 17 of 119
INSTRUMENTS and CONTROLS
20
Warning lamp is on Cause Action/Observations
Engine
autodiagnosis system fi x e d . The emission control system
has a fault.
This lamp should go off when the engine is started
.
If it does not go off, contact a PEUGEOT dealer
urgently.
P a r t i c l e e m i s s i o n s fi l t e r f a u l t
(fuel additive level, risk of
blockage...). Refer to the "Checks" section.
Have it checked by a PEUGEOT dealer.
fl a s h i n g . The engine management
system has a fault. Risk of destruction of the catalytic converter.
Have it checked by a PEUGEOT dealer.
Low fuel level fi x e d w i t h t h e
needle in the red zone. W h e n i t fi r s t c o m e s o n t h e r e
remains approximately
5 litres
of fuel in the tank.
At this point, you begin to use
the fuel reserve. Refuel as soon as possible to avoid running
out of fuel.
This warning lamp will come on every time
t h e i g n i t i o n i s s w i t c h e d o n , u n t i l a s u f fi c i e n t
addition of fuel is made.
Fuel tank capacity: approximately
50 litres .
Never continue to drive until you run out
of fuel, as this could damage the emission
control and injection systems.
Maximum
coolant
temperature fi x e d w i t h
the needle in
the red zone. The temperature of the cooling
system is too high. Stop as soon as it is safe to do so.
Wait until the engine has cooled down before
topping up the level, if necessary.
If the problem persists, contact a PEUGEOT
dealer.
Engine oil
pressure fi x e d . There is a fault with the engine
lubrication system. Stop as soon it is safe to do so.
Park, switch off the ignition and contact a
PEUGEOT dealer.
Page 21 of 119
ii
ii
INSTRUMENTS and CONTROLS
24
Following this operation, if you
wish to disconnect the battery,
lock the vehicle and wait at least
fi v e m i n u t e s f o r t h e z e r o r e s e t t o b e
taken into account.
Service indicator zero reset
After each service, the service indicator
must be reset to zero.
The procedure for resetting to zero is as
follows:
switch off the ignition,
press and hold the trip distance re-
corder zero reset button,
switch on the ignition; the distance
recorder display begins a count-
down,
when the display indicates "=0" ,
release the button; the spanner
disappears.
The distance remaining may be
weighted by the time factor, depend-
ing on the driver's driving habits.
Therefore, the spanner may also
come on if you have exceeded the
two year service interval.
Service overdue
For 5 seconds after the ignition is
switched on,
t h e s p a n n e r fl a s h e s to
indicate that the service must be carried
out as soon as possible.
Example: the service is overdue by
300 km.
For 5 seconds after the ignition is
switched on, the display indicates:
5 seconds after the ignition is switched
on, the distance recorder resumes its
normal operation. The spanner re-
mains
on .
