2010.5 Peugeot 206 P Dag instrument panel

63
Operating fault Lateral airbags Deployment
The lateral airbags are deployed uni-
laterally in the event of a serious side
impact applied to all or part of the lat-
eral impact zone
B , perpendicular to
the longitudinal centreline of the vehicle
on a horizontal plane and directed from
the outside towards the inside of the ve-
hicle.
The lateral airbag infl ates between the
occupant of the vehicle and the corre-
sponding door trim panel.
Impact detection zones

A. Front impact zone.

B. Side impact zone.
Deactivating the front
passenger's front airbag
To ensure the safety of your child, it is
essential to deactivate the passenger's
airbag when you install a rear-facing
child seat on the front passenger seat.
Otherwise, the child would risk being
seriously injured or killed if the airbag
were to infl ate.

 With the ignition switched off , insert
the key into the passenger's airbag de-
activation switch, turn it to the "OFF"
position, then remove the key keeping
the switch in the new position. Reactivation
As soon as the child seat is removed,
turn the airbag switch to the
"ON" po-
sition to reactivate the airbag and thus
ensure its safety function.
System which protects the driver in the
event of a serious side impact in order
to limit the risk of injury to the chest.
The lateral airbag is fi tted in the seat
back frame, on the door side. When the ignition is on, this
warning lamp remains lit on the
instrument panel if the passen-
ger's airbag is deactivated.
If this warning lamp comes on,
accompanied by an audible
signal and a message in the
multifunction screen, contact a
PEUGEOT dealer to have the airbag
system checked. In the
"OFF" position, the passenger's
airbag will not be triggered in the event
of an impact.

i
72
CRUISE CONTROL
System which automatically maintains
the speed of the vehicle at the value
programmed by the driver, without any
action on the accelerator pedal.
The cruise control is switched on
manually: it requires a minimum vehicle
speed of 25 mph (40 km/h) and the en-
gaging of fourth gear.
The cruise control is switched off man-
ually or by pressing the brake or clutch
pedal or on triggering of the ESP system
for safety reasons.
It is possible to exceed the programmed
speed temporarily by pressing the ac-
celerator pedal.
To return to the programmed speed,
simply release the accelerator pedal.
Switching off the ignition cancels any
programmed speed value. The controls of this system are grouped
together on stalk
A .

1. Cruise control mode selection dial

2. Speed programming/value decrease
button

3. Speed programming/value increase
button

4. Cruise control off/resume button The programmed information is grouped
together on the instrument panel display.

5. Cruise control off/resume indication

6. Cruise control mode selection indication

7. Programmed speed value
Steering mounted controls Displays on the instrumen
t panel
The cruise control cannot, in any circum-
stances, replace the need to respect speed
limits, nor can it replace the need for vigilance
and responsibility on the part of the driver.
You are advised to keep your feet
near the pedals.

74
SPEED LIMITER
System which prevents the vehicle from
exceeding the speed programmed by
the driver.
When the programmed speed limit is
reached, pressing the accelerator pedal
no longer has any effect.
The speed limiter is switched on man-
ually: it requires a programmed speed
of at least 20 mph (30 km/h).
The speed limiter is switched off by
manual operation of the control.
The programmed speed can be
exceeded temporarily by pressing the
accelerator fi rmly.
To return to the programmed speed,
simply slow down to a speed below the
programmed speed.
The programmed speed remains in the
memory when the ignition is switched
off.
The speed limiter cannot, in any circum-
stances, replace the need to respect
speed limits, nor can it replace the need
for vigilance and responsibility on the
part of the driver. The controls of this system are grouped
together on stalk
A .

1. Speed limiter mode selection dial

2. Value decrease button

3. Value increase button

4. Speed limiter on/off button The programmed information is grouped
together on the instrument panel screen.

5. Speed limiter on/off indication

6.
Speed limiter mode selection indication

7. Programmed speed value
Steering mounted controls Displays on the instrumen
t panel

91

Fuse

N° Rating
Functions
1 - Not used
4 20 A Multifunction screen - Boot lamp - Audio system - Ste ering mounted controls - Trailer
5 - Not used
6 10 A Coolant level - Audio system
7 15 A Driving school accessory - Alarm fi tted as an accessory
9 - Not used
10 40 A Rear screen demisting 11 15 A Rear windscreen wiper
12 30 A Front electric windows
14 10 A Engine fusebox - Airbags - Steering mounted cont rols - Rain sensor
15 15 A Instrument panel - Multifunction screen - Air con ditioning - Audio equipment
16 30 A Locking/unlocking controls for doors, bonnet a nd boot
20 10 A Right-hand brake lamp
21 15 A Left-hand brake lamp - 3rd brake lamp
22 20 A Front courtesy lamp - 12 volt accessory socket
S1 Shunt PARC shunt