Page 83 of 341
Fuel tank Capacity of the tank: approximately 60 litres.
Low fuel level
Refuelling
Additions of fuel must be of at least 5 litres to be registered by the fuel gauge. Opening the filler cap may result in an inrush of air. This vacuum is entirely normal and results
from the sealing of the fuel system.
Press control A until the automatic opening of the fuel flap is heard. This control remains active for a few minutes after switching off the ignition. If necessary, switch the ignition on again to reactivate it. Take care to select the pump that delivers the correct fuel for your vehicle.
Introduce the nozzle so as to push in the metal non-return flap B. Make sure that the nozzle is pushed in as far as possible before star ting to refuel (risk of blowback). Maintain this position while refuelling. Push the fuel flap to close it. If you are filling your tank to the top, do not persist after the third cut- off; this could cause your vehicle to malfunction.
When the low fuel level in the tank is reached, this warning lamp on
the instrument panel comes on, accompanied by an audible warning and a message in the screen. When it first comes on, around 6 litres of fuel remain in the tank. You must refuel as soon as possible to avoid running out.
With Stop & Star t, never refuel with the system in STOP mode; you must switch off the ignition with the key.
Page 84 of 341
117Access
Quality of the fuel used
for petrol engines
The petrol engines are per fectly compatible with E10 type petrol biofuels (containing 10 % ethanol), conforming to European standards EN 228 and EN 15376. E85 type fuels (containing up to 85 % ethanol) are reser ved exclusively for vehicles marketed for the use of this type of fuel (BioFlex vehicles). The quality of the ethanol must comply with European standard EN 15293. For Brazil only, special vehicles are marketed to run on fuels containing up to 100 % ethanol (E100 type).
Quality of the fuel used
for Diesel engines
The Diesel engines are per fectly compatible with biofuels which conform to current and future European standards (Diesel fuel which complies with standard EN 590 mixed with a biofuel which complies with standard EN 14214) available at the pumps (containing up to 7 % Fatty Acid Methyl Ester). The B30 biofuel can be used in cer tain Diesel engines; however, this use is subject to strict application of the special ser vicing conditions. Contact a CITROËN dealer or a qualified workshop. The use of any other type of (bio)fuel (vegetable or animal oils, pure or diluted, domestic fuel...) is strictly prohibited (risk of
damage to the engine and fuel system).
The petrol or Diesel engine of your vehicle is fitted with a catalytic conver ter, a device which helps to reduce the level of harmful emissions in the exhaust gases. For petrol engines, the use of unleaded fuel is compulsor y. The filler neck is narrower, admitting unleaded petrol nozzles only.
Fuel supply cut-off
Your vehicle is equipped with a safety device which cuts off the fuel supply in the event of a collision.
If you have put in the wrong fuel for your vehicle, you must have have the tank drained and refilled with the correct fuel before you star t the engine.
Page 198 of 341
Closing
Running out of fuel
(Diesel)
If your vehicle is fitted with an HDI engine, the fuel system must be primed if you run out of fuel; refer to the engine compar tment view on the "Diesel engine" page.
1.6 litre Turbo HDI engine
Fill the fuel tank with at least five litres of diesel. Open the bonnet. Squeeze and release the priming pump repeatedly until it hardens (it may be hard at the first press). Operate the star ter until the engine star ts. Close the bonnet.
If the engine does not star t first time, don't keep trying. Operate the priming pump again, then the star ter motor.
Take the stay out of the suppor t notch. Clip the stay in its housing. Lower the bonnet and release it at the end of its travel. Pull on the bonnet to check that it is secured correctly.
2 litre Turbo HDI engine
Fill the fuel tank with at least five litres of
Diesel. Open the bonnet. Unclip the style cover for access to the priming pump. Slacken the bleed screw. Squeeze and release the priming pump repeatedly until fuel appears in the transparent pipe with the green connector. Retighten the bleed screw. Operate the star ter until the engine star ts. Put the style cover back in position and clip it in place. Close the bonnet.
Page 199 of 341
Closing
Running out of fuel
(Diesel)
If your vehicle is fitted with an HDI engine, the fuel system must be primed if you run out of fuel; refer to the engine compar tment view on the "Diesel engine" page.
1.6 litre Turbo HDI engine
Fill the fuel tank with at least five litres of diesel. Open the bonnet. Squeeze and release the priming pump repeatedly until it hardens (it may be hard at the first press). Operate the star ter until the engine star ts. Close the bonnet.
If the engine does not star t first time, don't keep trying. Operate the priming pump again, then the star ter motor.
Take the stay out of the suppor t notch. Clip the stay in its housing. Lower the bonnet and release it at the end of its travel. Pull on the bonnet to check that it is secured correctly.
2 litre Turbo HDI engine
Fill the fuel tank with at least five litres of
Diesel. Open the bonnet. Unclip the style cover for access to the priming pump. Slacken the bleed screw. Squeeze and release the priming pump repeatedly until fuel appears in the transparent pipe with the green connector. Retighten the bleed screw. Operate the star ter until the engine star ts. Put the style cover back in position and clip it in place. Close the bonnet.
Page 201 of 341
Diesel engines
The various caps and covers allow access for checking the levels of the various fluids, for replacing cer tain components and for priming the fuel system.
1. Power steering reser voir. 2. Screenwash and headlamp wash reser voir. 3. Coolant reser voir. 4. Brake fluid reser voir. 5. Battery/Fuses. 6. Fusebox. 7. Air filter. 8. Engine oil dipstick. 9. Engine oil filler cap. 10. Priming pump * . 11. Bleed screw * .
* According to engine.
