2010.5 Citroen DS4 change time
[x] Cancel search: change timePage 23 of 341
55Monitoring
Lighting dimmer
Permits manual adjustment of the brightness of the instruments and controls in relation to the exterior brightness. Only operates when the vehicle lighting is on in night mode.
Activation
Press button A to change the brightness of the instruments and controls. When the lighting reaches the minimum setting, release the button, then press again to increase it. or When the lighting reaches the maximum setting, release the button, then press again to reduce it. When the lighting reaches the level of brightness required, release the button.
This indicator and the lighting
value appear in the middle of the instrument panel during adjustment to show the lighting level compared to the 16 levels available.
You can also modify the level of lighting by turning the thumb wheel B , located on the left of the steering wheel: upwards; to reduce the level, downwards; to increase the level.
Deactivation
When the vehicle lighting is off, or in day mode (daytime running lamps on), pressing the button or turning the thumb wheel does not have any effect.
Page 24 of 341
System allowing cer tain screens to be switched
off for night driving. The instrument panel remains on with the analogue vehicle speed, manual or electronic gearbox system gear selected, cruise control or speed limiter information, if in use, and the low fuel aler ts as appropriate. If there is an aler t or a change in a function or to a setting, the black panel mode is interrupted.
Black panel (black screen)
Activation
With the vehicle lighting on, press this button again to activate the black panel. Press once more to illuminate on the
various screens again. The dashboard lighting dimmer remains operational when in black panel mode.
In the instrument panel, you can change the colour of its dials (button A ) independently from Athat of the screens (button B ). There are five colour variants, from white to blue. press the appropriate button as many times as needed to obtain the desired colour.
Customising the instrument
panel colours
In order to retain the digital reading of the speed in km/h, activation of black panel mode is prohibited in countries that use metric units.
Page 26 of 341
Monochrome screen C
This displays the following information: - time, - date, - ambient temperature (this flashes if there is a risk of ice), - openings check (if a doors or the boot is open), - parking sensor information, - current audio source, - telephone or Bluetooth system information, - trip computer (refer to the end of the section). Warning messages (e.g.: "Emission control system faulty") or information messages (e.g.: "Automatic switching on of the headlamps activated") may appear temporarily. These can be cleared by pressing the "ESC" button.
Displays in the screen
From the control panel of your audio system, you can press: button A to chooses between the display of audio information in full screen or the shared display of audio and trip computer
information, the "MENU" button for access to the main menu , the " " or " " buttons to scroll through the items on the screen, the " " or " " buttons to change a setting value, the "OK" button to confirm, or the "ESC" button to abandon the operation in progress.
Controls
Press the "MENU" button for access to the main menu : - "Multimedia", - "Telephone", - "Trip computer", - "Bluetooth connection", - "Personalisation-configuration", Press the " " or " " button to select the menu required, then confirm by pressing the "OK" button.
Main menu
Page 36 of 341
A few definitions…
This value may vary following a change in the style of driving or the relief, resulting in a significant change in the current fuel consumption.
If dashes are displayed continuously while driving in place of the digits, contact a CITROËN dealer or a qualified workshop.
This function is only displayed from 20 mph (30 km/h).
The fuel consumption of your vehicle will be higher than the official figures obtained by CITROËN during the first 3 000 miles (5 000 km) of the vehicle's life.
Range
(miles or km) This indicates the distance which can still be travelled with the fuel remaining in the tank in relation to the average
fuel consumption over the last few miles (kilometres) travelled.
When the range falls below 20 miles (30 km), dashes are displayed. After filling with at least 5 litres of fuel, the range is recalculated and is displayed when it exceeds 60 miles (100 km).
Current fuelconsumption
(mpg or l/100 km or km/l) This is the average fuel consumption during the last few seconds.
A v e r a g e f u e l consumption
(mpg or l/100 km or km/l) This is the average fuel consumption since the last trip computer zero reset.
A v e r a g e s p e e d
(mph or km/h) This is the average speed calculated since the last trip computer zero reset (ignition on).
D i s t a n c e t r a v e l l e d
(miles or km) This indicates the distance travelled since the last trip computer zero reset.
Stop & Start timecounter
(minutes/seconds or hours/minutes) If your vehicle is fitted with Stop & S t a r t , a t i m e c o u n t e r c a l c u l a t e s t h e t i m e spent in STOP mode during a journey. It resets to zero every time the ignition is switched on with the key.
Page 39 of 341
A few definitions…
This value may vary following a change in the style of driving or the relief, resulting in a significant change in the current fuel consumption.
If dashes are displayed continuously while driving in place of the digits, contact a CITROËN dealer or a qualified workshop.
This function is only displayed from 20 mph (30 km/h).
The fuel consumption of your vehicle will be higher than the official figures obtained by CITROËN during the first 3 000 miles (5 000 km) of the vehicle's life.
Range
(miles or km) This indicates the distance which can still be travelled with the fuel remaining in the tank in relation to the average
fuel consumption over the last few miles (kilometres) travelled.
When the range falls below 20 miles (30 km), dashes are displayed. After filling with at least 5 litres of fuel, the range is recalculated and is displayed when it exceeds 60 miles (100 km).
Current fuelconsumption
(mpg or l/100 km or km/l) This is the average fuel consumption during the last few seconds.
A v e r a g e f u e l consumption
(mpg or l/100 km or km/l) This is the average fuel consumption since the last trip computer zero reset.
A v e r a g e s p e e d
(mph or km/h) This is the average speed calculated since the last trip computer zero reset (ignition on).
D i s t a n c e t r a v e l l e d
(miles or km) This indicates the distance travelled since the last trip computer zero reset.
Stop & Start timecounter
(minutes/seconds or hours/minutes) If your vehicle is fitted with Stop & S t a r t , a t i m e c o u n t e r c a l c u l a t e s t h e t i m e spent in STOP mode during a journey. It resets to zero every time the ignition is switched on with the key.
Page 75 of 341
Alarm *
- Exterior perimeter
The system checks for opening of the vehicle. The alarm is triggered if anyone tries to open a door, the boot, the bonnet...
- Interior volumetric
The system checks for any variation in the volume in the passenger compar tment. The alarm is triggered if anyone breaks a window, enters the passenger compar tment or moves inside the vehicle.
Locking the vehicle with full
alarm system
- Tilt
The system checks for any change in the attitude of the vehicle. The alarm is triggered if the vehicle is lifted, moved or knocked.
Self-protection function
The system checks for the putting out of
ser vice of its components. The alarm is triggered if the battery, the central control or the siren wiring are put out of ser vice or damaged.
For all work on the alarm system, contact a CITROËN dealer or a qualified workshop.
Activation
Switch off the ignition and get out of the vehicle. Press the locking button on the remote control. The monitoring system is active: the indicator lamp in the button flashes once per second.
After the locking button on the remote control is pressed, the exterior perimeter monitoring is activated after a delay of 5 seconds and the interior volumetric and anti-tilt monitoring after
a delay of 45 seconds.
Deactivation
Press the unlocking button on the remote control. The alarm system is deactivated: the indicator lamp in the button goes off.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior perimeter monitoring will be activated after a delay of 45 seconds at the same time as the interior volumetric and anti-tilt monitoring.
* According to country.
Page 205 of 341
Checks
Battery Air filter and passenger compartment filter
Oil filter
Unless other wise indicated, check these components in accordance with the Maintenance and Warranty Guide and according to your engine. Other wise, have them checked by a CITROËN dealer or a qualified workshop.
The battery does not require any maintenance. However, check that the terminals are clean and correctly tightened, par ticularly in summer and winter. When carrying out work on the battery, refer to the "Practical information" section for details of the precautions to be taken before disconnecting the battery and following its reconnection.
Refer to the Maintenance and Warranty Guide for details of the replacement inter vals for these components. Depending on the environment (e.g. dusty atmosphere) and the use of the vehicle (e.g. city driving), replace them twice as often if necessar y (refer to the "Engines" section). A clogged passenger compar tment filter may have an adverse effect on the per formance of the air conditioning system and generate undesirable odours.
Replace the oil filter each time the engine oil is changed.
Refer to the Maintenance and Warranty Guide for details of the replacement inter val for this component.
The presence of this label, in par ticular with the Stop & Star t system, indicates the use of a specific 12 V lead-acid battery with special technology and specification, for which the involvement of a CITROËN dealer or a qualified workshop is required when replacing or
disconnecting the battery. Failure to obser ve this recommendation may shor ten the life of the battery.
Page 223 of 341
Practical information
Changing daytime running lamp bulbs
Remove the protective cover by pulling on
the tab. Disconnect the bulb connector. Turn the bulb holder a quar ter of a turn and extract it. Pull the bulb and change it. To reassemble, carry out these operations in reverse order.
Changing main beam headlamp bulbs (only on models with halogen headlamps)
Remove the protective cover by pulling on the tab. Disconnect the bulb connector.
Squeeze the springs to release the bulb. Pull out the bulb and replace it. To reassemble, carry out these operations in reverse order.
Changing integrated direction indicator side repeaters
Inser t a screwdriver towards the centre of
the repeater between the repeater and the base of the mirror. Tilt the screwdriver to extract the repeater and remove it. Disconnect the repeater connector. To reassemble, carry out these operations in reverse order. Contact a CITROËN dealer or a qualified workshop to obtain replacement repeaters.