Page 223 of 341
Practical information
Changing daytime running lamp bulbs
Remove the protective cover by pulling on
the tab. Disconnect the bulb connector. Turn the bulb holder a quar ter of a turn and extract it. Pull the bulb and change it. To reassemble, carry out these operations in reverse order.
Changing main beam headlamp bulbs (only on models with halogen headlamps)
Remove the protective cover by pulling on the tab. Disconnect the bulb connector.
Squeeze the springs to release the bulb. Pull out the bulb and replace it. To reassemble, carry out these operations in reverse order.
Changing integrated direction indicator side repeaters
Inser t a screwdriver towards the centre of
the repeater between the repeater and the base of the mirror. Tilt the screwdriver to extract the repeater and remove it. Disconnect the repeater connector. To reassemble, carry out these operations in reverse order. Contact a CITROËN dealer or a qualified workshop to obtain replacement repeaters.
Page 225 of 341
Changing a bulb
The headlamps are fitted with polycarbonate glass with a protective coating: do not clean them using a dr y or abrasive cloth, nor with a detergent or solvent product, use a sponge and soapy water, when using a high pressure washer on persistent marks, do not direct at the lamps or their outlines for too long, so as not to damage their protective coating and seals.
Do not touch the bulb directly with your fingers, use lint-free cloths. Changing a bulb should only be done after the headlamp has been switched off for a few minutes (risk of serious burns). It is imperative to use only anti-ultraviolet (UV) type bulbs in order not to damage the headlamp. Always replace a failed bulb with a new bulb with the same type and specification.
Risk of electrocution
Xenon bulbs (D1S-35W) must be replaced by a CITROËN dealer or a qualified workshop.
Bulbs with lugs, type H1, H7... take care to position them correctly to ensure the best lighting.
Page 234 of 341
Fuse table
Fuse N°RatingFunctions
F1930 A Windscreen wipers slow/fast speed.
F2015 A Front and rear screenwash pump.
F2120 A Headlamp wash pump.
F2215 A Horn.
F2315 A Right-hand main beam headlamp.
F2415 A Left-hand main beam headlamp.
F275 A Left-hand dipped headlamp.
F285 A Right-hand dipped headlamp.
Page 239 of 341
Energy economy mode System which manages the period of use of cer tain functions to conser ve a sufficient level of charge in the battery. After the engine has stopped, you can still use func tions such as the audio equipment, windscreen wipers, dipped beam headlamps, cour tesy lamps, etc. for a maximum combined period of thir ty minutes.
This period may be greatly reduced if the battery is not fully charged.
A flat battery prevents the engine from star ting (refer to the corresponding paragraph).
If the telephone is being used at the same time on the navigation system, it will be interrupted after 10 minutes.
Switching to economy mode
Once this period has elapsed, a message
appears in the screen indicating that the vehicle has switched to economy mode and the active functions are put on standby.
Exiting economy mode
These functions are reactivated automatically
the next time the vehicle is driven. In order to resume the use of these functions immediately, star t the engine and let it run for a few minutes. The time available to you will then be double the period for which the engine is left running. However, this period will always be between five and thir ty minutes.
Page 297 of 341
329
10
1
2
3a
3b
1
2
3
4
CONFIGURATION
P r e s s SETUP to display the " C o n fi g u r a t i o n " m e n u .
S e l e c t " Adjust luminosity " a n d c o n fi r m t o a d j u s t t h e s c r e e n b r i g h t n e s s .
P r e s s " OK " t o s a v e t h e c h a n g e s .
T h e s e t t i n g s f o r d a y a n d n i g h t a r e independent.
S e l e c t " Choose colour " a n d c o n fi r m t o Choose colourselect the screen colour harmony and the map presentation mode:
- day mode,
- n i g h t m o d e ,
- a u t o m a t i c d a y / n i g h t m o d e , a c c o r d i n g t o w h e t h e r t h e headlamps are on.
SETTING THE DATE AND TIME
S e l e c t " Set date and time " a n d c o n fi r m .
S e l e c t t h e s e t t i n g t o a d j u s t .
C o n fi r m b y p r e s s i n g OK , then adjust t h e s e t t i n g a n d c o n fi r m a g a i n t o s a v e t h e m o d i fi c a t i o n .
S e l e c t " D i s p l a y c o n fi g u r a t i o n " a n d c o n fi r m .
P r e s s SETUP to display the " C o n fi g u r a t i o n " m e n u .
S e l e c t " D i s p l a y c o n fi g u r a t i o n " a n d c o n fi r m .
A d j u s t t h e s e t t i n g s o n e b y o n e .
T h e n s e l e c t " OK " o n t h e s c r e e n a n d c o n fi r m t o s a v e t h e s e t t i n g s .
DISPLAY CONFIGURATION
S e l e c t " Synchronize the minutes with GPS " s o t h a t s e t t i n g t h e minutes is done automatically by satellite reception.
Page 334 of 341
366
09 SCREEN MENU MAP
Personalisation-
configuration
D e fi n e t h e v e h i c l e p a r a m e t e r s
Access to the vehicle
Plip action
D r i v i n g p o s i t i o n s e t t i n g
U n l o c k i n g b o o t o n l y
Driving assistance
P a r k i n g b r a k e a u t o m a t i c
R e a r w i p e i n r e v e r s e g e a r
Speeds memorised
Vehicle lighting
Directional headlamps
D a y t i m e l i g h t s
Interior lighting
F o l l o w - m e - h o m e h e a d l a m p s
W e l c o m e l i g h t i n g
Choice of language
D i s p l a y c o n fi g u r a t i o n
Choice of units
Date and time adjustment
Display parameters
Brightness
Choice of sounds
Trip computer
Vehicle diagnosis *
Bluetooth connection
Connections management
Search for a device
* T h e p a r a m e t e r s v a r y a c c o r d i n g t o t h e v e h i c l e .
1
2
3
3
3
2
3
3
3
2
3
3
2
3
3
1
1
2
2
2
2
1
1
1
1
