2009 YAMAHA RHINO 700 warning

5-31 1. Tire pressure gauge
1. Manomètre pour pneus
1. Manómetro para neumáticos
EVU00510
Tire pressure
Use the tire pressure gauge to check and adjust
tire pressures when the tires are cold. Tire pres-
sures must be equal on both sides. WARNING!
Operation of this vehicle with improper tire
pressure may cause severe injury or death
from loss of control or rollover. Tire pressure
below the minimum specified could also cause
the tire to dislodge from the rim under severe
riding conditions.
Set tire pressures to the following specifications:ACE-02EThe tire pressure gauge is included as standard
equipment. Make two measurements of the tire
pressure and use the second reading. Dust or dirt
in the gauge could cause the first reading to be in-
correct.
Recommended
pressureMinimum Maximum
Front70 kPa
(0.70 kgf/cm
2,
10 psi)63 kPa
(0.63 kgf/cm
2,
9 psi)77 kPa
(0.77 kgf/cm
2,
11 psi)
Rear98 kPa
(0.98 kgf/cm
2,
14 psi)91 kPa
(0.91 kgf/cm
2,
13 psi)105 kPa
(1.05 kgf/cm
2,
15 psi)
EE.book Page 31 Tuesday, April 15, 2008 9:11 AM

6-1
EVU00530
1-OPERATION
Read the Owner’s Manual carefully to become fa-
miliar with all controls. If there is a control or func-
tion you do not understand, ask your Yamaha
dealer.
WARNING
Failure to familiarize yourself with the controls
can lead to loss of control, which could cause
an accident or injury.
EE.book Page 1 Tuesday, April 15, 2008 9:11 AM

6-7
5B410007
Starting the engine
1. Turn the main switch to “ON”.NOTICEThe coolant temperature warning light and en-
gine trouble warning light should come on,
then go off.
If a warning light does not go off, see pages
4-9–4-11 for the corresponding warning light
circuit check.2. Apply the brake pedal.
3. Shift the drive select lever into the neutral po-
sition.


When the drive select lever is in the neu-
tral position, the neutral indicator light
should come on. If the neutral indicator
light does not come on, ask a Yamaha
dealer to inspect the electric circuit.
EE.book Page 7 Tuesday, April 15, 2008 9:11 AM

6-15 1. Drive select lever a. L (Low)
b. H (High) c. N (Neutral)
d. R (Reverse)
1. Sélecteur de marche a. L (gamme basse)
b. H (gamme haute) c. N (point mort)
d. R (marche arrière)
1. Palanca selectora a. L (marcha corta)
b. H (marcha larga) c. N (punto muerto)
d. R (marcha atrás)
Shifting: neutral to reverse
WARNING
Before you shift into reverse, make sure there
are no obstacles or people behind you. When it
is safe to proceed, go slowly. Hitting an obsta-
cle or person could result in serious injury or
death.1. Stop the vehicle. Take your foot off the accel-
erator pedal and check behind you.
2. Apply the brake pedal.
3. Shift from neutral to reverse or vice versa by
moving the drive select lever along the shift
guide.


When in reverse, the reverse indicator
light should be on. Due to the synchroniz-
ing mechanism in the engine, the light
may not come on until the vehicle starts
moving.


If the light does not come on, ask a
Yamaha dealer to inspect the reverse in-
dicator light electrical circuit.
EE.book Page 15 Tuesday, April 15, 2008 9:11 AM

6-25
EVU00630
Loading
Take extra precautions when driving with a load or
trailer. Follow these instructions and always use
common sense and good judgment when carrying
cargo or towing a trailer.
Prepare your load or trailer
WARNING
Improper loading or towing can increase the
risk of loss of control, an overturn, or other ac-
cident:

Do not exceed the Maximum Loading Lim-
its for the vehicle (see box or vehicle label-
ing).


Keep weight in the cargo bed centered
side to side, and as low and as far forward
as possible. Top-heavy loads increase the
risk of overturn. Be sure cargo is secured –
a loose load could change handling unex-
pectedly or strike occupants.
EE.book Page 25 Tuesday, April 15, 2008 9:11 AM

6-31
Operating when loaded with cargo or towing a
trailer
Drive more slowly than you would without a load.
The more weight you carry, the slower you should
go. Although conditions vary, it is good practice to
keep the vehicle in low gear whenever you are car-
rying heavier loads or when towing a trailer.
WARNING
Carrying loads or towing a trailer can increase
the risk of loss of control, an overturn, or other
accident. To reduce the risk of an accident:

Reduce speed, operate in low gear only,
and allow more room to stop. A heavier ve-
hicle takes longer to stop.


Avoid hills and rough terrain. Choose ter-
rain carefully. Use extreme caution when
towing or carrying a load on inclines.


Turn gradually and go slowly.
EE.book Page 31 Tuesday, April 15, 2008 9:11 AM

6-33
Pulling something other than a trailer
Yamaha recommends that loads be transported in
the bed or in a trailer. If you need to move an ob-
ject a short distance use a winch and follow the
winch manufacturer’s instructions.
If you choose to use something other than a winch
use extreme caution, follow the manufacturer’s in-
structions for that product, and only attach to the
hitch or hitch bracket of the Rhino. WARNING! Im-
properly pulling can cause serious injury or
death. Never exceed the Pulling Load limit of
the Rhino. Avoid pulling on inclines.
Pulling objects on the ground can be more hazard-
ous than pulling a trailer. It may be difficult to pre-
dict how the load will affect vehicle operation. That
effect could also change depending upon terrain
or what obstacles might be in the object’s path.
EE.book Page 33 Tuesday, April 15, 2008 9:11 AM

7-1
5B460003
1-
BASIC GUIDE FOR SAFE
USE
As a Rhino owner you are responsible for the safe
and proper operation of this vehicle. Read this
chapter and review the safety instructions in Chap-
ter 2 before operating the vehicle. Use these chap-
ters and the labels on the vehicle to instruct new
operators and passengers. Do not allow anyone
else to operate the vehicle or ride as a passenger
if you are unsure that he/she is willing and able to
follow these instructions.
WARNING
Follow these instructions to reduce your risk
of an accident and to reduce the risk of serious
injury or death in the event of an accident.
EE.book Page 1 Tuesday, April 15, 2008 9:11 AM