2009 VOLVO S60 clock

09 Maintenance and servicing
Replacing bulbs
09``201 Turn signal, driver's side
G028438
Removing the defective bulb:1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Pull out the bulb holder by twisting it coun-
terclockwise.
3. Remove the bulb from the holder by press-
ing it in and turning it counterclockwise.Installing the new bulb:1. Insert the new bulb into the holder by
pressing it in and turning it clockwise.
2. Reinsert the bulb holder in the headlight
housing and twist it clockwise until it seats
properly.
Turn signal, passenger's side
G027283
1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Remove radiator pipe (1) from the box.
3. Remove filler pipe screw (2).
4. Pull the filler pipe (3) straight up.
5. Remove vent hose (4) from filler pipe.Installing the new bulb:1. Replace the bulb (same procedure as the
driver's side bulb).
2. Ensure that the seal between the washer
fluid reservoir and the filler pipe is correctly
positioned.3. Press the filler pipe (3) back into position.
4. Press the vent hose (4) into place on the
filler pipe.
5. Reinstall and tighten the filler pipe screw
(2).
6. Reinstall the radiator pipe to the box (1).
Side marker light
G028439
Side marker light1. Turn the lamp holder counterclockwise
and pull it out.
2. Pull out the defective bulb and insert a new
one.

09 Maintenance and servicingReplacing bulbs
09202
3. Reinsert the lamp holder and turn it clock-
wise until it seats properly.Front fog lights (option)
G027227
Front fog lightRemoving the defective bulb:1. Switch off the headlights and turn the igni-
tion switch to position 0.
2. Turn the bulb holder slightly counterclock-
wise.
3. Pull out and remove the bulb.Installing the new bulb:1. Insert the new bulb (it can only be inserted
in one position).2. Reinsert the bulb holder and turn it clock-
wise. "TOP" must be upward.

09 Maintenance and servicingReplacing bulbs
09204
High level brake lightThese bulbs are of a special type. We recom-
mend that you ask a trained and qualified Volvo
service technician to replace this bulb.License plate lights
G028442
1. Switch off the ignition.
2. Loosen the screws with a torx screwdriver.
3. Carefully pull out the lamp housing.
4. Turn the bulb holder counterclockwise and
pull it out.
5. Pull out the defective bulb and insert a new
one.6. Reinsert the bulb holder into the housing
and turn it clockwise.
7. Reinstall the housing and screw it in place.
Footwell lighting
G027287
The door step courtesy lights are located under
the dash on the driver's and passenger's sides.
To replace a bulb:
1. Carefully insert a screwdriver and pry out
the lens.
2. Replace the defective bulb.
3. Reinstall the lens.
Trunk lights
G028441
1. Carefully insert a screwdriver and pry out
the lens.
2. Pry out the bulb and replace it.
3. Press the lens back into place.

10 Audio
Radio functions HU-650/HU-850
10``219
Switch on/off
Press the knob to switch on or
turn off the radio.
Volume controlTurn the knob clockwise to increase volume.
Volume control is electronic and does not have
an end stop. If you have a key pad in the steer-
ing wheel, increase or decrease the volume
with the + or – buttons.Volume control - ALARMIf a CD is playing when the radio receives an
alarm bulletin (available in certain areas only),
the CD player enters pause mode. The bulletin
is broadcast at the volume selected for this
type of message.
G026678
Auxiliary (AUX) 3.5 mm connector portAfter the bulletin has been completed, the
audio system reverts to the originally selected
sound.AUX connector (option)The AUX (auxiliary) port can be used to connect
external devices such as an mp3 player.
Turn the SOURCE control (see the illustrations
on on page 217 or 218) to choose AUX.
If the player is being charged through a 12-volt
socket while it is connect to the AUX port,
sound quality may be impaired.
The volume of the external sound source AUX
may be different from the volume of the internalsound sources such as the CD player or the
radio.
To change the AUX volume level:
1. While playing the radio or a CD, lower the
audio volume to about one-quarter.
2. Switch to AUX mode on the audio system.
3. Connect the headphone output from your
music player to the AUX input using a cable
with a stereo 3.5mm miniplug at both ends.
4. Set your music player's headphone vol-
ume to three-quarters using the player's
volume controls.
5.
PressSOURCE, turn the SOURCE knob,
select
ADVANCED MENU
and press
SOURCE.
6.
Press the SOURCE knob, turn to AUDIO
SETTINGS and press SOURCE.
7.
Press the SOURCE knob, turn to
AUX
INPUT
and press SOURCE.
8. Turn the volume knob to raise or lower the
AUX Input Volume
until you hear music at
a comfortable level.
9. If there is distortion, lower your music play-
er's headphone volume until the distortion
goes away.
10. Finally, exit the menu and adjust the audio
volume to a comfortable level.