2009 TOYOTA YARIS HATCHBACK light

287
4-3. Do-it-yourself maintenance
4
Maintenance and care
Replacing light bulbs
n
Headlights
Unplug the connector.
Remove the rubber cover.
nRear bulb locations
Back-up lights
Rear turn signal lights Stop/tail and rear
side marker lights
License
plate light

288 4-3. Do-it-yourself maintenance
Release the bulb retaining
spring.
Remove the bulb.
To install a new bulb, align the
tabs of the bulb with the cutouts
of the mounting hole.
nFront fog lights (if equipped)
Remove the bolts and clips.
Partly remove the fender liner.

289
4-3. Do-it-yourself maintenance
4
Maintenance and care
Unplug the connector while
depressing the lock release.
Turn the bulb counterclockwise.
n Front sid
e marker lights
Turn the bulb base counterclock -
wise.
Remove the light bulb.

290 4-3. Do-it-yourself maintenance
nFront turn signal lights
Turn the bulb base counterclock-
wise.
Remove the light bulb.
n Parking ligh
ts
Turn the bulb base counterclock -
wise.

291
4-3. Do-it-yourself maintenance
4
Maintenance and care
Remove the light bulb.
n Ba
ck-up lights, stop/tail and rear side marker lights and rear
turn signal lights
Open the back door and remove
the cover
.
Use a flathead screwdriver which
is wrapped with a cloth.
Turn the bulb base counterclock -
wise.
Stop/tail and rear side marker
lights
Rear turn signal light
Back-up light
Remove the light bulb. Stop/tail and rear side marker
lights
Rear turn signal light
Back-up light

292 4-3. Do-it-yourself maintenance
nLicense plate light
Disengage the claws and
re
move the license plate light.
Use a flathead screwdriver which
is wrapped with a cloth.
Turn the bulb base counterclock -
wise.
Remove the light bulb.
n Light
s other than the above
If any of the lights listed below h
as burnt out, have it replaced by
your Toyota dealer.
• Side turn signal lights
• High mounted stoplight

293
4-3. Do-it-yourself maintenance
4
Maintenance and care
n
Condensation build-up on th e inside of the lens
Contact your Toyota dealer for more information in the following situations.
Temporary condensation build-up on the inside of the headlight lens does
not indicate a malfunction.
l Large drop
s of water are built up on the inside of the lens.
l W
ater has built up inside the headlight.
n LE
D high mounted stoplight
The high mounted stoplight consists of a number of LEDs. If any of the LEDs
burn
out, take your vehicle to your Toyota dealer to have the light replaced.
n Inst
alling the clips
CAUTION
nReplacing light bulbs
Turn off the headlights. Do not attempt to replace the bulb immediately after
turning off the headlights.
The bulbs become very hot and may cause burns.
n To prevent damage or fire
Make sure bulbs are fully seated and locked.
Insert the clips.

294 4-3. Do-it-yourself maintenance
NOTICE
lHalogen bulbs have pressurized gas inside and require special handling. \
Do
not touch the glass portion of the light bulb with bare hands. Hold the bulb by
the plastic or metal portion.
If the bulb is scratched or dropped it may blow out or crack.
l Fully install light bulbs and any parts used to secure them. Failing to do so
may result in heat damage, fire, or water entering the headlight unit. This
may damage the headlights or cause condensation to build up on the lens.