2009 TOYOTA xB ignition

8
Auto lock functions
Automatic door locks can be programmed to operate in four different mode\
s,
or turned OFF.
-Doors lock when shifting from Park.*
-Doors lock when the vehicle speed goes above approximately 12 mph.
-Doors unlock when ignition key is turned to “ACC” or “LOCK” \
position anddriver’s door is opened.
-Doors unlock when shifting into Park.*
* Automatic Transmission only
Refer to the Owner’s Manual for more details.
Automatic Transmission (if equipped)
Downshifting increases power going uphill, or provides engine braking do\
wnhill.
For best fuel economy during normal driving conditions, always drive wit\
h the
shift lever in the “D” position.
“S” position:
+: Upshift (push and release)
-: Downshift (pull and release)
“S” (Sequential) mode
Push shift lever to the left from “D” position. * The engine switch must be ON, and the brake pedal depressed to shiftfrom Park.
Parking brake
Pull
(2) Push (1) Pull slightly
(3) Lower
Set
Release
Park*
Reverse
Neutral
Drive
P
R
N
D
N
S“S” mode
“S” “D”
FEATURES/OPERATIONS
412xxxM2.qxd 3/20/08 3:20 PM Page 8

17
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
2009
Scion xB
!A word about safe ve hicle operations
This
Quick Reference Guide is a summary of basic vehicle operations. It
contains brief descriptions of fundamental operations so you can locate \
and
use the vehicle’s main equipment quickly and easily.
The Quick Reference Guide is not intended as a substitute for the Owner’s
Manual located in the vehicle’s glove box. We strongly encourage you to
review the Owner’s Manual and supplementary manuals so you will have a
better understanding of the vehicle’s capabilities and limitations.
Your dealership and the entire staff of Toyota Motor Sales, U.S.A., Inc. wish
you many years of satisfied driving in your new Scion xB.
This Quick Reference Guide is not a full description of Scion xB
o p erations. Every Scion xB owner s hould review t he Owner’s Manual th at
accom panies th is vehicle.
P ay s pecial attention to t he boxed information hig hligh ted in yellow
t h rough out the Owner’s Manual . Eac h box contains safe o perating
instructions to hel p you avoid injury or equi pment malfunction.
A ll information in t his Quick Reference Guide is current at the time of
p rinting. Toyota reserves t he righ t to make c hanges at any time
with out notice.
Spare tire & tools
Tool and s pare tire location
Removing t he spare tire
Jack
Jack handle
Wheel nut wrench
Spare tire
Refer to the Owner’s Manual for jack positioning and tire changing procedures.
After adjusting tire pressures, or after tires have been rotated or repl\
aced, turn
the ignition switch to “ON” and press and hold the “ SET” button until
indicator blinks three times. Then allow the vehicle to sit for a few mi\
nutes to
allow initialization to complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then\
remains
on, take the vehicle to your local Toyota dealer.
(1) Remove the spare tire cover.
(2) Loosen and remove the bolt.
(1)
(2)
If tire pressure indicator
light is on, check/adjust
each tire.
T ire Pressure Monitoring (warning)
System
412xxxM1.qxd 3/20/08 3:26 PM Page 2