Fuses and light bulbs
197
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Caution
Do not take hold of the glass bulb with
naked fingers (even the smallest amount of
dirt reduces the working life of the light bu
lb). Use a clean cloth, serviette or some-
thing similar.
Note
This Owner's Manual only describes the replacement of bulbs where it is assumed that no major complications wi
ll arise. Other light bulbs should be replaced by your
specialist garage.Main headlight with coverBefore changing the light bulb for the low beam and main beam light or the light bulb for the parking light, remove the protective cover from the rear part of the headlight. Removing cover – Switch the ignition and all lights off. – Open the bonnet.
– Press off the circlip from the cover and fold it in the direction of arrow
⇒
fig. 180
.
– Remove the cover of the headlight
by pulling towards the middle of
the vehicle.
Installation takes place in the reverse order.Parking light at the frontChange the light bulb for the parking light – Switch the ignition and all lights off. – Open the bonnet. – Remove the cover of the headlight. – Pull the lamp holder with light bulb for the parking light out of the
headlight
⇒
fig. 181
.
– Take the faulty bulb out of the fixture and insert a new one. – Insert the lamp holder with new light bulb into of the headlight. – Insert the cover of the headlight.
Fig. 180 Removing cover
Fig. 181 Change the light bulb for the parking light
s2g8.b.book Page 197 Tuesday, April 7, 2009 8:53 AM
