Page 128 of 224
Transporting children safely
127
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
Child seats of group 0/0+The optimal solution for babies of up to
about 9 months old weighing up to 10 kg
or babies up to about 18 mont
hs old weighing up to 13
kg is a child safety seat
which can be adjusted into the reclining position
⇒fig. 133
.
In view of the fact that such child seats are installed that the child is seated with its back facing the direction of travel, they
must not be used on the front passenger
seat
⇒page 124, “Use of child safety seats on the front passenger seat”.WARNING
•
It is essential to always switch off the front passenger airbag (airbags)
when attaching in exceptional circumstances a child safety seat on the front passenger seat where the child is seated
with its back facing in direction of
travel (in some countries also when the child is facing the direction of travel).
− in a specialist garage − or by using the switch for the front passenger airbag*
⇒page 121.
•
In certain countries national legal provisions require that besides the
front passenger airbag also the front passenger side airbag is deactivated. Please comply with any differing national legal regulations regarding the use of child safety seats.
•
If this is not done, a child seated on
the front passenger seat may suffer
severe or even fatal injuries if the
front passenger airbag or airbags are
deployed.•
You should have the front passenger ai
rbag (or airbags) reactivated just
as soon as you no longer use a child sa
fety seat on the front passenger seat.
Child safety seats in Group 1Child seats in Group 1 are for babies and sm
all children up to 4 years of age with a
weight of between 9 and 18 kilograms. It is
best for children in the lower range of
this group, to use a child seat which allows
the child to sit with its back to the direc-
tion of travel. It is best for children in the upper range of the Group 0+, to use a child seat which allows the child to sit
⇒fig. 134
in the direction of travel.
Child safety seats in which the child is seat
ed with its back facing the direction of
travel, must not be used on the front passenger seat
⇒page 124, “Use of child
safety seats on the front passenger seat”.
WARNING
•
It is essential to always switch of
f the front passenger airbag (airbags)
when attaching in exceptional circumstances a child safety seat on the front
Fig. 133 Child seats of group 0/0+
WARNING (continued)
Fig. 134 Child seat with padded table in Group 1 installed on rear seat bench facing the direction of travel
s2g8.b.book Page 127 Tuesday, April 7, 2009 8:53 AM
Page 129 of 224
Transporting children safely
128
passenger seat where the child is seated
with its back facing in direction of
travel (in some countries also when the
child is facing the direction of travel).
− in a specialist garage − or by using the switch for
the front passenger airbag*
⇒page 121.
•
In certain countries national legal provisions require that besides the
front passenger airbag also the front pa
ssenger side airbag is deactivated.
Please comply with any differing nati
onal legal regulations regarding the
use of child safety seats.•
If this is not done, a child seated on the front passenger seat may suffer
severe or even fatal injuries if the
front passenger airbag or airbags are
deployed.•
You should have the front passenger ai
rbag (or airbags) reactivated just
as soon as you no longer use a child sa
fety seat on the front passenger seat.
Child safety seats in Group 2For children up to about 7 years of age
weighing between 15 and 25 kg the optimal
solution is a child safety seat in comb
ination with the three-point seat belt
⇒ fig. 135
.
WARNING
•
When transporting a child on the front passenger seat, please comply
with the appropriate national regulati
ons regarding the use of child safety
seats. If required, the airbag has to be deactivated,
− in a specialist garage − or by using the switch for the front passenger airbag*
⇒page 121.
•
The shoulder part of the seat belt
must run approximately across the
middle of the shoulder and fit snugly agai
nst the chest. It must on no account
run across the neck. The lap part of the seat belt must run across the pelvis and fits snugly; it must not run over the belly. Tighten the belt webbing over your hip if necessary.•
Please comply with any differing nati
onal legal regulations regarding the
use of child safety seats.Child safety seats in Group 3For children of about 7 years of age weighi
ng between 22 and 36 kg and of a height
of less than 150 cm, the optimal solution
is a child safety seat (seat bolster) in
combination with the three-point seat belt
⇒fig. 136
.
Children of more than 150 cm in height may use the seat belts fitted to the vehicle without a seat bolster.
WARNING (continued)
Fig. 135 Child seat in Group 2 installed on the rear seat facing the direction of travel
Fig. 136 Child seat in Group 3 installed on the rear seat facing the direction of travel
s2g8.b.book Page 128 Tuesday, April 7, 2009 8:53 AM
Page 130 of 224
Transporting children safely
129
Using the system
Safety
Driving Tips
General Maintenance
Breakdown assistance
Technical Data
WARNING
•
When transporting a child on the front passenger seat, please comply
with the appropriate national regulations regarding the use of child safety seats. If required, the airb
ag has to be deactivated,
− in a specialist garage − or by using the switch for the front passenger airbag*
⇒page 121.
•
The shoulder part of the seat belt must run approximately across the
middle of the shoulder and fit snugly against the chest. It must on no account run across the neck. The lap part of the seat belt must run across the pelvis and fits snugly; it must not run over th
e belly. Tighten the belt webbing over
your hip if necessary.•
Please comply with any differing nati
onal legal regulations regarding the
use of child safety seats.Attaching a child seat us
ing the “ISOFIX” system
There are two locking eyes between th
e rear exterior seat backrest and
the surface of the seat itself
on both sides for fixing the
ISOFIX
system
child seat in place. One can mount
a child safety seat using the
ISOFIX
system quickly, easily and reliably.
The installation must be carried out
according to the supplied instructions. The seat must click into place audibly when installing. Install child seat – Insert the mounting funnels onto the locking eyes between the seat
backrest and the seat cushion
⇒
fig. 137
.
– Push the notched arms of the chil
d seat over the mounting funnels
into the locking eyes, until it is heard to lock
⇒
fig. 138
.
–
Pull on both sides of the child seat!
One can mount a child safety seat using the “ISOFIX” system quickly, easily and reli- ably. Please pay close attention to instruct
ions from the manufacturer of the child
safety seat when installing and removing the seat. Child seats fitted with the “ISOFIX” syst
em can only be mounted and fixed in a
vehicle fitted with an “ISOFIX” system when
these child seats have been released for
this type of vehicle according to the ECE-R 44 standard. You can obtain child seats with the “ISOFIX” attachment system from specialist garages who will also installed it as well.
Fig. 137 Locking eyes (ISOFIX system)
Fig. 138 The ISOFIX child seat is pushed into the mounting funnels
s2g8.b.book Page 129 Tuesday, April 7, 2009 8:53 AM