Radio3
WARNING
Please always pay full attention to the traffic situation around you! As the driver you are fully responsible for the traffic safety. Only use the functions in such a way that you always maintain the control over your vehicle in all traffic situations!
Using the display
Carefully handle the display because dent s and scratches can occur through pres- sure of the finger or contact with sharp objects.
The display can be cleaned with a soft cl oth and finger marks can be wiped away with pure alcohol.
Note
Do not use solvent such as turpentine or petrol as they will corrode the display surface.
Anti-theft protection
Anti-theft coding
Your radio is equipped with a convenience co ding. If the radio is being operated for the first time, the safety code is not only stored in the radio but also in the vehicle.
After disconnecting and reconnecting the batte ry, first of all switch on the ignition and then the radio.
If you wish to install the radio in another vehicle, the safety code must be entered. In this case, please do not hesitate to contact a Škoda Service Partner or a Škoda importer.
As the unit only functions after entering the safety code, this practically excludes its use after a theft - a contribution to increased anti-theft safety.
Note
The code is stored in the instrument cl uster. Through this it is automatically decoded (convenience coding). A manual entry of the code is normally not necessary.
Code entry
– Switch on the radio if the ignition is on. SAFE is displayed and then
0000 .
– Enter the safety code using the station keys .
– Confirm the safety code by pressing the button .
If you have confirmed a wrongly entered co de, you can repeat once again the entire process.
If the code number is entered incorrectl y for the second time, the unit will be blocked for approx. one hour. It is only po ssible to repeat the entry of the safety code after an hour has expired and while the unit is switched on and the ignition key remains in the ignition lock.
The cycle - two attempts, blocked for an hour - furthermore applies.
Basic setting
Switching the unit on and off
– The system is switched on or off by pressing the rotary/push knob .
If the key is pulled out of the ignition lock when the system is switched on, the system switches off automatically. You can switch on again the unit by pressing the rotary/push knob . If the engine is switch ed off, the unit (protection of the vehicle battery before discharging) switches of f automatically after approx. one hour.
A12
A1
A1
s1uk.3.book Page 3 Wednesday, May 2, 2007 11:07 AM
Radio4
If you have switched off the radio by withdrawing the ignition key, the radio switches on again once the ignition is on.
Audio settings
– Select the desired parameter after pressing the button and then
the station key .
– Set the desired value by turning the rotary/push knob .
You can select the following parameters:
•TREBLE - treble setting;
•MIDTONE - midtone setting;
•BASS - bass setting;
•LO U D - in case of low volume level, this function reinforces the range of bass and treble frequencies;
•MONO .
The selection OFF of the stereo coder is automatically regulated. If the signal is strong, a stereo reception is made.
The selection ON - under certain circumstances the reception of the stereo signals can be distorted, even if the signal is strong. e.g. while driving through urbanization. The stereo coder is deactivated and the re ception quality is clearly improved by activating the force Mono reception.
Note
The text on the display goes out 10 seconds after the last press. After pressing any button, except the station keys , the sett ing is finished and the selected values are stored.
Second level of the audio settings
– You can call up the second level of the audio settings by pressing the
button and by subsequently pressing the station key .
You can select between the following parameters:
•BALANCE - setting of the volume ratio between the right and left side;
•FA D E R - setting of the volume ratio between the front and the rear.
Third level of the audio settings
– You can call up the third level of the audio settings by pressing the
station key again.
You can select between the following parameters:
GALA
Your radio increases automatically its volume with the increasing vehicle speed. A higher setting value results in a stronger volume increase.
PDC VOL
If your vehicle is equippe d with “parking aid”, the volume is automatically decreased to a pre-defined value, when the “parking aid” is active.
PH VOL
If your vehicle is equipped with a handsfree system, you can set the desired volume of the mobile phone calls.
TA VO L
The setting of the minimum volume for receivable traffic reports.
The volume is increased by the value set by this parameter, if its current value is lower. Otherwise the volume is not changed.
A12
A1
A12
A12
A12
s1uk.3.book Page 4 Wednesday, May 2, 2007 11:07 AM
