2009 SATURN ASTRA height adjustment

Seats and
Restraints
Front Seats
Manual Seats.....................1-2
Seat Height Adjuster...........1-2
Lumbar Seat Adjustment. . . .1-3
Reclining Seatbacks...........1-3
Head Restraints..................1-5
Heated Seats.....................1-6
Rear Seats
Rear Seat Operation...........1-7
Safety Belts
Safety Belts........................1-8
How to Wear Safety
Belts Properly..................1-12
Lap-Shoulder Belt.............1-18
Safety Belt Use During
Pregnancy.......................1-22
Safety Belt Extender.........1-22
Safety Belt Check.............1-22
Care of Safety Belts.........1-23
Replacing Safety Belt
System Parts After a
Crash
..............................1-23
Airbag System
Airbag System..................1-24
Where Are the Airbags?. . .1-26
When Should an Airbag
Inate?............................1-27
What Makes an Airbag
Inate?............................1-28
How Does an Airbag
Restrain?........................1-28
What Will You See After
an Airbag Inates?..........1-29
Passenger Sensing
System............................1-30
Servicing Your
Airbag-Equipped
Vehicle
............................1-35
Adding Equipment to
Your Airbag-Equipped
Vehicle
............................1-36
Airbag System Check.......1-37
Replacing Airbag System
Parts After a Crash.........1-37
Child Restraints
Older Children..................1-38
Infants and Young
Children..........................1-40
Child Restraint Systems. . . .1-43
Where to Put the
Restraint.........................1-44
Lower Anchors and
Tethers for Children
(LATCH)
..........................1-46
Replacing LATCH System
Parts After a Crash...........1-50
Securing Child Restraints
(Rear Seat).....................1-51
Securing Child Restraints
(Right Front Seat)...........1-53
Seats and Restraints 1-1
ProCarManuals.com

Lap-Shoulder Belt
All seating positions in the vehicle
have a lap-shoulder belt.
The following instructions explain
how to wear a lap-shoulder belt
properly.
1. Adjust the seat, if the seat is
adjustable, so you can sit up
straight. To see how, see “Seats”
in the Index.
2. Pick up the latch plate and pull
the belt across you. Do not let
it get twisted.The lap-shoulder belt may lock if
you pull the belt across you
very quickly. If this happens,
let the belt go back slightly
to unlock it. Then pull the belt
across you more slowly.
If the shoulder portion of a
passenger belt is pulled out all
the way, the child restraint
locking feature may be engaged.
If this happens, let the belt go
back all the way and start again.
3. Push the latch plate into the
buckle until it clicks.Pull up on the latch plate to
make sure it is secure. If the belt
is not long enough, seeSafety
Belt Extender on page 1-22.
Position the release button on
the buckle so that the safety belt
could be quickly unbuckled if
necessary.
4. If equipped with a shoulder belt
height adjuster, move it to the
height that is right for you.
See “Shoulder Belt Height
Adjustment” later in this section
for instructions on use and
important safety information.
5. To make the lap part tight,
pull up on the shoulder belt.
1-18 Seats and Restraints
ProCarManuals.com

To unlatch the belt, push the button
on the buckle. The belt should return
to its stowed position. When the
safety belt is not in use, slide the
latch plate up the safety belt
webbing.
Before a door is closed, be sure the
safety belt is out of the way. If a
door is slammed against a safety
belt, damage can occur to both the
safety belt and the vehicle.
Shoulder Belt Height Adjuster
The vehicle has a shoulder belt
height adjuster for the driver and
right front passenger seating
position.
Adjust the height so that the
shoulder portion of the belt is
centered on the shoulder. The belt
should be away from the face
and neck, but not falling off the
shoulder. Improper shoulder
belt height adjustment could reduce
the effectiveness of the safety
belt in a crash.To move it, squeeze the button on
the front of the height adjuster to
release the locking feature and move
the height adjuster to the desired
position.
After the adjuster is set to the
desired position, try to move it
down without squeezing the
release button to make sure it
has locked into position.
Seats and Restraints 1-19
ProCarManuals.com

Rear disc brake pads do not have
built-in brake pad wear indicators.
Periodic visual inspection of the rear
brake pads is required to determine
when to replace the pads. Visually
inspect the rear brake pads
whenever the rear wheels are
removed such as during tire rotation.
1. Set the parking brake and make
sure that the brakes have been
given enough time to cool.
2. Remove the rear wheels.
3. Visually inspect the rear brake
inner pads (C) at each rear
wheel through the inspection
window in the brake caliper (A).Brake pads should be replaced
when the inner pad (C) is
worn to 5/64 in (2 mm) of pad
thickness (B). New brake pads,
with no wear, are 25/64 of
an inch (10 mm) thick.
4. After brake pad inspection or
replacement, install the rear
wheels.
Some driving conditions or climates
can cause a brake squeal when
the brakes are rst applied or
lightly applied. This does not mean
something is wrong with the brakes.Properly torqued wheel bolts are
necessary to help prevent brake
pulsation. When tires are rotated,
inspect brake pads for wear
and evenly tighten wheel bolts in
the proper sequence to torque
specications inCapacities
and Specifications on page 10-2.
Brake linings should always
be replaced as complete axle sets.
Brake Pedal Travel
See your dealer/retailer if the brake
pedal does not return to normal
height, or if there is a rapid increase
in pedal travel. This could be a
sign that brake service might
be required.
Brake Adjustment
Every brake stop, the disc brakes
adjust for wear.
9-24 Vehicle Service and Care
ProCarManuals.com

4. At a wall, measure from the
ground upward (A) to the
recorded distance from Step 3
and mark it.
5. Draw or tape a horizontal line (B)
on the wall the width of the
vehicle at the height of the mark
in Step 4.Notice:Do not cover a headlamp
to improve beam cut-off when
aiming. Covering a headlamp may
cause excessive heat build-up
which may cause damage to the
headlamp.
6. Turn on the low-beam headlamps
and place a piece of cardboard
or equivalent in front of the
headlamp not being adjusted.
Do not place it directly on
the headlamp. This allows only
the beam of light from the
headlamp being adjusted to be
seen on the at surface.7. Locate the vertical headlamp
aiming screws, which are
under the hood near each
headlamp assembly.
The adjustment screw can be
turned with a 6 mm socket
wrench.
8. Turn the vertical aiming screw
until the headlamp beam is
aimed to the horizontal
tape line. Turn it clockwise or
counterclockwise to raise
or lower the angle of the beam.
Vehicle Service and Care 9-27
ProCarManuals.com

S
Safety Belt Reminders..........4-13
Safety Belts.......................... 1-8
Care of ...........................1-23
Check.............................1-22
How to Wear Safety
Belts Properly...............1-12
Lap-Shoulder Belt.............1-18
Replacing Parts After a
Crash..........................1-23
Safety Belt Extender.........1-22
Safety Belt Use During
Pregnancy....................1-22
Scheduled Maintenance........11-3
Seats
Head Restraints................. 1-5
Heated Seats - Rear........... 1-6
Height Adjuster.................. 1-2
Lumbar Adjustment............. 1-3
Rear Seat Operation........... 1-7
Reclining Seatbacks............ 1-3
Securing Child
Restraints................1-51, 1-53Service................................ 9-2
Accessories and
Modications.................. 9-3
Adding Equipment to the
Outside of the Vehicle..... 9-4
California Perchlorate
Materials Requirements.... 9-3
California Proposition 65
Warning......................... 9-3
Doing Your Own Work........ 9-4
Engine Soon Lamp...........4-18
Owner Checks................... 9-4
Publications Ordering
Information.................12-15
Vehicle Soon Light............4-23
Service, Scheduling
Appointments...................12-8
Servicing Your
Airbag-Equipped Vehicle....1-35
Sheet Metal Damage............9-79
Shifting Into Park.................8-11
Shifting Out of Park..............8-12
Signals, Turn and
Lane-Change..................... 4-8Spare Tire
Compact.........................9-68
Installing..........................9-63
Removing........................9-62
Storing............................9-66
Specications, Capacities......10-2
Speedometer.......................4-13
StabiliTrak
®Indicator Light.....4-17
StabiliTrak®System..............8-19
Starting the Engine................ 8-3
Steering..............................8-20
Steering Wheel Controls,
Audio..............................6-23
Steering Wheel, Tilt Wheel...... 4-4
Storage Areas
Cupholders........................ 3-1
Glove Box......................... 3-1
Sunglasses Storage
Compartment.................. 3-1
Stuck in Sand, Mud, Ice, or
Snow..............................8-29
Sun Visors..........................2-11
Sunroof..............................2-12
i-8 INDEX
ProCarManuals.com