2009 RENAULT TWINGO fuel pressure

17B-9
PETROL INJECTION
Petrol injection: List and location of components
K4M
17B
131776
(1) Fuel vapour absorber bleed
solenoid valve
(2) Camshaft dephaser solenoid
valve
(3) Air inlet pressure sensor
(4) Coil
(5) Throttle valve
(6) Petrol injection computer
(7) Switching protection unit
(8) Coolant temper ature sensor
(9) Camshaft position sensor
(10) Pinking sensor
(11) Oil pressure sensor
(12) Air temperature sensor
(13) Injector rail
131766
(1) Fuel vapour absorber bleed
solenoid valve

19A-43
COOLING
Water chamber: Removal - Refitting
K9K
19A
aRemove the air filter unit (see 12A, Fuel mixture,
Air filter unit: Removal - Refitting, page 12A-13) .
aPull the intercooler air inlet pipe clip (1) at the turbo-
charger end.
aDisconnect the intercooler air inlet pipe (2) at the tur-
bocharger end.
aRemove the nut (3) from the intercooler air inlet pipe
at the turbocharger end.
aMove aside the intercooler air inlet pipe (2) at the tur-
bocharger end.
aRemove the nut (4) from the intercooler air outlet
pipe at the damper valve end.
aDisconnect the turbocharging pressure regulator
vacuum pipe (5) .
aUnclip:
-the turbocharging pressure regulator vacuum pipe
at (6) ,
-the brake servo vacuum pipe at (7) .
aDisconnect the brake servo vacuum pipe (8) .
aLoosen the clamp (9) for the air-air intercooler air
outlet pipe at the damper valve end.
aDisconnect the intercooler air outlet pipe (10) at the
damper valve end.
aMove aside the intercooler air outlet pipe (10) at the
damper valve end. K9K, and 718
141222
141213
141217

19D-14
ENGINE MOUNTING
Right-hand suspended engine mounting: Removal - Refitting
C44, and K9K
19D
aRemove:
-the right-hand suspended engine mounting bolts
(3) on the engine,
-the right-hand suspended engine mounting bolts
(4) on the body,
-the right-hand suspended engine mounting.
REFITTING
I - REFITTING OPERATION FOR PART
CONCERNED
aRefit:
-the right-hand suspended engine mounting,
-the right-hand suspended engine mounting bolts
on the body,
-the right-hand suspended engine mounting bolts
on the engine.
aTighten all bolts on the suspended engine mounting
until they make contact.
aTorque tighten:
-the right-hand suspended engine mounting
bolts on the engine (62 Nm),
-the right-hand suspended engine mounting
bolts on the body ( 62 Nm).
aFit the clip to the right-hand suspended engine
mounting.
aPosition the fuel filter cage.aRefit the fuel filter cage bolts.
aPosition the fuel filter.
aTighten the fuel filter cage nut.
aClip on the fuel pipes.
II - FINAL OPERATION.
aRefit the expansion bottle bolt.
aRemove the (Mot. 1672).
aTighten the new bolts on the axle sub-frame until
they make contact.
aTorque tighten:
-the axle sub-frame front bolts (62 Nm),
-the axle sub-frame rear bolts (105 Nm).
120047
Note:
Make sure that the clip on the high pressure
pump side is proper ly clipped onto the right-hand
suspended engine mounting.