86A-9
MR-413-X44-86A000$504_eng.mif
V1
86A
RADIO
Anti-theft code
The radio is protected by a four digit code. This code must be entered via the control satellite or the radio keypad
each time the battery is disconnected.
Entering the code with the control on the steering wheel:
Press the lower button on the control to confirm an entry.
Entering the code using the radio:
Enter the digits using buttons 1, 2, 3 and 4, and then confirm with button 6.
If the code is entered incorrectly, the radio will be locked (1 minute for the first error, 2 minutes for the second error,
4 minutes for the third error, etc. 32 minutes maximum).
Some configurations must be programmed after the code has been entered for the first time (see configuration -
settings). These settings are stored when the battery is disconnected.
Reminder:
The radio will operate for approximately 2 minutes in scrambled mode without the code having been entered (with
regular warning bleeps).
If the vehicle is equipped with a CD changer in the front panel, a code is exchanged between the CD changer and
the radio.
–If a new CD changer is fitted, the radio code is programmed when the battery or CD changer is connected.
–If the radio is replaced, enter the security code of the old radio connected to the CD changer. The CD changer is
programmed with the code for the new radio.
–If the old radio code is lost, the changer code can be cleared using the clearing code. The clearing code is sent by
the Techline.
Note:
If there is a configuration error, you can return to scrambled mode by pressing the 2 and 5 buttons at the same
time as switching the power on. Then wait 2 minutes.
Note:
The CD changer is supplied uncoded. When it is installed in the vehicle, the CD changer is programmed with the
radio supply code.
Reminder:
The radio will operate for approximately 2 minutes in scrambled mode without the code having been entered
(with regular warning bleeps).
MR-413-X44-86A000$504_eng.mif
86A-37
MR-413-X44-86A000$945_eng.mif
V1
86A
RADIO
Recovering a jammed CD
First solution
If the electric ejector motor is operational, eject the CD
using a 4.5 V battery to supply the electric motor (B)
(attach the + wire to contact (1) and the - wire to
contact (2) when ejecting the CD).
Second solution
If the electric ejector motor is not operational, remove
the screw (C) and release the electric motor (B) from
the radio.Turn toothed wheel (D) by hand in a clockwise
direction until the CD is ejected.
Before replacing the radio:
●refit the electric motor and attach it using the bolt
(second solution only),
●refit the casing.
RADIO
MR-413-X44-86A000$945_eng.mif
86A-41
MR-413-X44-86A000$945_eng.mif
V1
RADIO
Recovering a jammed CD86A
Remove:
–the three bolts (1) located underneath the unit,
–the two springs (2) after moving them to the top
position.Remove the electronic module from the support and fit
it to the side.
First solution
If the electric motors are operating:
1. Reinsert the CD and its drawer into the changer (4)
using a 4.5 V battery to supply the electric motor (3),
(attach the + wire to contact (1) and the - wire to
contact (2)).
2. Eject the changer by moving lever (4).
CHANGER IN THE BOOT
