Downloaded from www.Manualslib.com manuals search engine
5.30
ENG_UD12592_2Batterie : dépannage (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5
Start the engine as you would normally. As soon as it is running, disconnect
leads A and B in the reverse order (5-4-3-2).
Attach the positive lead A on support 1 to terminal 2 (+) of the discharged bat- tery, then to terminal 3 (+) of the bat- tery supplying the current.
Attach negative lead B to terminal 4 (–) of the battery supplying the current, then to terminal 5 (–) of the discharged battery.
Starting the vehicle using the
battery from another vehicle
Proceed as follows when starting your vehicle from another vehicle’s battery:
Obtain suitable jump leads (large) from an approved Dealer or, if you already have jump leads, ensure that they are in perfect condition.
The two batteries must have an iden- tical nominal voltage of 12 volts. The battery supplying the current should have a capacity (amp-hours, Ah) which is at least the same as that of the dis- charged battery.
Ensure that there is no risk of contact between the two vehicles (risk of short circuiting when the positive terminals are connected) and that the discharged battery is properly connected. Switch off your vehicle ignition.
Start the engine of the vehicle supply- ing the current and run it at an interme- diate engine speed.
BATTERY: troubleshooting (4/4)
A
4
B
3
25
1
1
Leads A and B must only be con- nected to the terminals indicated.
Check that there is no con-
tact between leads A and B
and that the positive lead A is not touching any metal parts on the vehicle supplying the current.
Risk of injury and/or damage to the vehicle.
