2009 RENAULT CLIO lock

Downloaded from www.Manualslib.com manuals search engine
5.4
ENG_UD10596_1Roue de secours (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5

JauneNoirNoir texte

Note: if the tool kit does not lock in
place, check the tightness of nut 5 and
the correct positioning of the handle 6.
Special features
The emergency spare wheel holder should always be present when you are driving even when the wheel itself is not present: risk of water entering the ve- hicle.
If you have to release it when it is not holding a wheel, push the centre of the wheel holder towards the ground while pressing handle 6.
To lock the system
– Press nut 5 screwing it on fully until it locks in place. Several turns will be necessary. This operation is es- sential to ensure that the wheel is secure;
– return handle
6 to its original posi- tion;
– clip the tool kit;
– replace the cover, then lower it and
replace the luggage compartment carpet.
EMERGENCY SPARE WHEEL (3/4)
The system should only be used with the original ve- hicle wheels or identical wheels.
It is essential to lock the nut so that the wheel is held se- curely.
6
5

Downloaded from www.Manualslib.com manuals search engine
tool kit ...................................................(up to the end of the DU)hubcap tool ...........................................(up to the end of the DU)jack .......................................................(up to the end of the DU)wheelbrace ...........................................(up to the end of the DU)towing hitch...........................................(up to the end of the DU)wheelbrace ...........................................(up to the end of the DU)puncture................................................(up to the end of the DU)
5.9
ENG_UD12590_2Bloc-outils (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5
End piece for special wheel
bolt
3(depending on vehicle)
Towing hitch 4Refer to the information on “Towing” in Section 5.
Hubcap tool 5 or 6This tool is used to remove the wheel trims.
Jack 7Remove jack 7.To refit, lower the jack fully and unscrew it by one turn and pivot the base so that it can be stored.
Storage compartment 1(depending on vehicle)
This is for storing a lock nut.
Wheelbrace 2This is used to tighten or release the wheel bolts.
Tool kit

A is located in the tray under the luggage compartment carpet.Depending on the vehicle, lift the cover, then remove it.Take out the tool kit, lifting it at both ends.To return it, proceed in the reverse order to removal.
TOOL KIT
Tool kit (jack, wheelbrace, etc.)
1
A
7
2
3
4
56
Do not leave the tools unsecured inside the vehicle as they may come loose under braking. After use, check that all the tools are correctly clipped into the tool kit, then position it correctl\
y in its housing: there is a risk of injury.If wheel bolts are supplied in the tool kit, only use these bolts for the emergency spare wheel: refer to the label affixed to the emergency spare wheel.
The jack is designed for wheel changing purposes only. Under no circumstances should it be used for carrying out repairs un- derneath the vehicle or to gain access to the underside of the vehicle.

Downloaded from www.Manualslib.com manuals search engine
5.26
ENG_UD12591_2Fusibles (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5
Some accessories are protected by fuses located in the engine compart- ment.
However, due to their reduced acces- sibility, we advise you to have your fuses replaced by an approved Dealer.
FUSES (2/2)
Allocation of fuses(the presence of certain fuse depends on the vehicle equipment level)
SymbolAllocation
2Rear door locking/child safety
hElectric windows
ÚPassenger compartment ventilation
ALIM UCHGeneral supply or courtesy lights
NCentral door locking
ÙEngine immobiliser or indicators
fRear screen wiper or not used
Z
Interior lightingWiper with automatic operation/Automatic lighting or not used
ßBrake lights
îRadio
SymbolAllocation
tClimate control
yManual air conditioning
ÆFront cigar lighter
nABS/ESP
hDriver-controlled windows or not used
æDriver’s window winder
ÌHorn
gElectric door mirrors
aAutomatic climate controlinstrument panel
Indicator or rear screen wiper

Downloaded from www.Manualslib.com manuals search engine
battery...................................................(up to the end of the DU)
5.27
ENG_UD12592_2Batterie : dépannage (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5
To avoid all risk of sparks:
– ensure that any consumers are switched off before disconnecting or reconnecting the battery;
– when charging, stop the charger
before connecting or disconnecting the battery;
– to avoid creating a short circuit be
- tween the terminals, do not place metal objects on the battery;
– always wait at least one minute after

the engine has been switched off before disconnecting a battery;
– make sure that you reconnect the
battery terminals after refitting.
Battery
Refitting the battery covers
– position cover C in its hinges and clip it in place;
– then position cover
B in its hinges and clip it in place;
Check that the two covers
B and C are correctly locked.
Depending on the vehicle, reposition block A, clipping first the rear, then the front. Ensure it is correctly locked in place.
Access to the battery
Depending on the vehicle, press tab 1
and tilt block A backwards to unclip it.
Unclip cover
B and remove it, then
unclip cover C and remove it.
BATTERY: troubleshooting (1/4)
AB
C
1
The engine may be hot during operations in close proximity. In addition, the engine cooling fan may
start at any moment.
Risk of injury.

Downloaded from www.Manualslib.com manuals search engine
5.28
ENG_UD12592_2Batterie : dépannage (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5

JauneNoirNoir texte

Depending on the battery, reposition
block A in the runners and slide it until it
is positioned between the two marks 1.
Pull block
A slightly to the right to clip it
on pin E, press, and check that it locks properly.
Refitting the battery covers
– position cover C in its hinges and clip it in place;
– then position cover
B in its hinges and clip it in place;
Check that the two covers
B and C are correctly locked.
Access to the battery
Depending on the vehicle, in the engine compartment:
– lift block
A to unclip it, then, while
holding pipe D , slide block A towards you;
– unclip cover
B and remove it;
– then unclip cover
C and remove it.
BATTERY: troubleshooting (2/4)
D
A
B
C
E
1
Handle the battery with care as it contains sulphuric acid, which must not come into contact with eyes or skin. If it does, wash the affected area with
plenty of cold water. If necessary, consult a doctor.
Ensure that naked flames, red hot objects and sparks do not come into contact with the battery as there is a risk of explosion.

Downloaded from www.Manualslib.com manuals search engine
JauneNoirNoir texte

5.29
ENG_UD12592_2Batterie : dépannage (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5

BATTERY: troubleshooting (3/4)
Special procedures may be required to charge some batteries. Contact your ap- proved Dealer.
Avoid all risk of sparks which may cause an immediate explosion and charge the battery in a well-venti- lated area. Risk of serious injury.
If your vehicle is to be left stationary for a relatively long time, disconnect the battery or have it recharged regularly, particularly during cold weather. It will then be necessary, with the engine run- ning, to move the steering wheel slowly, from lock to lock and to reprogram the electronic equipment with a memory feature, radio, etc. The battery should be stored in a cool and dry location pro- tected from frost.
Note: if you have disconnected or re- charged a battery, move the steering wheel slowly from lock to lock to reset the system.
Have the battery’s charge status checked regularly:
– especially if you use your vehicle for
short journeys or for frequent driving in town;
– when the exterior temperature drops
(in winter), the charge decreases. In winter, only use the electrical equipment that is really necessary;
– finally, you should understand that
the charge decreases naturally as a result of certain permanent electrical consumers such as the clock, after- sales accessories, etc.
When many accessories are fitted to the vehicle, have them connected to the + after ignition feed. In this case, it is advisable to have your vehicle fitted with a battery which has an increased nominal capacity. Contact an approved Dealer.
Connecting a battery charger
The battery charger must be com- patible with a battery with nominal voltage of 12 volts.
Switch the engine off and then discon- nect both battery leads starting with the negative terminal.
Do not disconnect the battery when the engine is running. Follow the instruc- tions given by the manufacturer for the battery charger you are using.
Only a fully charged and well-main- tained battery will have a long and useful life and enable you to start the vehicle’s engine normally.
The battery must be kept clean and dry.

Downloaded from www.Manualslib.com manuals search engine
wiper blades .........................................(up to the end of the DU)wipersblades .............................................(up to the end of the DU)
5.35
ENG_UD12593_2Balais d essuie-vitres (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5
Wipers (replacing blades)
Lower tab 3, by pressing on either
side A.
Then push the blade forwards
B, to re-
lease hook 4.
To refit
To refit the wiper blade, proceed in re- verse order to removal. Make sure that the blade is correctly locked in posi- tion.
Replacing windscreen wiper
blades
1
– With the ignition off, lift wiper arm 2;
– turn blade
1.
Driver’s side special note: stop turning before it touches the bonnet.
WINDSCREEN WIPER BLADES (1/2)
2
1
4
3B
A
A
– In frosty weather, make sure that the wiper blades are not stuck by ice (to avoid the risk of the motor overheating).
– Check the condition of the wiper
blades.Replace the wiper blades as soon as they begin to lose efficiency (approximately once a year).
Whilst changing the blade, take care not to drop the arm onto the window after it has been removed as this may break the window.
Check the condition of the wiper blades. You are responsible for their service life:
– clean the blades, windscreen and
rear screen regularly with soapy water;
– do not use them when the wind
- screen or rear screen are dry;
– free them from the windscreen or

rear screen when they have not been used for a long time.

Downloaded from www.Manualslib.com manuals search engine
5.36
ENG_UD12593_2Balais d essuie-vitres (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_5
To refit
To refit the wiper blade, proceed in re- verse order to removal. Make sure that the blade is correctly locked in posi- tion.
Rear screen wiper blade 5
– With the ignition off, lift wiper arm 6;
– pivot blade
5 until some resistance is met;
– remove the blade by pulling it.
WINDSCREEN WIPER BLADES (2/2)
5
6
– In frosty weather, make sure that the wiper blades are not stuck by ice (to avoid the risk of the motor overheating).
– Check the condition of the wiper
blades.Replace the wiper blades as soon as they begin to lose efficiency (approximately once a year).
Whilst changing the blade, take care not to drop the arm onto the window after it has been removed as this may break the window.
Check the condition of the wiper blades. You are responsible for their service life:
– clean the blades, windscreen and
rear screen regularly with soapy water;
– do not use them when the wind
- screen or rear screen are dry;
– free them from the windscreen or
rear screen when they have not been used for a long time.