2009 RENAULT CLIO ignition

Downloaded from www.Manualslib.com manuals search engine
1.54
ENG_UD10344_1Tableau de bord : témoins lumineux (X85 - B85 - C85 - S85 - K85 - Ren\
ault)ENG_NU_853-3_BCSK85_Renault_1

JauneNoirNoir texte

INSTRUMENT PANEL: warning lights (3/4)
The presence and operation of the warning lights DEPEND ON THE EQUIPMENT\
AND COUNTRY.
ùWarning light for Electronic Stability Program (ESP) and traction control system (ASR).
This lights up when the ignition is switched on and goes out after a few seconds.
There are several reasons for the warn- ing light coming on: refer to the informa- tion on the “Electronic Stability Program: ESP” and “Traction control: ASR” in Section 2.
ÚBattery charge warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it comes on when the vehicle is being driven, and is accompanied by the
® warning light and a beep, it in- dicates that the electrical circuit is over- charged or undercharged.
Stop as soon as traffic conditions allow and contact an approved Dealer.
ÄToxic Fume Filter System Warning Light
For vehicles equipped with this option, the light comes on when the ignition is switched on then goes out.
– If it lights up continuously, consult
your approved dealer as soon as possible;
– if it flashes, reduce the engine speed until the light stops flashing. Contact your approved Dealer as soon as possible.Refer to the information on “Advice: antipollution, fuel economy and driving” in Section 2.
DHandbrake on and brake cir-cuit incident warning light
This comes on when the ignition is switched on and goes out as soon as the handbrake is released.If it comes on during braking and is ac-
companied by the ® warning light and a beep, it indicates that the fluid level in the circuit is low or that there is a braking system fault.
Stop as soon as traffic conditions allow and contact an approved Dealer.
èAutomatic gearbox opera- tional warning lights
R e f e r t o i n f o r m a t i o n o n “ A u t o m a t i c g e a r b o x ” a n d “ Q u i c k s h i f t g e a r b o x ” i n
Section 2.
c
A
ê
ÜParticle filter warning light
Refer to the information on “Special features of diesel versions with particle filter” in Section 2.
A

Downloaded from www.Manualslib.com manuals search engine
JauneNoirNoir texte

1.55
ENG_UD10344_1Tableau de bord : témoins lumineux (X85 - B85 - C85 - S85 - K85 - Ren\
ault)ENG_NU_853-3_BCSK85_Renault_1

INSTRUMENT PANEL: warning lights (4/4)
The presence and operation of the warning lights DEPEND ON THE EQUIPMENT\
AND COUNTRY.
ÀOil pressure warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it comes on when you are driving ac-
companied by the ® warning light
and a beep, it is essential to stop and switch off the ignition.
Check the oil level. If the level is normal, the indicator light is being lit by something else. Contact an approved Dealer.
ÒElectronic fault warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it comes on when driving, it indicates a fault in the injection computer or the automatic transmission.
Contact your approved Dealer as soon as possible.
^Water in the diesel filter warning light
This lights up when the ignition is switched on and goes out after a few seconds.
If it comes on when driving, it indicates the presence of water in the diesel.
Contact your approved Dealer as soon as possible.
2
Door status warning light
A
ÉPreheating warning light (diesel version)
This should come on when the igni-tion is switched on. It indicates that the heater plugs are in operation.
It goes out when preheating is com-plete. The engine can be started.
ÆWarning light for serious in-jection fault
This lights up when the ignition is switched on and goes out after a few seconds.
If this light comes on when you are driv- ing, it indicates a fault in the injection system. Stop immediately, switch off the ignition and contact an approved Dealer.
UVa r i a b l e p o w e r - a s s i s t e d steering warning light
This comes on when the ignition is switched on and goes out after a few seconds.
If it lights up when you are driving, this indicates a fault in the system. Consult an approved Dealer as soon as possi- ble.

Downloaded from www.Manualslib.com manuals search engine
1.66
ENG_UD13453_3Ordinateur de bord (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1

JauneNoirNoir texte

Information messagesThese can help in the vehicle starting phase, or give information about \
a selection or a driving status.Examples of information messages are given in the following pages.
Examples of messagesInterpretation of messages
‘Tailgate open’Indicates that the tailgate has been left open.
‘Oil level OK’Indicates that the oil level is correct when the ignition is switched on\
.
‘Automatic lights OFF’Indicates that the automatic lights function is deactivated.
TRIP COMPUTER AND WARNING SYSTEM (8/10)

Downloaded from www.Manualslib.com manuals search engine
clock .....................................................(up to the end of the DU)clock .....................................................(up to the end of the DU)control instruments ...............................(up to the end of the DU)
1.69
ENG_UD10538_1Heure (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
Clock and exterior temperature
If the electrical supply is cut (battery disconnected, broken supply wire, etc.), the clock will lose its time set- ting.
The time must then be set.
We recommend that you do not adjust these settings while driving.
251772531425314
Then press and hold button 3 to con- firm the time set.
The minutes flash; repeatedly press or
press and hold button 2 to set them.
When setting is complete, the hours and minutes remain displayed continu- ously for 2 seconds: your setting is reg- istered.
You may change the display.
Display A
The time is displayed when the ignition is switched on.
To access display
1 for setting the time,
press button 2 or 3. Wait for a few sec- onds.
The hours and minutes flash and you are now in setting mode; press and
hold button 3 to set the hours.
When the hours flash, repeatedly
press or press and hold button 2, to set them.
CLOCK AND EXTERIOR TEMPERATURE (1/2)
A2
31

Downloaded from www.Manualslib.com manuals search engine
external temperature .............................................(current page)
1.70
ENG_UD10538_1Heure (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
Vehicles fitted with navigation aid systems, telephones, etc.
Refer to the separate instructions for the function to understand the special features of this equipment.
External temperature
indicator
Special note:
When the outside temperature is –3°C to +3°C, the °C characters flash (signal- ling a risk of ice on the road).
If the electrical supply is cut (battery disconnected, broken supply wire, etc.), the clock will lose its time set- ting.
The time must then be set.
We recommend that you do not adjust these settings while driving.
External temperature in- dicator
As ice formation is related to climatic exposure, local air humidity and temperature, the external temperature alone is not sufficient to detect ice.
Display B
The display B shows:
– the radio;
– the time;
– the exterior temperature.
The time and/or external tempera- ture are displayed when the ignition is switched on.
Resetting the clock
Press button:
H for the hours, M for the minutes.
CLOCK AND EXTERIOR TEMPERATURE (2/2)
B
H
M

Downloaded from www.Manualslib.com manuals search engine
rear view mirrors ...................................(up to the end of the DU)
1.72
ENG_UD10539_1Rétroviseurs (X85 - B85 - C85 - S85 - K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
JauneNoirNoir texte
Heated door mirrors
With the engine running, mirror de- icing is activated simultaneously with rear screen de-icing/demisting.
Rear view mirrors
The driver’s door mirror may have two clearly defined
zones. Zone B shows what can normally be seen in an
ordinary rear view mirror. Zone A in- creases rear side visibility.
Objects in zone A look much fur- ther away than they really are.
Electric door mirrors
With the ignition on, move button 2:
– position
C to adjust the left-hand door mirror;
– position
E to adjust the right-hand door mirror;
D is the inactive position.
Door mirrors with manual
adjustment
To adjust the mirror, move lever 1.
REAR VIEW MIRRORS (1/2)
AB
AB
D
C
F
E
2
1

Downloaded from www.Manualslib.com manuals search engine
lights:dipped beam headlights ...................................(current page)lighting:see-me-home ...................................................(current page)
1.76
ENG_UD10541_1Éclairages et signalisations extérieures (X85 - B85 - C85 - S85 -\
K85 - Renault)ENG_NU_853-3_BCSK85_Renault_1
JauneNoirNoir texte
EXTERIOR LIGHTING AND SIGNALS (2/5)
kDipped beam
headlights
Manual operation
Turn the end of stalk
1 until the symbol
is opposite mark 2.
An indicator light on the instrument panel will come on.
Automatic operation (depending on vehicle)
With the engine running, the dipped beam headlights are switched on or off automatically depending on the level of ambient light, without the need to oper-
ate stalk 1 (position 0).
This function can be deactivated or re- activated.
–
To activate it, with the ignition on,
press button 4 for at least four sec- onds. An instrument panel message confirms this action.
–
To deactivate it, with the ignition on and the vehicle stopped, press button 4 for at least four seconds. The ‘Auto lights OFF’ message is displayed on the instrument panel.
If stalk
1 is operated, it overrides and cancels the automatic function tempo- rarily.
See-me-home lighting
function
This function (useful, for example, for opening a gate, a garage, etc.) enables you to switch on dipped headlights mo- mentarily.
With the ignition off and the headlights
off, pull stalk 1 towards you: the dipped beam headlights come on for approxi- mately thirty seconds.
This action may be carried out no more than four times for a maximum lighting period of two minutes.
To switch off the lights before they go out automatically, turn the end of
stalk 1, then return it to position 0.
4
12

Downloaded from www.Manualslib.com manuals search engine
wipers ...................................................(up to the end of the DU)windscreen washer ...............................(up to the end of the DU)
1.81
ENG_UD10543_1Essuie-vitre / lave-vitre avant (X85 - B85 - C85 - S85 - K85 - Renault)\
ENG_NU_853-3_BCSK85_Renault_1
Wash/Wipe
Vehicles with automatic wiper
function
With the engine running, move
stalk 1
–
A park.
–
B automatic wiper functionWhen this position is selected, the system detects the presence of water on the windscreen and triggers wiping at a suitable wiping speed.It is possible to modify the sensitivity
by turning ring 2.
–
C normal wiping speed.
–
D fast wiping speed.Special note
When the vehicle is being driven, the wiping speed slows down whenever the vehicle stops. The speed will change from fast wiping speed to normal wiping speed.
As soon as the vehicle moves off, wiping will return to the speed originally selected.
Any action on stalk
1 overrides and cancels automatic operation.
With the ignition on, move stalk 1
–
A park.
–
B intermittent wipingThe wipers will pause for several seconds between sweeps. It is pos- sible to change the time between
sweeps by turning ring 2.
–
C normal wiping speed.
–
D fast wiping speed.
WINDSCREEN WASH/WIPE (1/2)
A
B
C
D
121
When working in the engine compartment, ensure that the windscreen wiper stalk
is in position A (park).
Risk of injury.