2009 Peugeot 407 low beam

1INSTRUMENTS and CONTROLS
23
Tyre under-infl ation detection
system warning light
This indicates the absence or mal-
function of one or more tyre pressure
sensors or a system fault.
Consult a PEUGEOT dealer.
Electronic engine
immobiliser warning light
This indicates an electronic engine im-
mobiliser system malfunction.
Consult a PEUGEOT dealer. Front brake pads wear
warning light
This indicates that the brake pads are
worn.
For your safety, have them replaced
by a PEUGEOT dealer.
Fuel tank cap warning light
(according to version)
With the engine running, this indicates
that the fuel tank cap is incorrectly se-
cured or absent.
It comes on in orange if the vehicle
speed is below 6 mph (10 km/h) and
in red if the vehicle speed is above
6 mph (10 km/h).
Water in diesel fi lter
warning light
This indicates the presence of water
in the diesel fi lter. There is a risk of
damage to the injection system.
Contact a PEUGEOT dealer as soon
as possible. Door/boot open warning
light
With the engine running, this indicates
that an access has not been closed
correctly.
An illustration on the multifunction
display identifi es the access(es) con-
cerned.
It comes on in orange if the vehicle
speed is below 6 mph (10 km/h) and
in red if the vehicle speed is above
6 mph (10 km/h). Air bags warning light
This indicates an air bag fault.
Consult a PEUGEOT dealer.
Automatic headlamp beam
adjustment system warning
light
This indicates that the automatic
headlamp height adjuster is faulty.
Consult a PEUGEOT dealer.
Engine oil pressure warning
light
This indicates that the engine oil
pressure is too low.
It is linked with the STOP warning
light.

Stop immediately if it comes on while
the engine is running.
If there is a lack of oil in the lubrication
circuit, top up the level and contact a
PEUGEOT dealer as soon as possible.

1010PRACTICAL INFORMATION
115
CHANGING A FRONT BULB
Handle the bulbs with a dry cloth.
2 - Main beam headlamps: H7-55 W.

 Remove the protective cover cor-
responding to the faulty bulb.

 Disconnect the connector.

 Press the end of the securing clips
to free the bulb. Change the bulb.

 When fi tting the new bulb, ensure that
the direction notches are positioned
correctly and the securing clips are
fi xed properly.

 Reconnect the connector.

 Refi t the protective cover.

4 -
Direction indicators:
PY 21 W (amber).

 Turn the bulb holder a quarter turn
and remove it.

 Change the bulb.

WARNING: RISK OF
ELECTROCUTION
Front lights
In the engine compartment, remove
the cover secured by one or two but-
terfl y screws, a plastic retainer clip and
two quarter turn screws.

1 - Dipped beam headlamps:
H1-55 W or D2S-35 W xenon bulb.
Xenon bulbs must be replaced by a
PEUGEOT dealer. Amber coloured bulbs (direction
indicators and side repeaters)
must be replaced with bulbs
of identical specifi cation and
colour.
5 - Front fog lamps: H11 - 55 W.
Turn the wheels to full lock.
Access to the bulb is via the fl ap in the
front mud fl ap.
Consult a PEUGEOT dealer.
The headlamps are fi tted with polycar-
bonate glass with a protective coating.
Do not clean them with a dry or abra-
sive cloth, nor with a detergent or sol-
vent product.
Ensure that the liquid used to fi ll the
wash-wipe and headlamp wash reser-
voir is of good quality.

High pressure washing :
when using a high pressure
washer on stubborn dirt, do
not persist on the headlamps,
the lights and their periphery to avoid
damaging their coating and their seal.
In certain climatic conditions (low tem-
perature, humidity), condensation on
the inside surface of the headlamp
glass and rear lights glass is normal;
it disappears a few minutes after the
lights are switched on.

3 - Side lights: W 5 W.

 Remove the protective cover, dis-
connect the connector and then
remove the bulb and change it.

 Put the connector back in place.

 Reconnect the connector.

 Refi t the protective cover.