2009 Peugeot 407 bonnet

FAMILIARISATION
Remote control key

A. Unfolding/folding the key.

B. Unlocking the vehicle
(brief press).

C. Unlocking and partial opening of the
boot (saloon) or of the rear screen
(SW)
(long press).

Also...

D. Normal locking
(a single press)
or
deadlocking of the vehicle
(two presses in succession). Fuel tank

1. Opening of the fuel fi ller fl ap.

2. Opening and hooking of the fuel
tank cap.
Tank capacity: approximately 67 litres.

A. Interior control.

B. Exterior control.

 62

 72  105
Bonnet

FAMILIARISATION INSTRUMENTS AND CONTROLS
1. Audio equipment steering wheel
stalk.

2. Steering lock and ignition.

3. Steering wheel height and depth
adjustment.

4. Cruise control/speed limiter stalk.

5. Lights/Direction indicator stalk.

6. Air conditioned glove box.
Fuse box.

7. Bonnet release.

8. Passenger-operated electric
window control.

9. Speakers (tweeters).

10. Air diffuser vent grille.

11. Instrument panel.

12. Wiper/Wash-wipe/Trip computer
stalk.

13. Headlamp height adjustment.

14. Storage compartment
(driver's side).

4ACCESS
66
ALARM When the alarm is triggered, the siren
sounds and the direction indicator lights
fl ash for approximately thirty seconds.
After triggering, the alarm remains set,
ten times in succession.
On the eleventh time it will become
inactive again, until the next cycle of
disarming then setting of the alarm.

Warning: if button A indicator light
fl ashes rapidly, the alarm has been
triggered while you were away from
your vehicle.

Note: if the alarm has been triggered
in your absence, this fl ashing stops
when the ignition is switched on. Remote control failure,
alarm set

 Unlock the doors with the key and
open the door. The alarm is trig-
gered.

 Switch on the ignition. The alarm is
disarmed.
* According to country.
Setting the alarm

 Switch off the ignition and get out
of the vehicle.

 Set the alarm, by locking or dead-
locking using the remote control
(button A indicator light fl ashes
once per second).
If you wish to lock or deadlock your
vehicle without setting the alarm, lock
it (one turn of the key) or deadlock it
(a second turn within fi ve seconds
maximum) using the lock. Disarming
Unlock the vehicle with the remote
control key.
The alarm is disarmed, indicator light
A
goes out when the ignition is switched on
(unless the alarm has been triggered).
To set the alarm with exterior
protection only
If, while you are away from the vehicle,
you wish to leave a window partially
open or a pet inside the vehicle, you
should choose exterior protection only.

 Switch off the ignition,

 In the next ten seconds, press but-
ton A until the indicator light is on
continuously,

 Get out of the vehicle,

 Set the alarm by locking or dead-
locking using the remote control
(button A indicator light fl ashes
once a second). Incorrect operation
When the ignition is switched on, if
button
A lights for ten seconds, there
is a fault in the siren connection.
Contact a PEUGEOT dealer to have
the system checked.
Automatic activation *
The alarm is activated automatically
two minutes after the last closure of a
door or the boot.
In order to avoid accidental triggering
of the alarm when a door or the boot
is opened, it is essential to press the
unlocking button on the remote control
again.
When the alarm is set, if a door,
the tailgate or the bonnet is
not closed correctly, the siren
is triggered briefl y. If the vehi-
cle is closed correctly within the next
45 seconds, the alarm is set. In all cases,
the alarm is set after 45 seconds.
This provides two types of surveillance:
-
exterior protection: it sounds if
a door, the boot or the bonnet is
opened. - interior protection: it sounds if the
volume inside the passenger compart-
ment changes (breaking of a window
or a movement inside the vehicle).

9CHECKS
105
Bonnet strut OPENING THE BONNET
To close
Lower the bonnet and release it at the
end of its travel. Check that the bonnet
is properly locked.

From inside: pull the handle on the
left-hand side under the fascia towards
you.

From outside: move the catch to the
left and up then raise the bonnet. Secure the strut in its housing to hold
the bonnet open.
Before closing the bonnet, replace the
strut in its clip.

9CHECKS
111
CHECKS
At the start of winter, have
your battery checked by a
PEUGEOT dealer.
Have the fi lter elements
replaced regularly. If you drive
in dusty conditions, change
them twice as often.
Air filter and passenger compartment filter
Particle emission filter (Diesel)
It is imperative that the particle emis-
sion fi lter is maintained in accordance
with the manufacturer’s servicing
schedule, by a PEUGEOT dealer.

Note: following prolonged operation of
the vehicle at very low speed or at idle,
you may, in exceptional circumstances,
notice emissions of water vapour at the
exhaust on acceleration. This does not
have any effect on the performance of
the vehicle or the environment.
On vehicles which are fi tted with a
particle emission fi lter, the fan as-
sembly may operate after the vehicle
has stopped, even when the engine is
cold. Where the handbrake travel is
too great or there is a reduc-
tion in the performance of the
system, the handbrake should
be adjusted.
Have the system checked by a
PEUGEOT dealer.
Handbrake
Disc wear status
For any information relating to checking
disc wear, contact a PEUGEOT dealer.
FUEL SUPPLY CUT-OFF
(PETROL) *
As a safety precaution, in certain circum-stances, a mechanism prevents fuel from reaching the engine. To re-establish the fuel supply:
RUNNING OUT OF FUEL (DIESEL)
If you should run out of fuel, it is neces-
sary to re-prime the circuit.
The repriming pump and the degas
screw are located under the bonnet
(see corresponding illustration in the
technical data section):
1.6 litre 16V HDI engine
- fi ll the fuel tank with at least fi ve
litres of diesel,
- squeeze and release the manual re-priming pump, until fuel appears
in the transparent pipe,
- operate the starter until the engine starts.
2 litre 16V HDI engine
- fi ll the fuel tank with at least fi ve litres of diesel,
- unscrew the degas screw,
- squeeze and release the manual repriming pump until diesel is seen
escaping via the degas screw,
- retighten the degas screw,
- operate the starter until the engine starts.
Brake pad wear depends on
the style of driving, in particu-
lar for vehicles which are used
in town, over short distances.
Brake pads It may be necessary to check
the thickness of the pads,
even between services.
* According to version.
To ensure the best perfor-
mance from components as
important as the power steer-
ing and the braking system, the
manufacturer selects and offers specifi c
products, only use products recom-
mended by PEUGEOT .
Battery
To prevent damage to the electrical units,
high pressure washing of the engine
compartment is strictly prohibited .
 press the red button on the angle of the front right-hand suspension assembly, under the bonnet.

1010PRACTICAL INFORMATION
124

To start the vehicle from another
battery: BATTERY (LOCATED IN THE BOOT) *
* Vehicles fi tted with the 2.7 litre HDI
24 V engine.
The battery is in the left boot trim.

To charge the battery using a bat-
tery charger (boot open):

 fold down the panel to gain access
to the battery,

 disconnect the battery,


follow the instructions for use given
by the battery charger manufacturer,

 reconnect starting with the nega-
tive (-) terminal,

 raise the panel and close it.
 open the bonnet,

 use the two additional positive (+)
and negative (-) terminals located
under the bonnet,

 open the red cover of the positive
(+) terminal,

 connect the red cable between the
positive (+) terminal and the positive
(+) terminal of the slave battery,

 connect the green or black cable
between the negative (-) terminal
and the negative (-) terminal of the
slave battery,


operate the starter, let the engine run,

 wait for the engine to return to idle,
then disconnect the cables,

 close the red cover of the positive
(+) terminal,

 refi t the left side cover,

 close the bonnet. Before disconnecting the bat-
tery, you must wait for 2 minutes
after switching off the ignition.
Never disconnect a terminal
when the engine is running.
Never charge a battery without fi rst
disconnecting the terminals.
Open the windows and close the sun-
roof before disconnecting the battery.
If they do not operate normally follow-
ing reconnection of the battery, they
must be reinitialised (see paragraphs
"Reinitialisation of the electric win-
dows" and "Sunroof").
After every reconnection of the bat-
tery, switch on the ignition and wait
1 minute before starting to allow the
electronic systems to be initialised.
However, if slight diffi culties are ex-
perienced after this, please contact a
PEUGEOT dealer.

On the 2.7 litre 24V HDI engine, if
there is no battery in the boot, do
not connect a slave battery to the
positive (+) and negative (-) termi-
nals under the bonnet as a short
circuit may occur.
The batteries contain harmful
substances such as sulphu-
ric acid and lead. They must
be disposed of in accordance
with regulations and must never be
discarded with household waste.
Take used batteries to an approved
collection point.