i
88
STATIC DIRECTIONAL
LIGHTING
When the dipped or main beam head-lamps are on, this function enables the beam to light the inside of the turn with an additional angle of approximately 30°.
The use of this lighting is optimum above all at low and average speed (city driving, w i n d i n g r o a d s , . . . ) .
with directional lighting
Programming
Switching on
The system is switched on from a certain speed and a certain angle of rotation of the steering wheel.
Operating fault
The function is activated or deactivated via the multi- f u n c t i o n d i s p l a y c o n fi g u r a -tion menu.
By default, this function is activated.
In the event of a malfunction, t h i s w a r n i n g l i g h t fl a s h e s o n t h e instrument panel, accompanied by a message on the multifunc-tion display.
Have it checked by a PEUGEOT dealer.
Switching off
The system is switched off below a certain angle of rotation of the steering wheel.
It is switched off when reverse gear is engaged.
HEADLAMP ADJUSTMENT
To avoid causing a nuisance to other road users, the height of the headlamps should be adjusted in relation to the load in the vehicle.
0. 1 or 2 people in the front seats.
-. 3 people.
1. 5 people.
2. 5 people + maximum authorised load.
3. Driver + maximum authorised load. without directional lighting
SAFETY
109
SEAT BELTS Height adjustment
Seat belt not fastened/unfastened
warning light on the instrument
panel
Fastening
Pull the strap, then insert the tongue
in the buckle.
Check that the seat belt is fastened
correctly by pulling the strap.
To lower the attachment point,
squeeze control A and slide it down-
wards.
To raise the attachment point, slide
control A upwards.
When the ignition is switched on,
this warning light comes on on
the instrument panel if the driver
has not fastened his seat belt.
Above approximately 12 mph (20 km/h)
and for two minutes, this warning light
fl a s h e s a c c o m p a n i e d b y a n a u d i b l e
signal of increasing volume. When the
two minutes have elapsed, this warning
light remains on until the driver fastens
his seat belt.
This warning light comes on on the in-
strument panel if one or more passen-
gers unbuckle their seat belt.
Unfastening
Press the red button on the buckle.
Front seat belts
T h e f r o n t s e a t b e l t s a r e fi t t e d w i t h a p r e -
tensioning and force limiting system.
This system improves safety in the front
seats in the event of front impacts. De-
pending on the severity of the impact,
the pretensioning system instantly tight-
ens the seat belts against the body of
the occupants.
The pretensioning seat belts are active
when the ignition is on.
The force limiter reduces the pressure
of the seat belt on the chest of the oc-
cupant, increasing his protection.
On the 5-door and GTi versions, a slider,
fi t t e d o n t h e s e a t b e l t , m a k e s i t p o s s i b l e
to support the buckle as close as pos-
sible to the strap return.
