2009 OPEL CORSA ESP

162 Driving and operation
Picture no: 18189s.tif
Ultrasonic parking sensors 3
Park pilot makes reverse parking easier by
measuring the distance between the back
of the vehicle and obstacles to the rear. It is
the driver, however, who maintains full
responsibility for parking.
The system records the distance using four
sensors in the rear bumper.
Picture no: 18254s.tif
To activateThe park pilot system activates
automatically when the ignition is switched
on and reverse gear is engaged.
Its operational readin ess is indicated by
illumination of the LED in the button r 3. If the vehicle approaches an obstacle, a
series of acoustic signals sound. The
interval between the signals becomes
shorter as the vehicle gets closer to the
obstacle. When the distance is less
than 30 cm, the signal is continuous.
9
Warning
Under certain circum
stances, various
reflective surfaces on objects or clothing
as well as external noise sources may
cause the system to fail to detect obsta-
cles.
Back to overview

165
Driving and operation
Picture no: 17206t.tif
Hydraulic brake system The foot brake comprises two independent
brake circuits.
If a brake circuit fails, the vehicle can still be
braked using the other brake circuit.
However, the brake pedal must be
depressed a considerable way before any
braking effect occurs, and much more
force is required. The braking distance is
longer. Contact a workshop for assistance
before continuing to drive. To ensure that full
pedal travel can be
utilised, especially in case of a fault in one
of the brake circuits, there must be no mats
in the vicinity of the pedals 3150.
When the engine is not running, the
support of the brake servo unit disappears
once the brake pedal has been depressed
once or twice. Braking effect is not
reduced, but braking requires significantly
greater force. This is especially important
to bear in mind when towing.
The brake fluid level should be checked
regularly. If the brake fluid level is too low
and the hand brake is not applied, control
indicator R on the instrument panel
illuminates 389.
Picture no: 18257s.tif
Brake system control indicator R
The control indicator lights up when the
ignition is switched on when the hand
brake is applied or when the brake or
clutch fluid level is too low. Brake fluid
level 3246.
For vehicles with manual transmission
automated 3, the control indicator flashes
for a few seconds when the ignition is
turned off when the hand brake is not
applied.
9
Warning
If the control indicator illuminates when
the hand brake is released, stop driving
immediately. Contact a workshop for
assistance.
Back to overview

166 Driving and operationAnti-lock brake system (ABS
u)
ABS prevents the wheels from locking.
ABS starts to regulate brake pressure as
soon as a wheel shows a tendency to lock.
The vehicle remains steerable, even during
hard braking.
For optimum braking, keep the brake
pedal fully depressed throughout the
braking process, despite the fact that the
pedal is pulsating. Do not reduce the
pressure on the pedal.
Picture no: 18258s.tif
Control indicator u for ABS
It illuminates for a few seconds when
ignition is switched on. Once the control
indicator goes out, the system is ready for
operation.
If the control indica tor does not go out
after a few seconds, or if it illuminates while
driving, there is a fault in the ABS. The
brake system remains operational without
ABS regulation.
Adaptive brake lamp 3
During full-on braking, all three brake
lamps flash for the duration of ABS control. Self testing
When the engine is started and the vehicle
starts off, the system performs a self-check,
which may be audible.
Fault
Have cause of fault remedied by a
workshop. The system’s integrated self
diagnostics allow faults to be quickly
remedied.
9
Warning
If there is a fault in the ABS, the wheels
may be liable to lock due to braking that
is heavier than normal. The advantages
of ABS are no longer available. During
hard braking, the vehicle can no longer
be steered and may swerve.
Back to overview

171
Driving and operation
Tyre designations
Meanings:
e.g. 185/65 R 15 88 T
Speed code letters: Run-flat tyres (RFT)
3
Run-flat tyres have reinforced, self-
supporting sidewalls, which ensure that the
tyres always have a certain amount of
driveability, even when there is no pressure.
Run-flat tyres are permitted only in the
case of vehicles with ESP®
Plus
3 and a
deflation detection system.
Depending on the tyre manufacturer, run-
flat tyres can be identified from a marking
on the tyre wall, e.g. ROF = RunonFlat for
Dunlop or SSR = Self Supporting Runflat
Tyre for Continental.
Run-flat tyres can be used only in
combination with the alloy wheels issued
by Opel: this also applies to winter tyres. Driving with a damaged tyre
The deflation of a tyre is displayed via the
deflation detection system
3.
If a tyre has no pressure, continued driving
is possible
z at a speed of max. 80 km/h,
z up to a distance of 80 km.
Do not use a tyre repair kit.
Deflation detection system 3 3 164.
185
= Tyre width in mm
65 = Cross-section ratio
(tyre height to tyre width in %)
R = Belt type Radial
RF = Type: Run-flat
15 = Rim diameter in inches
88 = Load-bearing capacity code
e.g.: 88 corresponds to 567 kg
T = Speed code letter:
Q = Up to 160 km/h
S = Up to 180 km/h
T = Up to 190 km/h
H = Up to 210 km/h
V = Up to 240 km/h
W = Up to 270 km/h
9
Warning
Even the tyre pressure of run-flat tyres
must be checked regularly.
Check tyre pressures at least every
14 days and prior to any long journey;
the tyres should be checked when cold.
9
Warning
When driving with a flat tyre, do not
exceed a speed of 80 km/h or a distance
of 80 km.
The vehicle will be more difficult to steer
and handle and the braking distance
will be longer.
Adapt driving style and speed to the
conditions at hand.
Back to overview

172 Driving and operationWinter tyres 3
Notes on fitting new tyres 3 168.
Restrictions 3171, 3264.
Winter tyres improve driving safety at
temperatures below 7 C.
The design of summer tyres means they
have limited qualities for winter driving.
In accordance with country-specific
regulations, affix the speed sticker 3 in the
driver’s field of view.
If you use the spare wheel when it is fitted
with a summer tyre, the vehicle’s
driveability may be affected, especially on
slippery road surfaces. Obtain a
replacement for the faulty tyre as soon as
possible, and have the wheel balanced
and fitted to the vehicle.
Wheel covers 3
Use of wheel trims and tyres that approved
by Opel for the vehicle in question and
thereby fulfil all requirements for the wheel
and tyre combination.
If the wheel trims and tyres used are not
Opel-approved, the ty res must not have a
beaded edge. Wheel trims must not impair brake cooling.
Remove the wheel trims if fitting tyre
chains
3.
Picture no: 17217t.tif
Tyre chains
Restrictions and further information 3264.
Tyre chains are only permitted on the
driven wheels (front axle). They must be
fitted to the tyres symmetrically in order to
achieve a concentric fit.
Always use fine mesh chains that add no
more than 10 mm to the tyre tread and the
inboard sides (including chain lock).
9
Warning
Use of unsuitable tyres or wheel trims
could lead to sudden loss of air and
thereby accidents.
Back to overview

198 Self-help, vehicle careNotes on directional tyres 3
Fit directional tyres such that they roll in the
direction of travel. The rolling direction is
indicated by a symbol (e.g. an arrow) on
the sidewall.
The following applies to tyres fitted
opposing the rolling direction:
z Driving conditions may be altered. Have
the defective tyre replaced as soon as
possible.
z Do not drive faster than 80 km/h.
z Be especially careful when driving in rain
and snow.
Further information on directional tyres
3 168.
Jack
£
3 and vehicle tools
3
The jack and the vehicle tools have been
specially developed for your vehicle and
must only be used on that vehicle. Only use
jack for changing wheels.
With versions of the Corsa OPC with sill
panelling 3 or retrofitted sill panelling 3 no
jack 3 must be used. The vehicle may be
damaged.
Picture no: 18317s.tif
Vehicles with spare wheel 3
The jack and the vehicle tools are in the
right-hand compartm ent in the luggage
compartment.
To open the compartment, disengage the
cover and open it.
Back to overview

208 Self-help, vehicle careElectrical system Fuses
Data on the replacement fuse must match
the data on the defective fuse.
There are three fuse boxes in the vehicle:
zfront left, in the engine compartment,
z in the interior behind the light switch, or,
in right-hand drive cars, behind the
glove compartment,
z on the left of the luggage compartment,
behind a cover.
Before replacing a fuse, turn off the
respective switch and the ignition.
A blown fuse can be recognised by its
melted wire. Do not replace the fuse until
the cause of the fault has been remedied.
Only fit fuses of the specified current
rating. Each fuse has its current rating
written on it, the ratings are also colour
coded.
Picture no: 17259t.tif
Some functions are protected by several
fuses.
There may be fuses inserted with no
function.
Picture no: 17260t.tif
Different versions of fuses are used.
Back to overview

241
Opel Service, maintenance
Genuine Opel Parts and
Accessories We recommend that you use "Genuine
Opel Parts and Accessories" and
conversion parts expressly approved for
your vehicle model. These parts have
undergone special tests to establish their
reliability, safety and specific suitability for
Opel vehicles. Despit e continuous market
monitoring, we cannot assess or guarantee
these attributes for other products, even if
they – have been granted approval – by
the relevant authorities or in some other
form.
"Genuine Opel Parts and Accessories" and
conversion parts approved by Opel can of
course be obtained from your Opel
Partner, who can provide – comprehensive
advice about permissible technical
changes – and ensure that the part is
installed correctly.
Picture no: 17304t.tif
Performing work To avoid injury from moving parts and
cables conducting ignition voltage, only
carry out engine compartment checks
(e. g. checking brake fluid or engine oil
level) when the igniti on is switched off.
Picture no: 18145s.tif
To aid identification, the caps to be
removed for topping up engine oil, coolant
and washer fluid and the dipstick handle
may be coloured yellow.
9
Warning
Only perform engine compartment
checks when the ignition is off.
The cooling fan may start operating
even if the ignition is off.
9
Warning
The ignition system 3 and Xenon head-
lamps 3 use extremely high voltage. Do
not touch.
Back to overview