Page 355 of 388

Oil overheat can be triggered in severe driving conditions, such as
towing heavy loads over mountainous terrain in extreme hot
temperatures. As oil temperature increases, engine and vehicle speed
will be limited. The transmission will also shift differently.
When the engine oil has cooled, the vehicle will perform normally.
When fail-safe cooling mode is activated
You have limited engine power when in the fail-safe mode, so drive the
vehicle with caution. Remember that the engine is capable of completely
shutting down automatically to prevent engine damage, therefore:
1. Pull off the road as soon as safely possible and turn off the engine.
2. Arrange for the vehicle to be taken to an authorized dealer.
3. If this is not possible, wait approximately 15 minutes for the engine to
cool.
4. Check the coolant level and replenish if low. Look for coolant leakage
in the engine compartment and under the vehicle.
WARNING:Never remove the coolant reservoir cap while the
engine is running or hot.
5. Restart the engine and take your vehicle to an authorized dealer.
Driving the vehicle without repairing the engine problem
increases the chance of engine damage. Take your vehicle to an
authorized dealer as soon as possible.
FUEL FILTER
For fuel filter replacement, see your authorized dealer. Refer to
scheduled maintenance informationfor the appropriate intervals for
changing the fuel filter.
Replace the fuel filter with an authorized Motorcraft part. The
customer warranty may be void for any damage to the fuel system
if an authorized Motorcraft fuel filter is not used.
WHAT YOU SHOULD KNOW ABOUT AUTOMOTIVE FUELS
Important safety precautions
WARNING:Do not overfill the fuel tank. The pressure in an
overfilled tank may cause leakage and lead to fuel spray and fire.
2009 Mountaineer(mnt)
Owners Guide, 2nd Printing
USA(fus)
Maintenance and Specifications
355
Page 367 of 388

The OBD-II system is designed to check the emission control system
during normal driving. A complete check may take several days. If the
vehicle is not ready for I/M testing, the following driving cycle consisting
of mixed city and highway driving may be performed:
15 minutes of steady driving on an expressway/highway followed by
20 minutes of stop-and-go driving with at least four 30-second idle
periods.
Allow the vehicle to sit for at least eight hours without starting the
engine. Then, start the engine and complete the above driving cycle. The
engine must warm up to its normal operating temperature. Once started,
do not turn off the engine until the above driving cycle is complete. If
the vehicle is still not ready for I/M testing, the above driving cycle will
have to be repeated.
POWER STEERING FLUID
Check the power steering fluid. Refer toscheduled maintenance
information.
1. Start the engine and let it run
until it reaches normal operating
temperature (the engine coolant
temperature gauge indicator will be
near the center of the normal area
between H and C).
2. While the engine idles, turn the
steering wheel left and right several
times.
3. Turn the engine off.
4. Check the fluid level in the reservoir.
5. The fluid level should be between the MIN and MAX lines. Do not add
fluid if the level is in this range.
6. If the fluid is low, add fluid in small amounts, continuously checking
the level until it reaches the correct operating range. Be sure to put the
cap back on the reservoir. Refer toMaintenance product specifications
and capacitiesin this chapter for the proper fluid type.
2009 Mountaineer(mnt)
Owners Guide, 2nd Printing
USA(fus)
Maintenance and Specifications
367
Page 383 of 388

Cleaning your vehicle
engine compartment ..............330
instrument panel ....................332
interior .....................................333
plastic parts ............................331
washing ....................................328
waxing .....................................329
wheels ......................................329
wiper blades ............................331
Climate control (see Air
conditioning or Heating) ............80
Clock adjust
6-CD in dash .............................32
AM/FM/CD .................................25
Compass, electronic
set zone adjustment ...............129
Console ..............................100–101
overhead ....................................99
rear ..........................................101
Controls
power seat ...............................160
steering column ......................111
Coolant
checking and adding ..............349
refill capacities ................353, 372
specifications ..........................372
Cruise control
(see Speed control) ..................108
Customer Assistance ................292
Ford Extended
Service Plan ............................325
Getting assistance outside the
U.S. and Canada .....................326
Getting roadside assistance ...292
Getting the service
you need .................................321
Ordering additional owner’s
literature .................................326Utilizing the
Mediation/Arbitration
Program ...................................324
D
Daytime running lamps
(see Lamps) ................................86
Defrost
rear window ..............................84
Dipstick
automatic transmission
fluid ..........................................368
engine oil .................................342
Driveline universal joint and
slip yoke ....................................369
Driving under special
conditions ..................282, 286, 289
sand .........................................287
snow and ice ...........................289
through water .................288, 291
Dual automatic temperature
control (DATC) ...........................80
DVD system .................................46
E
Electronic message center .......120
Emergencies, roadside
jump-starting ..........................313
running out of fuel .........313, 360
Emergency Flashers .................293
Emission control system ..........364
Engine ........................................377
cleaning ...................................330
coolant .....................................349
fail-safe cooling .......................354
idle speed control ...................347
lubrication specifications .......372
2009 Mountaineer(mnt)
Owners Guide, 2nd Printing
USA(fus)
Index
383