2009 Lexus GS450h Owner's Manual

416
3-7. Other interior features
GS_HV_U (OM30B44U)
April 27, 2009 10:09 am
■Certification for the Lexus Link System
NOTE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the fol-
lowing two conditions: (1) this device may not cause harmful interference and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC WARNING:
Changes or modifications in construction not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equip-
ment.
Radio Frequency Exposure. This device is approved for Mobile Application only
and, to comply with applicable FCC radio frequency exposure regulations, must be
used with a distance of at least 7.9 in. (20 cm) between the antenna and the body of
any person at all time during use.
FCC ID: SCWTR-423-A2
GS450h_HV_U.book Page 416 Monday, April 27, 2009 10:10 AM

417
3-7. Other interior features
3
Interior features
GS_HV_U (OM30B44U)
April 27, 2009 10:09 am
GS450h_HV_U.book Page 417 Monday, April 27, 2009 10:10 AM

418
3-7. Other interior features
GS_HV_U (OM30B44U)
April 27, 2009 10:09 am
GS450h_HV_U.book Page 418 Monday, April 27, 2009 10:10 AM

Maintenance and care4
419
GS_HV_U (OM30B44U)
April 27, 2009 10:09 am
4-1. Maintenance and careCleaning and protecting the vehicle exterior............. 420
Cleaning and protecting the vehicle interior .............. 423 4-2. Maintenance
Maintenance requirements 426
General maintenance .......... 428
Emission inspection and maintenance (I/M)
programs ................................ 431
4-3. Do-it-yourself maintenance Do-it-yourself service precautions ........................... 432
Hood .......................................... 435
Positioning a floor jack ......... 436
Engine compartment ........... 438
Tires............................................ 452
Tire inflation pressure........... 462
Wheels ....................................... 467
Air conditioning filter ........... 469
Electronic key battery.......... 472
Checking and replacing fuses ...................... 474
Headlight aim ......................... 489
Light bulbs................................ 492
GS450h_HV_U.book Page 419 Monday, April 27, 2009 10:10 AM

420
GS_HV_U (OM30B44U)
April 27, 2009 10:09 am
4-1. Maintenance and care
Cleaning and protecting the vehicle exterior
■Automatic car washes
●Fold the mirrors back before washing the vehicle.
●Brushes used in automatic car washes may scratch the vehicle surface and
harm your vehicle’s paint.
●Before entering an automatic car wash, check that the fuel filler door is closed.
■High pressure washers
Do not allow the nozzles of the washers to come within close proximity of the win-
dows and fuel filler door.
Perform the following to protect the vehicle and maintain it in prime condi-
tion.
●Working from top to bottom, liberally apply water to the vehicle
body, wheel wells and underside of the vehicle to remove any dirt
and dust.
Wash the vehicle body using a sponge or soft cloth, such as a chamois.
●For hard-to-remove marks, use car wash soap and rinse thor-
oughly with water.
● Wipe away any water.
● Wax the vehicle when the waterproof coating deteriorates.
If water does not bead on a clean surface, apply wax when the vehicle
body is cool.
GS450h_HV_U.book Page 420 Monday, April 27, 2009 10:10 AM

421
4-1. Maintenance and care
4
Maintenance and care
GS_HV_U (OM30B44U)
April 27, 2009 10:09 am
■Aluminum wheels
Remove any dirt immediately by using a neutral detergent. Do not use hard brushes
or abrasive cleaners. Do not use strong or harsh chemical cleaners. Use the same
mild detergent and wax as used on the paint.
■Bumpers and side moldings
Do not scrub with abrasive cleaners.
■To prevent paint deterioration and corrosion on the body
●Wash the vehicle immediately in the following cases:
• After driving near the sea coast
• After driving on salted roads
• If you see coal tar or tree sap on the paint surface
• If you see dead insects, insect droppings or bird droppings on the paint
• After driving in an area contaminated with soot, oily smoke, mine dust, ironpowder or chemical substances
• If the vehicle becomes heavily soiled in dust or mud
• If liquids such as benzene and gasoline are spilled on the paint surface
●If the paint is chipped or scratched, have it repaired immediately.
CAUTION
■Caution about the exhaust pipe
Exhaust gasses cause the exhaust pipe to become quite hot.
When washing the vehicle, be careful not to touch the pipe until it has cooled suffi-
ciently, as touching a hot exhaust pipe can cause burns.
GS450h_HV_U.book Page 421 Monday, April 27, 2009 10:10 AM

422
4-1. Maintenance and care
GS_HV_U (OM30B44U)
April 27, 2009 10:09 am
NOTICE
■To protect your vehicle’s painted surfaces
Do not use organic cleaners such as benzene or gasoline.
■Cleaning the exterior lights
●Wash carefully. Do not use organic substances or scrub with a hard brush.
This may damage the surfaces of the lights.
●Do not apply wax on the surfaces of the lights.
Wax may cause damage to the lenses.
■When using an automatic car wash (with rain-sensing windshield wipers)
Set the wiper switch to off.
If the wiper switch is in “AUTO”, the wipers
may operate and the wiper blades may be
damaged.OFF
AUTO
GS450h_HV_U.book Page 422 Monday, April 27, 2009 10:10 AM

423
4-1. Maintenance and care
4
Maintenance and care
GS_HV_U (OM30B44U)
April 27, 2009 10:09 am
Cleaning and protecting the vehicle interior
The following procedures will help protect your vehicle’s interior and keep
it in top condition:
■Protecting the vehicle interior
Remove dirt and dust using a vacuum cleaner. Wipe dirty surfaces
with a cloth dampened with lukewarm water.
■ Cleaning the leather areas
● Remove dirt and dust using a vacuum cleaner.
● Wipe any excess dirt and dust with a soft cloth dampened with
diluted detergent.
Use a diluted water solution of approximately 5% neutral wool deter-
gent.
●Wring out any excess water from the cloth and thoroughly wipe
off all remaining traces of detergent.
● Wipe the surface with a dry, soft cloth to remove any remaining
moisture. Allow the leather to dry in a shaded and ventilated area.
■ Synthetic leather areas
● Remove loose dirt using a vacuum cleaner.
● Apply a mild soap solution to the synthetic leather using a sponge
or soft cloth.
● Allow the solution to soak in for a few minutes. Remove the dirt
and wipe off the solution with a clean, damp cloth.
GS450h_HV_U.book Page 423 Monday, April 27, 2009 10:10 AM