2009 INFINITI QX56 200

AV
U1000 CAN COMM CIRCUITAV-41
< COMPONENT DIAGNOSIS > [AUDIO SYSTEM]
C
D
E
F
G H
I
J
K L
M B A
O P
COMPONENT DIAGNOSIS
U1000 CAN COMM CIRCUIT
DescriptionINFOID:0000000003776791
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle mul-
tiplex communication line with high data communication speed and excellent error detection ability. Many elec-
tronic control units are equipped onto a vehicle and each control unit shares information and links with other
control units during operation (not independent). In CAN communication, control units are connected with 2
communication lines (CAN-H, CAN-L) allowing a high rate of information transmission with less wiring. Each
control unit transmits/receives data but selectively reads required data only.
CAN Communication Signal Chart. Refer to LAN-44, "
CAN Communication Signal Chart".
DTC LogicINFOID:0000000003776792
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000003776793
1.PERFORM SELF DIAGNOSTIC
1. Turn ignition switch ON and wait for 2 seconds or more.
2. Check “Self Diagnostic Result” of “AV Control Unit”.
Is
“CAN COMM CIRCUIT” displayed?
YES >> Refer to “LAN system”. Refer to LAN-14, "Trouble Diagnosis Flow Chart".
NO >> Refer to GI section. Refer to GI-38, "
Intermittent Incident".
DTCDisplay contents of CON-
SULT-III Diagnostic item is detected when ...
Probable malfunction location
U1000 CAN COMM CIRCUIT When AV control unit is not transmitting or re-
ceiving CAN communication signal for 2 sec-
onds or more. CAN communication system.
Revision: December 20092009 QX56

AV-42
< COMPONENT DIAGNOSIS >[AUDIO SYSTEM]
U1010 CONTROL UNIT (CAN)
U1010 CONTROL UNIT (CAN)
DescriptionINFOID:0000000003776794
Initial diagnosis of AV control unit.
DTC LogicINFOID:0000000003776795
DTC DETECTION LOGIC
Diagnosis ProcedureINFOID:0000000003776796
1.REPLACE AV CONTROL UNIT
When DTC U1010 is detected, replace AV control unit. Refer to AV-168, "
Removal and Installation".
>> Inspection end.
DTC Display contents of CON-
SULT-III Diagnostic item is detected when ...
Probable malfunction location
U1010 CONTROL UNIT (CAN) CAN initial diagnosis malfunction is detected. AV control unit.
Revision: December 20092009 QX56

AV
U1200 AV CONTROL UNITAV-43
< COMPONENT DIAGNOSIS > [AUDIO SYSTEM]
C
D
E
F
G H
I
J
K L
M B A
O P
U1200 AV CONTROL UNIT
DescriptionINFOID:0000000003776797
Replace the AV control unit if this DTC is displayed. Refer to AV-168, "Removal and Installation".
DTC LogicINFOID:0000000003776798
Part name Description
AV CONTROL UNIT • It is the master unit of the MULTI AV system and it is connected to each control
unit by means of communication. It operates each system according to com-
munication signals from the AV control unit.
• AV control unit includes audio function and vehicle information function.
• It is connected to ECM and combination meter via CAN communication to ob- tain necessary information for the vehicle information function.
• It inputs the automatic brightness ON/OFF signals that are required for the dis- play dimming control.
• It inputs the signals for driving status recognition (vehicle speed, reverse and parking brake).
DTC Display contents of CONSULT-III DTC Detection Condition Action to take
U1200 Control Unit
FLASH- ROM
[U1200] An internal malfunction is detected in AV control unit
(FLASH-ROM). Replace AV control unit. Re-
fer to AV- 1 6 8 , "
Removal and
Installation".
Revision: December 20092009 QX56

AV-44
< COMPONENT DIAGNOSIS >[AUDIO SYSTEM]
U1201 AV CONTROL UNIT
U1201 AV CONTROL UNIT
DescriptionINFOID:0000000004110619
Replace the AV control unit if this DTC is displayed. Refer to
AV-168, "Removal and Installation".
DTC LogicINFOID:0000000003776800
DTC DETECTION LOGIC
Part name Description
AV CONTROL UNIT • Integrates HDD (hard disk dr
ive) allowing map data and music data to be
stored.
• It is the master unit of the MULTI AV system, and it is connected to each control unit by means of communication. It operates each system according to com-
munication signals from the AV control unit.
• The AV control unit includes the audio, hands-free phone, voice control, navi- gation, and vehicle information functions.
• It is connected to ECM and combination meter via CAN communication to ob-
tain necessary information for the vehicle information function.
• It inputs the automatic brightness ON/OFF signals that are required for the dis- play dimming control.
• It inputs the signals for driving status recognition (vehicle speed, reverse and
parking brake).
DTC CONSULT-III display Detection conditionAction to take
U1201 GYRO NO CONN
[U1201] An internal malfunction is detected in AV control unit (gy-
rocompass disconnection). Replace AV control unit. Refer
to
AV- 1 6 8 , "
Removal and Instal-
lation".
Revision: December 20092009 QX56

AV
U1204 GPS COMMAV-45
< COMPONENT DIAGNOSIS > [AUDIO SYSTEM]
C
D
E
F
G H
I
J
K L
M B A
O P
U1204 GPS COMM
DescriptionINFOID:0000000004110653
Replace the AV control unit if this DTC is displayed. Refer to AV-168, "Removal and Installation".
DTC LogicINFOID:0000000003776802
DTC DETECTION LOGIC
Part name Description
AV CONTROL UNIT • Integrates HDD (hard disk
drive) allowing map data and music data to be
stored.
• It is the master unit of the MULTI AV system, and it is connected to each control unit by means of communication. It operates each system according to com-
munication signals from the AV control unit.
• The AV control unit includes the audio, hands-free phone, voice control, navi- gation, and vehicle information functions.
• It is connected to ECM and combination meter via CAN communication to ob-
tain necessary information for the vehicle information function.
• It inputs the automatic brightness ON/OFF signals that are required for the dis- play dimming control.
• It inputs the signals for driving status recognition (vehicle speed, reverse and
parking brake).
DTC CONSULT-III display Detection conditionAction to take
U1204 GPS COMM
[U1204] An internal malfunction is detected in AV control unit (GPS
malfunction). Replace AV control unit. Refer
to
AV-168, "
Removal and Instal-
lation".
Revision: December 20092009 QX56

AV-46
< COMPONENT DIAGNOSIS >[AUDIO SYSTEM]
U1205 GPS ROM
U1205 GPS ROM
DescriptionINFOID:0000000004110654
Replace the AV control unit if this DTC is displayed. Refer to
AV-168, "Removal and Installation".
DTC LogicINFOID:0000000003776804
DTC DETECTION LOGIC
Part name Description
AV CONTROL UNIT • Integrates HDD (hard disk dr
ive) allowing map data and music data to be
stored.
• It is the master unit of the MULTI AV system, and it is connected to each control unit by means of communication. It operates each system according to com-
munication signals from the AV control unit.
• The AV control unit includes the audio, hands-free phone, voice control, navi- gation, and vehicle information functions.
• It is connected to ECM and combination meter via CAN communication to ob-
tain necessary information for the vehicle information function.
• It inputs the automatic brightness ON/OFF signals that are required for the dis- play dimming control.
• It inputs the signals for driving status recognition (vehicle speed, reverse and
parking brake).
DTC CONSULT-III display Detection conditionAction to take
U1205 GPS ROM
[U1205] An internal malfunction is detected in AV control unit (GPS
malfunction). Replace AV control unit. Refer
to
AV- 1 6 8 , "
Removal and Instal-
lation".
Revision: December 20092009 QX56

AV
U1206 GPS RAMAV-47
< COMPONENT DIAGNOSIS > [AUDIO SYSTEM]
C
D
E
F
G H
I
J
K L
M B A
O P
U1206 GPS RAM
DescriptionINFOID:0000000004110655
Replace the AV control unit if this DTC is displayed. Refer to AV-168, "Removal and Installation".
DTC LogicINFOID:0000000003776806
DTC DETECTION LOGIC
Part name Description
AV CONTROL UNIT • Integrates HDD (hard disk
drive) allowing map data and music data to be
stored.
• It is the master unit of the MULTI AV system, and it is connected to each control unit by means of communication. It operates each system according to com-
munication signals from the AV control unit.
• The AV control unit includes the audio, hands-free phone, voice control, navi- gation, and vehicle information functions.
• It is connected to ECM and combination meter via CAN communication to ob-
tain necessary information for the vehicle information function.
• It inputs the automatic brightness ON/OFF signals that are required for the dis- play dimming control.
• It inputs the signals for driving status recognition (vehicle speed, reverse and
parking brake).
DTC CONSULT-III display Detection conditionAction to take
U1206 GPS RAM
[U1206] An internal malfunction is detected in AV control unit (GPS
malfunction). Replace AV control unit. Refer
to
AV-168, "
Removal and Instal-
lation".
Revision: December 20092009 QX56

AV-48
< COMPONENT DIAGNOSIS >[AUDIO SYSTEM]
U1207 GPS RTC
U1207 GPS RTC
DescriptionINFOID:0000000004110656
Replace the AV control unit if this DTC is displayed. Refer to
AV-168, "Removal and Installation".
DTC LogicINFOID:0000000003776808
DTC DETECTION LOGIC
Part name Description
AV CONTROL UNIT • Integrates HDD (hard disk dr
ive) allowing map data and music data to be
stored.
• It is the master unit of the MULTI AV system, and it is connected to each control unit by means of communication. It operates each system according to com-
munication signals from the AV control unit.
• The AV control unit includes the audio, hands-free phone, voice control, navi- gation, and vehicle information functions.
• It is connected to ECM and combination meter via CAN communication to ob-
tain necessary information for the vehicle information function.
• It inputs the automatic brightness ON/OFF signals that are required for the dis- play dimming control.
• It inputs the signals for driving status recognition (vehicle speed, reverse and
parking brake).
DTC CONSULT-III display Detection conditionAction to take
U1207 GPS RTC
[U1207] An internal malfunction is detected in AV control unit (GPS
malfunction). Replace AV control unit. Refer
to
AV- 1 6 8 , "
Removal and Instal-
lation".
Revision: December 20092009 QX56