2009 Hyundai Accent FRONT

6
DO-IT-YOURSELF MAINTENANCE
23
G270A03O
!
WARNING:
o When removing/replacing halogen
bulbs, always handle the metal body
of the bulb, not the glass.
o The halogen bulb contains gas under
pressure and if impacted could shat-
ter, resulting in flying fragments. Al-
ways wear eye protection when ser-
vicing the bulb. Protect the bulb
against abrasions or scratches and
against liquids when lighted. Turn
the bulb on only when installed in a
headlight. Replace the headlight if
damaged or cracked. Keep the bulb
out of the reach of children and dis-
pose of the used bulb with care.
5. Remove the socket cover.
6. Push the bulb spring to remove the
headlight bulb.
7. Remove the protective cap from the
replacement bulb and install the new
bulb by matching the plastic base with
the headlight hole. Reattach the bulb
spring and install the socket cover.
Reconnect the power cord.
8. Use the protective cap and carton to
dispose of the old bulb.
9.Check for proper headlight aim.
OMC055022
Front Turn Signal light
1. Open the engine hood and disconnect
the negative (-) post of the battery.
2. Disconnect the power cord from the
bulb.
3. Take out the bulb from the bulb holder
by turning it counterclockwise.
4. Install the new bulb.
OMC055023
Front Fog Light (If Installed)
NOTE:
It is recommended that the front fog
light bulb be replaced by an authorized
Hyundai dealer.

6
DO-IT-YOURSELF MAINTENANCE
26
G270G01MC-GATMap Light (If Installed)1. Remove the cover with a flat-head
screwdriver.
2. Replace with a new bulb.
OMC055029
G275H01MC-GATInterior Light1. Remove the cover with a flat-head
screwdriver.
2. Replace with a new bulb.
OMC055030
G270E01A-GATSide Repeater Light (If Installed)
G270E01MC
1. Push the cover toward the front of
vehicle and remove it.
2. Disconnect the power code.
3. Replace with a new bulb.

6
DO-IT-YOURSELF MAINTENANCE
27
BULB WATTAGEG280A03MC-AAT
G280A02MC-U
Bulb Type
HB2 Long Life
2357
10W (FESTOON)
10W (FESTOON)
GE881
WY5WPart Name
Stop/Tail Light
High Mounted Rear Stop Light
Luggage Compartment Light
Rear Turn Signal Light
Back-up Light
License Plate Light Part Name
Headlight (High/Low)
Front Turn Signal Light/
Side Marker Light
Map Light (If Installed)
Interior Light
Front Fog Light (If Installed)
Side Repeater Light (If Installed) No.
1
2
3
4
5
6No.
7
8
9
10
11
12 Wattage
55/60
28/8
10
10
27
5
Wattage
27/8
16
5
27
16
5Bulb Type
1157
W16W
C5W
1156
W16W
C5W
4 Door 3 Door

6
DO-IT-YOURSELF MAINTENANCE
29
G200E01MC-AATInner Panel
G200E01MC
FUSE RATING
25A
25A
10A
25A
10A
10A
15A
25A
10A
10A
20A
10A
10A
30A
25A
10A
10A
15A
10ACIRCUIT PROTECTED
Driver Power Window Switch, Assist Power Window Switch,Rear Power Window
Switch RH
Driver Power Window Switch, Rear Power Window Switch LH
Power Outside Mirror Switch, Digital Clock, Audio
Cigarette Lighter, Power Outlet
Head Lamp LH, DRL Control Module
ECM, Driver Power Outside Mirror Motor,Assist Power Outside Mirror Motor, PCM,
Rear Defogger Switch
Multi-function Swicth, Rear Wiper Motor
Multi-function Switch, Front Wiper Motor
Rear Combination Lamp LH, License Lamp LH(3DOOR),Turn Signal Lamp LH
Front Fog Relay
Driver Seat Warmer Switch, Assist Seat Warmer Switch
Active Interior & Humidity Sensor, A/C Control Module, BCM, Blower Relay, Sunroof
Motor
Rear Combination Lamp RH, License Lamp RH(3DOOR), License Lamp(4DOOR),
Shunt Connector, Turn Signal Lamp RH
BCM, Rear Defogger, Rear Defogger Relay
AMP
Head Lamp RH, Instrument Cluster, DRL Control Module
Hazard Relay, Hazard Switch
SRS Control Module
Telltale Lamp, Passenger Seat Track Position Sensor
P/WDW RH
P/WDW LH
AUDIO
C/LIGHTER
H/LP (LH)
HTD MIRR
RR WIPER
FR WIPER
TAIL LP (LH)
IGN
HTD SEAT
BLOWER
TAIL LP (RH)
HTD GLASS
AMP
H/LP (RH)
HAZARD
A/BAG
SNSRFUSE

6
DO-IT-YOURSELF MAINTENANCE
30
FUSE RATING
10A
20A
10A
10A
15A
10A
10A
20A
10A
10A
15A
15A
10A
10A
10A
10ACIRCUIT PROTECTED
Front Fog Lamp Switch, Front Fog Lamp LH, Front Fog Lamp RH, Front Fog
Lamp Relay
Sunroof Motor
Hazard Switch
Overdrive Switch, Vehicle Speed Sensor
Data Link Connector, Stop Lamp Switch, P/WDW Relay,Multipurpose Check
Connector
Instrument Cluster
ECM, PCM
Driver Door Lock Actuator, Assist Door Lock Actuator, BCM,Rear Door Lock
Actuator LH, Rear Door Lock Actuator RH,Driver Power Window Switch, Tail
Gate Lock Actuator
Star t Relay, Burglar Alarm Relay
BCM, Instrument Cluster, Generator, DRL Control Module, Tire Pressure
Monitoring Module, Pre-excitation Resistor
Ignition Coil #1, #2, #3, #4, Condenser
Audio
Luggage Lamp, Room Lamp, Vanity Lamp Switch, Digital Clock,Overhead
Console Lamp, A/C Control Module, Instrument Cluster, Door Warning Switch,
BCM, Tire Pressure Monitoring Module
ABS Control Module, Multipurpose Check Connector
Back-up Lamp Switch, Transaxle Range Switch, Multipurpose Check Connector
DRL Control Module
FR FOG LP
S/ROOF
T/SIG LP
TCU
STOP LP
A/BAG IND
ECU
C/DR LOCK
START
CLUSTER
IGN COIL
AUDIO(Power Connector)MULT B/UP(Power Connector)
ABS
B/UP LP
DRLFUSE

8
CONSUMER INFORMATION, REPORTING SAFETY DEFECTS & BINDING ARBITRATION OF WARRANTY CLAIMS2
VEHICLE IDENTIFICATION
NUMBER (VIN)I010A01MC-AAT
The vehicle identification number (VIN) is
the number used in registering your car
and in all legal matters pertaining to its
ownership, etc. It can be found in four
different places on your car:
1. Lower side of the front passenger seat
under the carpet.
2. On the left top side of the instrument
panel where it can be seen by looking
down through the windshield.
3. Door edge post
4. On the lower side of the center pillar
outer panel.
1JBA5003
OMC079010
1JBA5005OMC079011
12
34

8
CONSUMER INFORMATION, REPORTING SAFETY DEFECTS & BINDING ARBITRATION OF WARRANTY CLAIMS8
I030D01JM-AATTIRE TERMINOLOGY AND DEFINI-
TIONS
Air Pressure: The amount of air inside
the tire pressing outward on the tire.
Air pressure is expressed in pounds
per square inch (psi) or kilopascal (kPa).
Accessory Weight: This means the
combined weight of optional accesso-
ries. Some examples of optional ac-
cessories are, automatic transmission,
power seats, and air conditioning.
Aspect Ratio: The relationship of a
tire's height to its width.
Belt: A rubber coated layer of cords
that is located between the plies and
the tread. Cords may be made from
steel or other reinforcing materials.
Bead: The tire bead contains steel
wires wrapped by steel cords that hold
the tire onto the rim.
Bias Ply Tire: A pneumatic tire in
which the plies are laid at alternate
angles less than 90 degrees to the
centerline of the tread.Cold Tire Pressure: The amount of
air pressure in a tire, measured in
pounds per square inch (psi) or
kilopascals (kPa) before a tire has
built up heat from driving.
Curb Weight: This means the weight
of a motor vehicle with standard and
optional equipment including the maxi-
mum capacity of fuel, oil and coolant,
but without passengers and cargo.
DOT Markings: A code molded into
the sidewall of a tire signifying that the
tire is in compliance with the U.S.
Department of Transportation motor
vehicle safety standards. The DOT
code includes the Tire Identification
Number (TIN), an alphanumeric desig-
nator which can also identify the tire
manufacturer, production plant, brand
and date of production.
GVWR: Gross Vehicle Weight Rating
GAWR FRT: Gross Axle Weight Rat-
ing for the front Axle.
GAWR RR: Gross Axle Weight Rating
for the rear axle. 6. Maximum load rating
This number indicates the maxi-
mum load in kilograms and pounds
that can be carried by the tire. When
replacing the tires on the vehicle,
always use a tire that has the same
load rating as the factory installed
tire.
7. Uniform Tire Quality Grading
(UTQG):
Tire manufacturers are required to
grade tires based on three perfor-
mance factors: treadwear, traction
and temperature resistance. For
more information, see Uniform Tire
Quality Grading on page 8-15.

8
CONSUMER INFORMATION, REPORTING SAFETY DEFECTS & BINDING ARBITRATION OF WARRANTY CLAIMS
11
!
!
I050A01MC-AATTIRE CHAINS
Tire chains, if necessary, should be
installed on the front wheels. Be sure
that the chains are installed in accor-
dance with the manufacturer's instruc-
tions.
To minimize tire and chain wear, do
not continue to use tire chains when
they are no longer needed.
WARNING:
o If your vehicle is equipped with
P205/45R16 size tires, do not in-
stall tire chains. This may cause
damage to the vehicle (wheels,
suspension and body) by chains
contacting the body.
o When driving on roads covered
with snow or ice, drive at less
than 20 mph (30 km/h).
o Use the SAE "S" class or wire &
plastic chains.o If you have noise caused by
chains contacting the body, re-
tighten the chain to avoid contact
with the vehicle body.
o To prevent body damage, re-
tighten the chains after driving
0.3~0.6 miles.
o Don't use tire chains on a vehicle
equipped with aluminium wheels.
If it is unavoidable, use wire type
chains.
o Use wire chains less than 15 mm
to prevent damage to the chain's
connection.WARNING:
I060A02A-AATTIRE ROTATION
Tires should be rotated every 7,500
miles (12,000 km). If you notice that
tires are wearing unevenly between
rotations, have the car checked by a
Hyundai dealer so the cause may be
corrected.
After rotating, adjust the tire pressures
and be sure to check the wheel nut
torque.
HEF-241