2009 HUMMER H3 spare wheel

4. Use the wheel wrench to tighten
the nuts rmly. Try to move the
tire back and forth slightly to
be sure it is secure.
5. Reinstall the center tire cover
onto the spare or at tire.
6. If the vehicle has a spare tire
cover close the cover and
latch the side latch.To store the jack tool bag and jack:
1. Return the tools to the jack
tool bag.
2. Secure the tool bag to the jack
by securely wrapping the straps
around the jack. Then, slide
the straps through the rings on
the bag and secure.
3. Position the jack and jack tool
bag in the swing-gate.
When reinstalling the jack and
jack tool bag, make sure the jack
base is securely seated behind
the tabs in the swing-gate.4. Reinstall the wing nut retainer to
fasten the jack and tool bag in
the storage compartment.
Make sure that the wing nut
passes through the tool bag and
the jack before tightening it.
5. Turn the wing nut retainer
clockwise to secure.
6. Reinstall the compartment cover
by inserting the locator tabs in
the holes in the swing-gate.
Push the latches down to secure.
Service and Appearance Care 5-79

Storing a Flat or Spare
Tire and Tools (H3T)
{CAUTION
Storing a jack, a tire, or other
equipment in the passenger
compartment of the vehicle could
cause injury. In a sudden stop or
collision, loose equipment could
strike someone. Store all these in
the proper place.
A. Spare Tire/Flat Tire
(Valve Stem Pointed Down)
B. Tire/Wheel Retainer
C. Hoist Cable
D. Hoist Assembly
E. Hoist Shaft
F. Jack Handle Extension(s)
G. Wheel Wrench
H. Hoist Shaft Access Ramp
I. Hoist End of the Extension ToolTo store the at or spare tire on the
spare tire mount:
1. Place the at or spare tire (A) on
the ground at the rear of the
vehicle with the valve stem
pointed down and to the rear.
2. Tilt the tire. Separate the
tire/wheel retainer (B) from the
guide pin. Pull the pin through
5-80 Service and Appearance Care

To store the jack tool bag and jack:
1. Return the tools to the jack
tool bag.
2. Secure the tool bag to the jack
by securely wrapping the straps
around the jack. Then, slide
the straps through the rings on
the bag and secure.
3. Reinstall the wing nut retainer to
fasten the jack and tool bag
under the rear seat.
Make sure that the wing nut
passes through the tool bag and
the jack before tightening it.
4. Turn the wing nut retainer
clockwise to secure.Spare Tire
The vehicle, when new, had a
fully-inated spare tire. A spare tire
may lose air over time, so check
its ination pressure regularly.
SeeInflation - Tire Pressure on
page 5-51andLoading the Vehicle
on page 4-35for information
regarding proper tire ination and
loading your vehicle. For instruction
on how to remove, install or store
a spare tire, seeRemoving the Flat
Tire and Installing the Spare Tire
on page 5-72andStoring a Flat or
Spare Tire and Tools (H3) on
page 5-78orStoring a Flat or Spare
Tire and Tools (H3T) on page 5-80.
After installing the spare tire on
your vehicle, you should stop
as soon as possible and make sure
the spare is correctly inated.The spare tire does not have a Tire
Pressure Monitor System sensor.
You may get a low pressure warning
light. SeeTire Pressure Monitor
Operation on page 5-54. Have the
damaged or at road tire repaired or
replaced as soon as you can.
Do not mix tires and wheels of
different sizes, because they will not
t. Keep your spare tire and its
wheel together.
5-82 Service and Appearance Care

Starting the Engine..............2-17
Steering..............................4-10
Steering Wheel, Tilt Wheel...... 3-6
Storage Areas
Cargo Management
System........................2-49
Center Console
Storage Area................2-47
Convenience Net..............2-49
Cupholders......................2-47
Front Seat Storage Net.....2-47
Glove Box.......................2-47
Luggage Carrier...............2-48
Rear Storage Area............2-49
Stuck in Sand, Mud, Ice,
or Snow..........................4-33
Sun Visors..........................2-11
Sunroof..............................2-50
Swing-gate........................... 2-9
T
Tachometer.........................3-24
Tailgate................................ 2-7
Taillamps
Turn Signal, Stoplamps and
Back-up Lamps.............5-42Taillamps (cont.)
Theft-Deterrent, Radio...........3-62
Theft-Deterrent Systems........2-11
Content Theft-Deterrent.....2-11
PASS-Key
®III+ Electronic
Immobilizer...................2-13
PASS-Key
®III+ Electronic
Immobilizer Operation....2-14
Passlock
®........................2-12
Tilt Wheel............................. 3-6
Time, Setting.......................3-41
Tire
Pressure Light..................3-30
Tires..................................5-44
Aluminum or
Chrome-Plated Wheels,
Cleaning......................5-88
Buying New Tires.............5-59
Chains............................5-65
Changing a Flat Tire.........5-66
Cleaning..........................5-89
Different Size...................5-61
If a Tire Goes Flat............5-66
Ination - Tire Pressure.....5-51
Inspection and Rotation.....5-57
Installing the Spare Tire.....5-72Tires (cont.)
Pressure Monitor
Operation.....................5-54
Pressure Monitor System . . . 5-52
Removing the Flat Tire......5-72
Removing the Spare Tire
and Tools.............5-68, 5-69
Secondary Latch System . . . 5-76
Spare Tire.......................5-82
Storing a Flat or Spare Tire
and Tools.............5-78, 5-80
Tire Sidewall Labeling.......5-45
Tire Terminology and
Denitions....................5-48
Uniform Tire Quality
Grading.......................5-62
Wheel Alignment and Tire
Balance.......................5-63
Wheel Replacement..........5-64
When It Is Time for New
Tires............................5-58
Towing
Recreational Vehicle..........4-40
Towing a Trailer................4-42
Your Vehicle.....................4-40
i-10 INDEX