2009 HONDA CR-V dashboard

[x] Cancel search: dashboard

Page 41 of 373

HONDA CR-V 2009 RD1-RD5, RE7 / 3.G Owners Manual 
µ
Many parents say they pref er to put
an inf ant or a small child in the f ront
passenger seat so they can watch the
child, or because the child requires
attention.If they do, they
could be very s

Page 59 of 373

HONDA CR-V 2009 RD1-RD5, RE7 / 3.G Owners Manual CONT INUED
These labels are in the locations 
shown. They warn you of potential
hazards that could cause serious
injury or death. Read these labels
caref ully. 
If a label comes of f or becomes hard

Page 131 of 373

HONDA CR-V 2009 RD1-RD5, RE7 / 3.G Owners Manual Turn this dial to increase or decrease 
the fan speed and airflow. 
Turning this dial clockwise increases 
the temperature of the airflow.When the recirculation indicator is
on, air f rom the vehicle

Page 134 of 373

HONDA CR-V 2009 RD1-RD5, RE7 / 3.G Owners Manual To remove f og f rom the inside of the 
windows:Turning the f an speed control dial all
the way to the left shuts the system
of f .
Keep the system of f f or short
periods only. 
To keep stale air and

Page 138 of 373

HONDA CR-V 2009 RD1-RD5, RE7 / 3.G Owners Manual When the indicator in the button is 
on, air f rom the vehicle’s interior is
sent through the system again.
When the indicator is off, air is
brought in f rom the outside of the
vehicle (fresh air m

Page 142 of 373

HONDA CR-V 2009 RD1-RD5, RE7 / 3.G Owners Manual Theclimatecontrolsystemhastwo 
sensors: a sunlight sensor on top of
the dashboard, and a temperature
and humidity sensor next to the
steering column. Do not cover the
sensors or spill any liquid on th

Page 231 of 373

HONDA CR-V 2009 RD1-RD5, RE7 / 3.G Owners Manual Open the f uel f ill door by pulling 
on the handle located under the
lower lef t corner of the dashboard. 
Park with the driver’s side closest 
to the service station pump.Remove the f uel f ill ca

Page 233 of 373

HONDA CR-V 2009 RD1-RD5, RE7 / 3.G Owners Manual To close the hood, lif t it up slightly to 
remove the support rod f rom the
hole. Put the support rod back into
its holding clip. Lower the hood to
about a f oot (30 cm) above the
f ender, then let i
Page:   < prev 1-8 9-16 17-24 next >